Engineering topics

Collin, R. E.

Publications and source records attributed to Collin, R. E..

7 records

NASA NTRS1993

Full wave characterization of microstrip open end discontinuities patterned on anisotropic substrates using potential theory

A technique for a full wave characterization of microstrip open end discontinuities fabricated on uniaxial anisotropic substrates using potential theory is presented. The substrate to be analyzed is enclosed in a cutoff waveguide, with the anisotropic axis aligned perpendicular to the air-dielectric interface. A full description of the sources on the microstrip line is included with edge conditions built in. Extention to other discontinuities is discussed.

Toncich, S. S.↗

NASA NTRS1989

Aperture impedance of flared horns

The method of moments is often used when solving for the mutual coupling in arrays of aperture antennas. For elements that are waveguides or gradually flared horns the aperture fields can be approximated by a finite sum of waveguide modal functions. To solve for the flared horn case an approximation for the aperture impedances of the modes in the horn is needed. The WKB approach can be used to find these impedances, but this technique has an important limitation. It is known to fail in the vicinity of its turning points. The turning point is the cutoff point of the mode being considered. To overcome this limitation a different technique, the spherical mode approach, is discussed. This approach has no cutoff problems and works well for conical and pyramidal horns. Comparisons between the impedances and the resulting dominant mode reflection coefficient found using the two techniques are presented to illustrate this point.

Silvestro, J. W.↗

NASA NTRS1986

Mutual coupling effects in antenna arrays, volume 1

Mutual coupling between rectangular apertures in a finite antenna array, in an infinite ground plane, is analyzed using the vector potential approach. The method of moments is used to solve the equations that result from setting the tangential magnetic fields across each aperture equal. The approximation uses a set of vector potential model functions to solve for equivalent magnetic currents. A computer program was written to carry out this analysis and the resulting currents were used to determine the co- and cross-polarized far zone radiation patterns. Numerical results for various arrays using several modes in the approximation are presented. Results for one and two aperture arrays are compared against published data to check on the agreement of this model with previous work. Computer derived results are also compared against experimental results to test the accuracy of the model. These tests of the accuracy of the program showed that it yields valid data.

Collin, R. E.↗

NASA NTRS1984

Circular waveguide bifurcation for asymmetric modes

An analytical solution for a circular waveguide bifurcation with incident TE(11)- and TM(11)-modes is presented using the residue calculus method. It is shown how the coupling between the TE(1n)- and TM(1n)-modes can be taken into account by expressing the coupling factor as a contour integral, which is the key step enabling the residue calculus method to be applied. Graphical results for the scattering matrix parameters of the junction are given for a range of waveguide radii of interest in the design of dual-mode coaxial prime focus feeds for paraboloidal antennas.

Schilling, H. W.↗

NASA NTRS1984

Dual-mode coaxial feed with low crosspolarisation

Design data for optimized TE(11)-TM(11) dual-mode coaxial prime focus feeds is presented. The optimized feeds have a crosspolarization below -30 dB, an input reflection coefficient below 0.1 and very little phase error in their radiation patterns, over a 5 percent bandwidth. Experimental patterns are also given that show that the theoretically derived design data can be relied upon. The optimized feeds are useful for paraboloidal reflectors with focal-length/diameter ratios in the range 0.3 to 0.5, and will give overall efficiencies as high as 70 percent or more with sidelobes below -30 dB.

Collin, R. E.↗

NASA NTRS1982

Coaxial prime focus feeds for paraboloidal reflectors

A TE11 - TM11 dual mode coaxial feed for use in prime focus paraboloidal antenna systems is investigated. The scattering matrix parameters of the internal bifurcation junction was determined by the residue calculus technique. The scattering parameters and radiation fields of the aperture were found from the Weinstein solution. The optimum modeing ratio for minimum cross-polarization was determined along with the corresponding optimum feed dimensions. A peak cross-polarization level of -58 dB is predicted. The frequency characteristics were also investigated and a bandwidth of 5% is predicted over which the cross-polarization remains below -30 dB, the input VSWR is below 1.15, and the phase error is less than 10 deg. Theoretical radiation patterns and efficiency curves for a paraboloidal reflector illuminated by this feed were computed. The predicted sidelobe level is below -30 dB and aperture efficiencies greater than 70% are possible. Experimental results are also presented that substantiates the theoretical results. In addition, experimental results for a 'short-cup' coaxial feed are given. The report includes extensive design data for the dual-mode feed along with performance curves showing cross-polarization as a function of feed parameters. The feed is useful for low-cost ground based receiving antennas for use in direct television satellite broadcasting service.

Collin, R. E.↗

NASA NTRS1979

Low sidelobe level low-cost earth station antennas for the 12 GHz broadcasting satellite service

An experimental investigation of the performance of 1.22 m and 1.83 m diameter paraboloid antennas with an f/D ratio of 0.38 and using a feed developed by Kumar is reported. It is found that sidelobes below 30 dB can be obtained only if the paraboloids are relatively free of surface errors. A theoretical analysis of clam shell distortion shows that this is a limiting factor in achieving low sidelobe levels with many commercially available low cost paraboloids. The use of absorbing pads and small reflecting plates for sidelobe reduction is also considered.

Collin, R. E.↗