Engineering Papers⌕ Search

Engineering topics

Couet, Adrien

Publications and source records attributed to Couet, Adrien.

47 records · Page 3

Investigation of impurity driven corrosion behavior in molten 2LiF-BeF 2 salt

A 1000 -h corrosion experiment of 316H stainless steel at 700 °C investigated the role of metal fluoride impurities CrF 2 and FeF 2 in LiF-BeF 2 (66-34 mole %) (FLiBe) salt. Inductively coupled plasma-optical emission spectroscopy (ICP-OES) demonstrated the ability to measure changes in the concentration of these fluorides in FLiBe salt. Cyclic voltammetry (CV) showed the potential for real-time quantitative concentration measurement of corrosion products in the molten salt. Materials characterization revealed that both impurity species influence the dissolution of Cr from the alloy. The collective results from these analysis methods advance the understanding of the influence impurities have on materials corrosion.

2LiF-BeF2↗

Corrosion and Thermal Stability of CrMnFeNi High Entropy Alloy in Molten FLiBe Salt

The corrosion behavior of the FCC Cr 18 Mn 27 Fe 27.5 Ni 27.5 high entropy alloy (HEA) after exposure to molten FLiBe salt at 700 °C for 1000 hours, has been investigated. Results show that the HEA lost a higher mass compared to the reference 316 H stainless steel due to the dissolution of Mn into the molten salt. The loss of Mn from the alloy appeared to discourage the dissolution of Cr in the molten fluoride salts which is widely recognized as the mechanism of corrosion degradation. Thermal exposure at 700 °C for 1000 hours also led to the precipitation of an additional BCC phase Cr 67 Fe 13 Mn 18.5 Ni 1.5 , which was confirmed by CALPHAD predictions.

36 MATERIALS SCIENCE↗

Microstructure and microchemistry study of irradiation-induced precipitates in proton irradiated ZrNb alloys

Proton irradiation induced Nb redistribution in Zr-xNb alloys (x = 0.4, 0.5, 1.0 wt%) has been investigated using scanning transmission electron microscopy/energy dispersive X-ray spectroscopy (STEM/EDS). Zr-xNb alloys are mainly composed of Zr matrix, native Zr–Nb–Fe phases, and β-Nb precipitates. After 2 MeV proton irradiation at 350 °C, a decrease of Nb content in native precipitates, as well as irradiation-induced precipitation of Nb-rich platelets (135 69 nm long and 27 12 nm wide) were found. Nb-rich platelets and Zr matrix form the Burgers orientation relationship, [$1\bar{1}1$]//[$2\bar{1}\bar{1}0$] and (011)//(0002). The platelets were found to be mostly coherent with the matrix with a few dislocations near the ends of the precipitate. The coherent strain field has been measured in the matrix and platelets by the 4D-STEM technique. Here, the growth of Nb-rich platelets is mainly driven by coherency and dislocation-induced strain fields. Irradiation may both enhance the diffusion and induce segregation of interstitial Nb to the ends of the irradiation induced platelets, further facilitating their growth.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗

Comprehensive investigation of the role of Nb on the oxidation kinetics of Zr-Nb alloys

Zirconium oxidation, and the associated hydrogen pickup, has long been considered the life-limiting degradation mechanism of fuel elements in pressurized-water reactor (PWR) systems. Currently, PWRs use Zr-Nb alloys as the cladding material of choice. However, oxidation kinetics for Zr-Nb alloys can vary greatly depending on the Nb content; moreover, even Zr-Nb with the same composition can exhibit radically different oxidation kinetics if heat treated at different temperatures. To improve the fundamental understanding of the corrosion of Zr-Nb, it is necessary to determine mechanistically how Nb affects the oxidation kinetics of the overall system. To achieve this, nano-beam X-ray absorption near-edge spectroscopy (XANES), energy-dispersive spectroscopy (EDS), transmission electron microscopy (TEM), and modelling using the physically based C4 model have been performed in concert on samples of Zr-1.0Nb annealed at two different temperatures, 580 °C and 720 °C, and oxidized in an autoclave environment. Through TEM/EDS, it has been seen that β-Zr precipitates dissolved upon oxidation, releasing Nb to the surrounding environment, while β-Nb precipitates remain intact and retard oxidation of Nb. Comparison of the XANES results and C4 model predictions illustrate that space charge generated in the oxide can lead to subparabolic oxidation kinetics in Zr-Nb alloys, which have been shown to negatively affect the hydrogen-pickup fraction. However, sufficient Nb in solid solution can become oxidized to compensate this mechanism to maintain parabolic kinetics in select alloys.

36 MATERIALS SCIENCE↗

Evaluation of post-weld heat treatments applied to FeCrAl alloy weldments

The nuclear incident at the Fukushima Daiichi nuclear power plant has created a strong push for accident-tolerant fuel cladding to replace current zirconium-based cladding. A current near-term focus on iron-chromium-aluminum (FeCrAl) alloys. Laser-welded FeCrAl samples (C35MN, C37M, and C35M10 TC) were subjected to three different post-weld heat treatment regimes: 650 °C for 5 h, 850 °C for 1 h, and 850 °C for 5 h. Here, the samples were then analyzed using optical light microscopy, micro-hardness indentation, and scanning electron microscopy coupled with energy-dispersive spectroscopy and electron backscatter diffraction. The base microstructure of C37M and C35M10 TC experienced significant grain coarsening outside the fusion zone due to the applied post-weld heat treatments, whereas Nb-rich precipitation in C35MN limited grain growth compared with the other alloys studied.

36 MATERIALS SCIENCE↗

Hydrogen pickup mechanism in zirconium alloys - 2016-0055

Because hydrogen ingress into zirconium cladding can cause embrittlement and limit cladding lifetime, hydrogen pickup during corrosion is a critical life-limiting degradation mechanism for nuclear fuel. However, mechanistic knowledge of the oxidation and hydrogen pickup mechanisms is still lacking. In an effort to develop such knowledge, we conducted a comprehensive study that included detailed experiments combined with oxidation modeling. We review this set of results conducted on zirconium alloys herein and articulate them into a unified corrosion theoretical framework. First, the hydrogen pickup fraction (f{sub H}) was accurately measured for a specific set of alloys specially designed to determine the effects of alloying elements, microstructure, and corrosion kinetics on f{sub H}. We observed that f{sub H} was not constant and increased until the kinetic transition and decreased at the transition. F{sub H} depended on the alloy and was lower for niobium-containing alloys. These results led us to hypothesize that hydrogen pickup during corrosion results from the need to balance the charge during the corrosion reaction such that f{sub H} decreases when the rate of electron transport through the protective oxide increases. To assess this hypothesis, two experiments were performed: (1) micro-X-ray absorption near-edge spectroscopy (μ-XANES) to investigate the evolution of the oxidation state of alloying elements when incorporated in the growing oxide and (2) in situ electrochemical impedance spectroscopy (EIS) to measure oxide resistivity as a function of exposure time on different alloys. With the use of these results, we developed an analytical zirconium alloy corrosion model based on the coupling of oxygen vacancies and electron currents. Both modeling and EIS results show that as the oxide electric conductivity decreases the f{sub H} increases. These new results support the general hypothesis of charge balance. The model quantitatively and qualitatively predicts the differences observed in oxidation kinetics and hydrogen pickup fraction between different alloys. (authors)

36 MATERIALS SCIENCE↗

Zirconium Alloy Corrosion and Hydrogen Pickup

During operation nuclear fuel rods are immersed in the primary water, causing waterside corrosion and consequent hydrogen ingress. The mechanisms of corrosion and hydrogen pickup and the role of alloy selection in minimizing both phenomena are considered, based on two principal characteristics: the pre-transition kinetics and the loss of oxide protectiveness at transition. In zirconium alloys very small changes in composition or microstructure can cause significant corrosion differences, so that corrosion performance is strongly alloy dependent. The alloys show different, but reproducible sub-parabolic pre-transition kinetics and transition thicknesses. A mechanism for oxide growth and breakup based on a detailed study of the oxide structure can explain these results. Using the recently developed Coupled Current Charge Compensation model of corrosion kinetics and hydrogen pickup, the sub-parabolic kinetics and the hydrogen fraction can be rationalized: hydrogen pickup increases when electron transport decreases, requiring hydrogen ingress to close the reaction. (authors)

36 MATERIALS SCIENCE↗