Engineering Papers⌕ Search

Engineering topics

Chyu, W. J.

Publications and source records attributed to Chyu, W. J..

29 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Calculation of Unsteady Transonic Flow Over an Airfoil

An implicit finite-difference solver for either the Euler equations or the "thin-layer" Navier-Stokes equations was used to calculate a transonic flow over the NACA 64A010 airfoil pitching about its one-quarter chord. An unsteady automatic grid-generation procedure that will improve significantly the computational efficiency of various unsteady flow problems is described. The calculated results for both inviscid and viscous flows at Mach number 0.8 over the airfoil oscillating with reduced frequency referenced to one-half chord, 0.2, are compared with experimental data measured in the Ames 11 x 11 ft Transonic Wind Tunnel. Nonlinear, unsteady effects of the flow on the surface pressure variations, shock-wave excursions, and overall airloads are examined. Good agreements between the results of computations and experiments were obtained. In the shock-wave region, however, the results of the viscous-flow computations showed closer agreement with the experimental data.

Chyu, W. J.↗
NASA NTRS1978

Static and dynamic stability analysis of the space shuttle vehicle-orbiter

The longitudinal static and dynamic stability of a Space Shuttle Vehicle-Orbiter (SSV Orbiter) model is analyzed using the FLEXSTAB computer program. Nonlinear effects are accounted for by application of a correction technique in the FLEXSTAB system; the technique incorporates experimental force and pressure data into the linear aerodynamic theory. A flexible Orbiter model is treated in the static stability analysis for the flight conditions of Mach number 0.9 for rectilinear flight (1 g) and for a pull-up maneuver (2.5 g) at an altitude of 15.24 km. Static stability parameters and structural deformations of the Orbiter are calculated at trim conditions for the dynamic stability analysis, and the characteristics of damping in pitch are investigated for a Mach number range of 0.3 to 1.2. The calculated results for both the static and dynamic stabilities are compared with the available experimental data.

Chyu, W. J.↗
NASA NTRS1973

Response of panels to turbulence-induced, surface-pressure fluctuations and resulting acoustic radiation to the flow field.

The response of finite rectangular panels, excited by turbulent boundary layers and the resulting acoustical radiation into the flow field is studied. The method of normal modes and the technique of spectral analysis are used to compute the power spectra of the panel amplitude and strain response. Computed results are compared with the corresponding response measurements for panels exposed to attached and separated flows at supersonic speeds and attached flow at subsonic speeds. The thin plate and the convected wave equations are coupled through the boundary condition on the panel to give a formula for the radiation pressure power spectra. A formula for the acoustical damping ratio of the panel is obtained through the principle of virtual work.-

Chyu, W. J.↗
NASA NTRS1973

Pressure-fluctuation inputs and response of panels underlying attached and separated supersonic turbulent boundary layers

Results of an investigation of surface pressure fluctuations and response of panels underlying attached and separated turbulent boundary layers and shock waves are summarized. Extensive tests of a large assortment of axisymmetric and two-dimensional models have been conducted at transonic and supersonic Mach numbers to 3.6 to study the pressure fields. Assorted fixed-edge flat panels have been tested at Mach numbers from 1.6 to 3.6 in attached and completely separated flow fields and also in mixed flow with a step induced shock wave oscillating on the panels. The surface pressure fluctuations are described in terms of broadband rms, spectral density, and spatial correlation information. The effectiveness of parameters for scaling the pressure fluctuations is also illustrated. Measurements of the amplitude and strain response of the panels are compared with response computations by the normal method of analysis.

Coe, C. F.↗
NASA NTRS1972

Random response of rectangular panels to the pressure field beneath a turbulent boundary layer in subsonic flows

The response of a rectangular panel under the excitation of a turbulent boundary layer with a zero longitudinal mean pressure gradient in a subsonic flow was studied in detail. The method of normal mode was used together with the technique of spectral analysis. Both simply supported and clamped edge conditions of a panel were considered, and the displacement power spectral density of the panel response was computed. The results for the clamped edge panel compare favorably with existing data. Charts of structural acceptance, which provide a framework for estimating the response of other rectangular panels, are presented, and the physical significances of structural acceptances discussed.

Chyu, W. J.↗
NASA NTRS1972

Pressure-fluctuation inputs and response of panels underlying attached and separated supersonic turbulent boundary layers

Results are presented for an investigation of surface pressure fluctuations and response of panels underlying attached and separated turbulent boundary layers and shock waves. Tests conducted at transonic and supersonic Mach numbers to 3.6 to study the pressure fields. Assorted fixed edge flat panels were tested at Mach numbers from 1.6 to 3.6 in attached and completely separated flow fields, and also in mixed flow with a step-induced shock wave oscillating on the panels. The surface pressure fluctuations are described in terms of broadband rms, spectral density, and spatial correlation information. The effectiveness of parameters for scaling the pressure fluctuations is also illustrated. Measurements of the amplitude and strain response of the panels are compared with response computations by the normal mode method of analysis.

Coe, C. F.↗