Engineering Papers⌕ Search

Engineering topics

Choi, J

Publications and source records attributed to Choi, J.

23 records · Page 2

Stripe-to-bubble transition of magnetic domains at the spin reorientation of (Fe/Ni)/Cu/Ni/Cu(001)

Magnetic domain evolution at the spin reorientation transition (SRT) of (Fe/Ni)/Cu/Ni/Cu(001) is investigated using photoemission electron microscopy. While the (Fe/Ni) layer exhibits the SRT, the interlayer coupling of the perpendicularly magnetized Ni layer to the (Fe/Ni) layer serves as a virtual perpendicular magnetic field exerted on the (Fe/Ni) layer. We find that the perpendicular virtual magnetic field breaks the up-down symmetry of the (Fe/Ni) stripe domains to induce a net magnetization in the normal direction of the film. Moreover, as the virtual magnetic field increases to exceed a critical field, the stripe domain phase evolves into a bubble domain phase. Although the critical field depends on the Fe film thickness, we show that the area fraction of the minority domain exhibits a universal value that determines the stripe-to-bubble phase transition.

36 MATERIALS SCIENCE↗

Processing and characterization of new passive and active oxysulfide glasses in the Ge-Ga-Sb-S-O system

New passive and active oxysulfide glasses have been prepared in the Ge-Ga-Sb-S-O system employing a two-step melting process which involves the processing of the chalcogenide glass (ChG) and its subsequent melting with amorphous GeO{sub 2} or Sb{sub 2}O{sub 3} powder. Optical characterization of the oxysulfide glasses has shown that the UV cut-off wavelength decreases with increasing oxygen content. Using Raman spectroscopy, correlations have been made between the formation of new Ge- and Sb-based oxysulfide structural units, the Sb content and the O/S ratio. We demonstrate the successful processing of active rare earth doped oxysulfide glasses by melting the chalcogenide glass with Er{sub 2}O{sub 3} and Sb{sub 2}O{sub 3} and also by melting the Er{sup 3+} doped chalcogenide glass with Sb{sub 2}O{sub 3}. Modification of the emission spectra at 1500 nm of Er{sup 3+} doped samples with the introduction of oxygen revealed that Er{sup 3+} most likely exists in dual O- and S-neighbor environments. Finally, the photo-response of these new glasses upon near-IR femtosecond laser irradiation has been investigated as a function of Sb content and O/S ratio and shows that the glasses are photo-sensitive to NIR fs laser light with the magnitude of the photo-sensitivity dependent on the glass' Sb content and O/S ratio. - Graphical abstract: In this paper, we demonstrate the successful processing of active rare earth doped oxysulfide glasses by melting the chalcogenide glass with Er{sub 2}O{sub 3} and Sb{sub 2}O{sub 3} but also by melting the Er{sup 3+} doped chalcogenide glass with Sb{sub 2}O{sub 3}. These new glasses were found to be photo-sensitive to near-IR femtosecond laser irradiation and to exhibit a surface photo-expansion after laser irradiation which remains, as expected, lower than similar response seen for oxygen-free chalcogenide glasses.

36 MATERIALS SCIENCE↗

Iron-Based Amorphous-Metals: High-Performance Corrosion-Resistant Materials (HPCRM) Development Final Report

An overview of the High-Performance Corrosion-Resistant Materials (HPCRM) Program, which was co-sponsored by the Defense Advanced Research Projects Agency (DARPA) Defense Sciences Office (DSO) and the United States Department of Energy (DOE) Office of Civilian and Radioactive Waste Management (OCRWM), is discussed. Programmatic investigations have included a broad range of topics: alloy design and composition; materials synthesis; thermal stability; corrosion resistance; environmental cracking; mechanical properties; damage tolerance; radiation effects; and important potential applications. Amorphous alloys identified as SAM2X5 (Fe{sub 49.7}Cr{sub 17.7}Mn{sub 1.9}Mo{sub 7.4}W{sub 1.6}B{sub 15.2}C{sub 3.8}Si{sub 2.4}) and SAM1651 (Fe{sub 48}Mo{sub 14}Cr{sub 15}Y{sub 2}C{sub 15}B{sub 6}) have been produced as melt-spun ribbons, drop-cast ingots and thermal-spray coatings. Chromium (Cr), molybdenum (Mo) and tungsten (W) additions provided corrosion resistance, while boron (B) enabled glass formation. Earlier electrochemical studies of melt-spun ribbons and ingots of these amorphous alloys demonstrated outstanding passive film stability. More recently thermal-spray coatings of these amorphous alloys have been made and subjected to long-term salt-fog and immersion tests. Good corrosion resistance has been observed during salt-fog testing. Corrosion rates were measured in situ with linear polarization, while simultaneously monitoring the open-circuit corrosion potentials. Reasonably good performance was observed. The sensitivity of these measurements to electrolyte composition and temperature was determined. The high boron content of this particular amorphous metal make this amorphous alloy an effective neutron absorber, and suitable for criticality control applications. In general, the corrosion resistance of these iron-based amorphous metals is maintained at operating temperatures up to the glass transition temperature. These materials are much harder than conventional stainless steel and nickel-based materials, and are proving to have excellent wear properties, sufficient to warrant their use in earth excavation, drilling and tunnel boring applications. The observed corrosion resistance may enable applications of importance in industries such as: oil and gas production, refining, nuclear power generation, shipping, and others. Large areas have been successfully coated with these materials, with thicknesses of approximately one centimeter.

36 MATERIALS SCIENCE↗

Ni spin switching induced by magnetic frustration in FeMn/Ni/Cu(001)

Epitaxially grown FeMn/Ni/Cu(001) films are investigated by Photoemission Electron Microscopy and Magneto-Optic Kerr Effect. We find that as the FeMn overlayer changes from paramagnetic to antiferromagnetic state, it could switch the ferromagnetic Ni spin direction from out-of-plane to in-plane direction of the film. This phenomenon reveals a new mechanism of creating magnetic anisotropy and is attributed to the out-of-plane spin frustration at the FeMn-Ni interface.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Formation and dissolution of copper-based nanoparticles in SiO{sub 2} sol-gel film using heat treatment and/or UV light exposure

We report in this paper, results on the formation and dissolution of Cu-based nanoparticles in sol-gel SiO{sub 2} thin films using heat treatment and UV light exposure, respectively. Using UV-vis-NIR spectroscopy, we have shown that Cu{sub 2}O nanoparticles can be generated by controlling the aging of the sol prior to film deposition while the Cu{sup 0} nanoparticles can be synthesized using a heat treatment in H{sub 2} atmosphere at 550 deg. C for 6 h. It has been also demonstrated that irradiation with an UV pulsed (Q-switched Nd:YAG) or continuous black ray UV lamp can dissolve these Cu-based nanoparticles with controlled, spatial selectivity. The mechanism of the dissolution process was found to be mainly thermal. Finally, we report a new analytical technique for detecting/confirming the presence of low densities of Cu nanoparticles in the films, based on a relative heat flow measurement of such films using a micro-thermal analyzer (e.g., TA Instruments {mu}TA model 2990)

36 MATERIALS SCIENCE↗