Engineering Papers⌕ Search

Engineering topics

Coe, Joshua Damon

Publications and source records attributed to Coe, Joshua Damon.

4 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2024

Translation of "Contribution a l'etude du diagramme pression-temperature du beryllium pur" (Contribution to the Study of the Pressure-Temperature Diagram of Pure Beryllium)

An unusual feature of beryllium’s phase diagram is the transition from a hexagonal close packed (hcp, or α) to a body-centered cubic (bcc, or β) structure ~20 K below the normal melting temperature of T melt ≈ 1560 K. An early thermal analysis of 99.7% pure Be found two arrests1 : one at 1533-1536 K and another at 1551-1557 K. Without ruling out an allotropic transformation in Be itself, Sloman attributed the first of these to solidification of a Be-BeO eutectic. Losano observed only the higher of the two in 99.962% Be, seeming to confirm the notion that the lower feature was an artifact of impurity. Teitel (99.4%) also measured two arrests and attributed the lower to impurity, but questioned whether oxygen was the culprit.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

New Sesame Equations of State for Polypropylene, Polyvinylchloride (PVC), and Nylon 66

I built new Sesame equations of state (EOS) for polypropylene (PP), polyvinylchloride (PVC), and nylon 66. PP has the same stoichiometry as polyethylene and TPX but with a density intermediate between the two. Nylon is a polyamide manufactured chiefly in the form of fibers. PP and PVC are the second- and third-most widely produced polymers in the world. All three are thermoplastics. Their monomer units are depicted in Figure 1. I discuss the theory on which the EOS are based in the following section, then compare results to thermal and shock compression data in Section III.

36 MATERIALS SCIENCE↗
DOE OSTI2023

Polyimide dynamically compressed to decomposition pressures: Two-wave structures captured by velocimetry and modeling

We performed a series of six plate impact experiments on polyimide and modeled them using new reactant and products equations of state combined with an Arrhenius rate model. The first experiment was diagnosed with embedded electromagnetic velocity gauges through which we directly observed attenuation of the lead shock to an approximately constant state over a propagation distance of roughly 4 mm. Simulated gauge profiles were in excellent qualitative agreement with experiment and suggested a sluggish chemical reaction that did not proceed to completion. The remaining five experiments were conducted in a transmission geometry and diagnosed velocimetrically at the sample/window interface. All five of these yielded profiles with a sharp shock followed by a more gradual approach to maximum interface velocity that was “rounded” to varying degree. These profiles proved difficult to interpret unambiguously due to the convolution of the reactive wave upon first shock with reflection of the lead wave and reshock or release by the window. Comparison with thermochemical calculations strongly suggests that the point of maximum interface velocity corresponds to the equilibrium reshock or release locus. We discuss the implications of this point for the practice of impedance matching based on the reflected Hugoniot of reactive materials such as polymers. The reactant and thermochemical products equations of state are developmental SESAME tables 97710 and 97720, respectively.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗