Engineering topics
Publications and source records attributed to Chuang, S. L..
We measured directly the optical gain, refractive index change, and the linewidth enhancement factor of a type-II quantum-cascade laser. We obtained very low linewidth enhancement factor of 0.8 near threshold.
The partial intermixing of the well and barrier materials offers unique opportunities to shift locally the bandgap of quantum well structures (QW).
We demonstrate that SiO(sub 2) cap annealing in the ultra-thin p-type InGaAs/InP quantum wells can be used to produce large blue shifts of the band edge. A substantial bandgap blue shift, as much a 292.5 meV at 900 degrees C have been measured and the value of the bandgap shift can be controlled by the anneal time.
This paper describes a study conducted by NASA Ames Research Center (ARC) in collaboration with the Jet Propulsion Laboratory (JPL), Pasadena, California on the image acceptability of the Galileo Low Gain Antenna mission. The primary objective of the study is to determine the impact of the Integer Cosine Transform (ICT) compression algorithm on Galilean images of atmospheric bodies, moons, asteroids and Jupiter's rings. The approach involved fifteen volunteer subjects representing twelve institutions involved with the Galileo Solid State Imaging (SSI) experiment. Four different experiment specific quantization tables (q-table) and various compression stepsizes (q-factor) to achieve different compression ratios were used. It then determined the acceptability of the compressed monochromatic astronomical images as evaluated by Galileo SSI mission scientists. Fourteen different images were evaluated. Each observer viewed two versions of the same image side by side on a high resolution monitor, each was compressed using a different quantization stepsize. They were requested to select which image had the highest overall quality to support them in carrying out their visual evaluations of image content. Then they rated both images using a scale from one to five on its judged degree of usefulness. Up to four pre-selected types of images were presented with and without noise to each subject based upon results of a previously administered survey of their image preferences. Fourteen different images in seven image groups were studied. The results showed that: (1) acceptable compression ratios vary widely with the type of images; (2) noisy images detract greatly from image acceptability and acceptable compression ratios; and (3) atmospheric images of Jupiter seem to have higher compression ratios of 4 to 5 times that of some clear surface satellite images.
The third-order nonlinear intersubband absorption in a semiconductor quantum well is studied theoretically using the density matrix formalism including intrasubband relaxation. It is shown that the peak absorption is reduced by half for an optical intensity 1 MW/sq cm for the well size L = 126.5 A with 3.0 x 10 to the 16th/cu cm electrons.
Tunneling-assisted impact ionization across the conduction-band-edge discontinuity of quantum-well heterostructures is investigated and applied to a new superlattice structure. Multiquantum-well structures where the quantum-well regions are heavily doped and the undoped barrier regions are essentially insulating were considered. Incident hot electrons due to the applied electric field perpendicular to the heterointerface interact with the two-dimensional electrons confined to the quantum wells through Coulomb force. The resultant electrons can either have enough energy to get out of the wells or to tunnel through the triangular barriers. A new analytical approximation for the impact ionization rate is given which compares favorably with numerical results. The tunneling-assisted impact ionization rates and the ionization coefficients are calculated. It is shown that the tunneling effect reduces the ionization threshold and enhances the ionization rate significantly.
Superlattice photodetectors were investigated. A few major physical processes in the quantum-well heterostructures related to the photon detection and electron conduction mechanisms, the field effect on the wave functions and the energy levels of the electrons, and the optical absorption with and without the photon assistance were studied.
Variational calculations of subband eigenstates in an infinite quantum well with an applied electric field using Gram-Schmidt orthogonalized trial wave functions are presented. The results agree very well with the exact numerical solutions even up to 1200 kV/cm. It is also shown that, for increasing electric fields, the energy of the ground state decreases, while that of higher subband states increases slightly up to 1000 kV/cm and then decreases for a well size of 100 A.
A leaky-wave theory is applied to the study of the lateral shift of a bounded optical beam reflected from a prism-air-metal (and prism-metal-air) layered configuration with surface-plasmon excitations. The locations of the pole and the zero of the reflection coefficient for the leaky surface-plasmon mode are calculated as one varies the thickness of the center layer. The excited surface-plasmon mode is leaky because of the presence of the prism. Both the real part and the imaginary part of the pole are affected by the energy leakage. The detailed structure of the reflected intensity and the forward and backward shifts of the reflected beam are illustrated.
Impact ionization across the band-edge discontinuity of quantum-well heterostructures is studied theoretically. A heterolayer structure of alternating Al(x)Ga(1-x)As and GaAs layers is considered where the GaAs layers are heavily doped with donors. Thus a large number of electrons is confined to the quantum-well region. Incident electrons are heated up by applied electric fields and collide with the electrons confined in the well regions. Both the ionization rate as a function of the incident energy, and average ionization rates are computed. Device applications of such multiple quantum-well structures and the possibility of a complete analog to the conventional photomultiplier are discussed.
Technical progress made in the study of superlattice photoconductors is summarized and papers submitted for publication are listed. Since the quantum-well regions may contain several subbands, each of which may be occupied by electrons depending on the doping concentrations, it is important to include the multi-subbands in calculating the impact ionization rate. The electrons occupying the higher subbands require a smaller amount of energy to get out of the quantum well; thus, those higher level subband electrons contribute significantly to the impact ionization rate. The results of the subbands have been calculated. Results concerning the nonparabolicity effect of the band structure, the effect of the quantum-well size, and the effect of the band-edge discontinuity and doping are also summarized.
During the past half-year, the research effort centered on further investigating both the new superlattice photomultiplier with tunneling-assisted impact ionization and the photodetector based on the real space transfer mechanism. A brief outline of the current status of these projects is presented. Detailed analyses are included in Appendices A and B. New results of the tunneling-assisted impact ionization are presented.
Attenuation properties of the normal modes in an overmoded waveguide coated with a lossy material were analyzed. It is found that the low-order modes, can be significantly attenuated even with a thin layer of coating if the coating material is not too lossy. A thinner layer of coating is required for large attenuation of the low-order modes if the coating material is magnetic rather than dielectric. The Radar Cross Section (RCS) from an uncoated circular guide terminated by a perfect electric conductor was calculated and compared with available experimental data. It is confirmed that the interior irradiation contributes to the RCS. The equivalent-current method based on the geometrical theory of diffraction (GTD) was chosen for the calculation of the contribution from the rim diffraction. The RCS reduction from a coated circular guide terminated by a PEC are planned schemes for the experiments are included. The waveguide coated with a lossy magnetic material is suggested as a substitute for the corrugated waveguide.
The normal modes in an overmoded waveguide coated with a lossy material are analyzed, particularly for their attenuation properties as a function of coating material, layer thickness, and frequency. When the coating material is not too lossy, the low-order modes are highly attenuated even with a thin layer of coating. This coated guide serves as a mode suppressor of the low-order modes, which can be particularly useful for reducing the radar cross section (RCS) of a cavity structure such as a jet inlet. When the coating material is very lossy, low-order modes fall into two distinct groups: highly and lowly attenuated modes. However, as a/lambda (a = radius of the cylinder; lambda = the free-space wavelength) increases, the separation between these two groups becomes less distinctive. The attenuation constants of most of the low-order modes become small, and decrease as a function of lambda sup 2/a sup 3.
Two novel types of superlattice photodetectors were studied. The first was a superlattice photomultiplier and the second a photodetector based on the real space transfer mechanism. A summary of the results is presented.
Numerical methods to analyze electromagnetic scattering are presented. The dispersions and attenuations of the normal modes in a circular waveguide coated with lossy material were completely analyzed. The radar cross section (RCS) from a circular waveguide coated with lossy material was calculated. The following is observed: (1) the interior irradiation contributes to the RCS much more than does the rim diffraction; (2) at low frequency, the RCS from the circular waveguide terminated by a perfect electric conductor (PEC) can be reduced more than 13 dB down with a coating thickness less than 1% of the radius using the best lossy material available in a 6 radius-long cylinder; (3) at high frequency, a modal separation between the highly attenuated and the lowly attenuated modes is evident if the coating material is too lossy, however, a large RCS reduction can be achieved for a small incident angle with a thin layer of coating. It is found that the waveguide coated with a lossy magnetic material can be used as a substitute for a corrugated waveguide to produce a circularly polarized radiation yield.
Explore the source record for details and available documents.
The wave attenuation in a cylindrical waveguide coated with lossy dielectric material was studied. The scope was extended to the high frequency case for calculating attenuation coefficients and propagation constants of a dielectric coated circular waveguide. The magnetic material coating was studied. At low frequency a one way 3dB attenuation was achieved within a longitudinal distance of one diameter. A software program was generated to plot the field patterns of the lowest 30 modes in the cylindrical waveguides.