Engineering Papers⌕ Search

Engineering topics

Clayton, R. M.

Publications and source records attributed to Clayton, R. M..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Physical and chemical characteristics of cenospheres from the combustion of heavy fuel oil

Photomicrography of particle cross sections, measurements of density, porosity, and surface area, and determinations of chemical compositions, have been used in conjunction with SEM of surface structure to characterize cenospheres generated by combustion of residual oil in a steam power plant. Large and small cenospheres, which respectively fall into the 100-200 and small 20-40 micron range, are spheroidal and hollow, with at least one blowhole; outer/inner diameter ratios for the shells are of the order of 1.3-1.4. Typically, a cenosphere contains only about 18 vol pct solid material. The presence of S, Fe, Na, and V in substantial concentrations presage high temperature heat exchanger surface corrosion problems due to cenosphere deposition.

Clayton, R. M.↗
NASA NTRS1988

Rain simulation studies for high-intensity acoustic nose cavities

Unarmed plastic projectiles can be equipped with small axisymmetric cavities for the generation of intense tones that are useful in training maneuvers. Attention is presently given to the simulation of rainfall in an airstream and the effect of rain droplet impingement on the nose of projectiles, and especially to any penetration or accumulation of water at the base of the cavity that might increase the fundamental cavity frequency and/or reduce the intensity of sound production during rain conditions.

Clayton, R. M.↗
NASA NTRS1986

Thrust improvement with ablative insert nozzle extension

Aspects are examined of an investigation by the Marshall Space Flight Center into the conceptual feasibility of increasing the thrust performance of the Space Shuttle Main Engine (SSME) by using a conical nozzle extension fitted with an ablative insert in order to achieve a low-cost, near-term gain in payload. The ablating insert would provide a controlled increase in nozzle expansion ratio during launch and early climbout (first 30-60 seconds) so as to reduce thrust loss from nozzle over-expansion in the lower atmosphere. Summaries are given of JPL studies in the area of: defining the near-wall flow environment in the extended nozzle insert region; selecting potential insert materials; conceptualizing an extension/insert geometrical configuration; and identifying future experimental efforts necessary to verify the feasibility of the concepts.

Clayton, R. M.↗
NASA NTRS1982

Two-Stage Combustor Reduces Pollutant Emissions

By controlling fuel-to-air ratio of local reactants, pollutant emissions would be minimized in a proposed two-stage combustor for gas-turbine engines. It would use fuel-rich partial-oxidation stage and air-rich combustion stage to reduce emissions of nitrogen oxide, carbon monoxide and hydrocarbons. Combustor fuel-lean burning limit would be extended simultaneously.

Clayton, R. M.↗
NASA NTRS1981

Two-stage combustion for reducing pollutant emissions from gas turbine combustors

Combustion and emission results are presented for a premix combustor fueled with admixtures of JP5 with neat H2 and of JP5 with simulated partial-oxidation product gas. The combustor was operated with inlet-air state conditions typical of cruise power for high performance aviation engines. Ultralow NOx, CO and HC emissions and extended lean burning limits were achieved simultaneously. Laboratory scale studies of the non-catalyzed rich-burning characteristics of several paraffin-series hydrocarbon fuels and of JP5 showed sooting limits at equivalence ratios of about 2.0 and that in order to achieve very rich sootless burning it is necessary to premix the reactants thoroughly and to use high levels of air preheat. The application of two-stage combustion for the reduction of fuel NOx was reviewed. An experimental combustor designed and constructed for two-stage combustion experiments is described.

Clayton, R. M.↗
NASA NTRS1979

Emission characteristics of a premix combustor fueled with a simulated partial-oxidation product gas

A two-stage gas turbine combustor concept employing a very fuel-rich partial oxidation stage is being explored for broadening the combustion margin between ultralow emissions and the lean stability limit. Combustion and emission results are presented for a series of experiments where a simulated partial oxidation product gas was used in a premix combustor operated with inlet air state conditions typical of cruise power for high-performance aviation engines (12 atm and 850 F). Ultralow NOx, CO, and HC emissions and an extended lean burning limit were achieved simultaneously.

Clayton, R. M.↗
NASA NTRS1979

A partial oxidation staging concept for gas turbines using broadened specification fuels

A concept is described for using a very fuel-rich partial oxidation process as the first stage of a two-stage combustion system for onboard processing of broadened specification fuels to improve their combustion characteristics. Results of an initial step in the experimental verification of the concept are presented, where the basic benefits of H2 enrichment are shown to provide extended lean-combustion limits and permit simultaneous achievement of ultralow levels of NOx, CO, and HC emissions. The H2 required to obtain these results is within the range available from a partial oxidation precombustion stage. Operation of a catalytic partial oxidation reactor using a conventional aviation turbine fuel (JP5) and an unconventional fuel (blend of JP5/xylene) is shown to produce a 'fuel gas' stream with near-theoretical equilibrium H2 content. However, a number of design considerations indicate that the precombustion stage should be incorporated as a thermal reaction.

Clayton, R. M.↗
NASA NTRS1978

Hydrogen enrichment for low-emission jet combustion

Simultaneous gaseous pollutant emission indexes (g pollutant/kg fuel) for a research combustor with inlet air at 120,900 N/sq m (11.9 atm) pressure and 727 K (849 F) temperature are as low as 1.0 for NOx and CO and 0.5 for unburned HC. Emissions data are presented for hydrogen/jet fuel (JP-5) mixes and for jet fuel only for premixed equivalence ratios from lean blowout to 0.65. Minimized emissions were achieved at an equivalence ratio of 0.38 using 10-12 mass percent hydrogen in the total fuel to depress the lean blowout limit. They were not achievable with jet fuel alone because of the onset of lean blowout at an equivalence ratio too high to reduce the NOx emission sufficiently.

Clayton, R. M.↗
NASA NTRS1976

Reduction of gaseous pollutant emissions from gas turbine combustors using hydrogen-enriched jet fuel

Recent progress in an evaluation of the applicability of the hydrogen enrichment concept to achieve ultralow gaseous pollutant emission from gas turbine combustion systems is described. The target emission indexes for the program are 1.0 for oxides of nitrogen and carbon monoxide, and 0.5 for unburned hydrocarbons. The basic concept utilizes premixed molecular hydrogen, conventional jet fuel, and air to depress the lean flammability limit of the mixed fuel. This is shown to permit very lean combustion with its low NOx production while simulataneously providing an increased flame stability margin with which to maintain low CO and HC emission. Experimental emission characteristics and selected analytical results are presented for a cylindrical research combustor designed for operation with inlet-air state conditions typical for a 30:1 compression ratio, high bypass ratio, turbofan commercial engine.

Clayton, R. M.↗
NASA NTRS1973

Experimental verification of computer spray-combustion models

Analytical model formulation, representing performance of spray-combustion device, is based on understanding of atomization, mixing, vaporization, and combustion which occurs in device. Report lists results of correlations of computed values with values obtained from experiments with rocket combustor. Technique offers excellent method for evaluating validity and ranges of applicability of combustion models.

Nurick, W. H.↗
NASA NTRS1972

Stability evaluation of a rocket engine for gaseous oxygen difluoride (OF2) and gaseous diborane (B2H6) propellants

Results of an experimental evaluation of the dynamic stability of a candidate combustor for the space storable propellants gaseous OF2/B2H6 show that the combustor is unstable without supplementary damping. A computer analysis indicated that the uninhibited engine could be unstable. The experiments, conducted with O2/C2H4 substitute propellants and with 70-30 FLOX/B2H6 (OF2 simulated with FLOX), show that the uninhibited combustor has a low stability margin to starting transient perturbations, but that is relatively insensitive to bomb disturbances. Damping cavities are shown to provide stability.

Clayton, R. M.↗
NASA NTRS1966

Resonant combustion

Resonant combustion wave interaction on injector, steady state combustion properties, diagnostic methods for determining wave behavior, and chamber geometry effects on wave properties

COMBUSTION WAVE↗