Engineering topics

Chigier, Norman

Publications and source records attributed to Chigier, Norman.

7 records

NASA NTRS1996

Transport Phenomena in Stratified Multi-Fluid Flow in the Presence and Absence of Gravity

Experiments are being conducted to study the effects of buoyancy on planar density-stratified shear flows. A wind tunnel generates planar flows separated by an insulating splitter plate, with either flow heated, which emerge from a two-dimensional nozzle. The objective is to isolate and define the effect of gravity and buoyancy on a stratified shear layer. To this end, both stably and unstably stratified layers will be investigated. This paper reports on the results of temperature and velocity measurements across the nozzle exit plane and downstream along the nozzle center plane.

Chigier, Norman↗

NASA NTRS1994

Transport phenomena in stratified multi-fluid flo w in the presence and absence of gravity

An experiment is being conducted to study the effects of buoyancy on planar stratified flows. A wind tunnel has been designed and constructed to generate planar flows with separate heating for the top and bottom planar air jets emerging from slot nozzles separated by an insulating splitter plate. The objective is to generate planar jet flows with well defined and well controlled velocity and temperature profiles. Magnitudes of velocity and temperature will be varied separately in each flow for both laminar and turbulent flow conditions. Both stably and unstably stratified flows will be studied by changing the temperature distributions in each air stream. This paper reports on the design of the apparatus and initial measurements of velocity and turbulence made by laser Doppler velocimetry.

Chigier, Norman↗

NASA NTRS1991

Dynamic behavior of liquid sheets

An experiment was conducted to study the aerodynamic instability of liquid sheets issuing from a two-dimensional air-assisted nozzle. Detailed measurements of the frequency of oscillation of the liquid sheet have been made. The measured vibrational frequencies were then correlated with the resulting spray angle. It was shown that the liquid sheet oscillations are dynamically similar to that of hard spring systems. For each air pressure, three distinct modes of breakup are distinguished. At low liquid flow rates, both the sinusoidal and the dilational modes are superimposed on the liquid sheet. With a further increase in liquid flow rate, the liquid sheet oscillations mainly become of the dilational type. It was also shown that the effect of introducing air in the nozzle is similar to the effect of inducing forced vibrations on the nozzle jaws. Thus, for each air flow rate, there is a specific vibration frequency for the nozzle. The frequency of these vibrations is proportional to the air velocity. As the liquid sheet natural frequency approaches that of the nozzle, resonance is established. At resonance, the maximum spray angle is achieved.

Mansour, Adel↗

NASA NTRS1991

Coaxial atomizer liquid intact lengths

Average intact lengths of round liquid jets generated by airblast coaxial atomizer were measured from over 1500 photographs. The intact lengths were studied over a jet Reynolds number range of 18,000 and Weber number range of 260. Results are presented for two different nozzle geometries. The intact lengths were found to be strongly dependent on Re and We numbers. An empirical equation was derived as a function of these parameters. A comparison of the intact lengths for round jets and flat sheets shows that round jets generate shorter intact lengths.

Eroglu, Hasan↗

NASA NTRS1990

Disintegration of liquid sheets

The development, stability, and disintegration of liquid sheets issuing from a two-dimensional air-assisted nozzle is studied. Detailed measurements of mean drop size and velocity are made using a phase Doppler particle analyzer. Without air flow the liquid sheet converges toward the axis as a result of surface tension forces. With airflow a quasi-two-dimensional expanding spray is formed. The air flow causes small variations in sheet thickness to develop into major disturbances with the result that disruption starts before the formation of the main break-up region. In the two-dimensional variable geometry air-blast atomizer, it is shown that the air flow is responsible for the formation of large, ordered, and small chaotic 'cell' structures.

Mansour, Adel↗

NASA NTRS1988

An experimental study of air-assist atomizer spray flames

It is noted that air-assisted atomizer spray flames encountered in furnaces, boilers, and gas turbine combustors possess a more complex structure than homogeneous turbulent diffusion flames, due to the swirling motion introduced into the fuel and air flows for the control of flame stability, length, combustion intensity, and efficiency. Detailed comparisons are presented between burning and nonburning condition measurements of these flames obtained by nonintrusive light scattering phase/Doppler detection. Spray structure is found to be drastically changed within the flame reaction zone, with changes in the magnitude and shape of drop number density, liquid flux, mean drop size diameter, and drop mean axial velocity radial distributions.

Mao, Chien-Pei↗

NASA NTRS1987

An experimental investigation of air-assist non-swirl atomizer sprays

Detailed measurements and comparisons were made of air-assist nonswirl atomizer sprays currently being used in aircraft icing research. The critical liquid to air mass flowrate ratio to achieve a good quality of atomization and the most suitable mean dropsize correlation equation has been determined. Two of the most sophisticated and effective instruments, the Laser Diffraction particle sizer (Malvern) and Phase/Doppler particle analyzer (Aerometrics), have been successfully employed in spray characterization over a wide range of operating conditions. Results obtained by line-of-sight measurements using the Laser Diffraction sizer are compared with point measurements obtained by using the Phase/Doppler analyzer as well as with photographs. The accuracy and limitations of using the various instruments for spray characterization are discussed.

Wang, Geng↗