Engineering Papers⌕ Search

Engineering topics

Chen, Xiaowen

Publications and source records attributed to Chen, Xiaowen.

27 records · Page 2
All sourcesNASA NTRSDOE OSTI
DOE OSTI2021

Controlling Bacterial Contamination During Fuel Ethanol Fermentation Using Thermochemically Depolymerized Lignin Bio-Oils

Lactic acid bacteria (LAB) contamination during fuel ethanol fermentation can lead to significant economic loses. To circumvent this, fuel ethanol plants add antibiotics prophylactically, but their overuse has resulted in the emergence of antibiotic-resistant LAB strains. Lignin is a sustainable biopolymer that can be found as a waste product from lignocellulosic biorefineries. Technical lignins and their smaller phenolic subunits have been shown to exhibit broad-spectrum antimicrobial properties, but there is a lack of demonstrations of lignin derivatives with highly selective properties in the literature. Here, corn stover lignin from a biorefinery was oxidatively depolymerized using an environmentally benign organic oxidant, peracetic acid, into a bio-oil that has selective antimicrobial properties against LAB and not yeasts. The resulting bio-oil demonstrated up to 90% inhibition of commercially sampled LAB (including antibiotic-resistant strains) at 4 mg ml-1 with no inhibition against an industrial yeast strain. These antimicrobial properties of the bio-oil are attributed to larger unidentified lignin oligomers, compared to monolignols, that have a membrane damaging mode of action. Using the bio-oil (4 mg ml-1) during simultaneous saccharification and fermentation (SSF) of raw corn starch showed no inhibition of enzymatic activity, and in LAB contaminated fermentations the bio-oil treatments showed an 8% increase in ethanol yields at higher bacterial contamination ratios (l : 100 yeast to LAB, CFU per ml). This study illustrates the efficacy of using lignin bio-oil as an antibiotic replacement during fuel ethanol fermentation and demonstrates the highly selective antimicrobial properties of lignin oligomers, which creates a viable lignin valorization strategy for biorefineries.

bio-oil↗
DOE OSTI2021

Iron incorporation both intra- and extra-cellularly improves the yield and saccharification of switchgrass (Panicum virgatum L.) biomass

Abstract Background Pretreatments are commonly used to facilitate the deconstruction of lignocellulosic biomass to its component sugars and aromatics. Previously, we showed that iron ions can be used as co-catalysts to reduce the severity of dilute acid pretreatment of biomass. Transgenic iron-accumulating Arabidopsis and rice plants exhibited higher iron content in grains, increased biomass yield, and importantly, enhanced sugar release from the biomass. Results In this study, we used intracellular ferritin (FerIN) alone and in combination with an improved version of cell wall-bound carbohydrate-binding module fused iron-binding peptide (IBPex) specifically targeting switchgrass, a bioenergy crop species. The FerIN switchgrass improved by 15% in height and 65% in yield, whereas the FerIN/IBPex transgenics showed enhancement up to 30% in height and 115% in yield. The FerIN and FerIN/IBPex switchgrass had 27% and 51% higher in planta iron accumulation than the empty vector (EV) control, respectively, under normal growth conditions. Improved pretreatability was observed in FerIN switchgrass (~ 14% more glucose release than the EV), and the FerIN/IBPex plants showed further enhancement in glucose release up to 24%. Conclusions We conclude that this iron-accumulating strategy can be transferred from model plants and applied to bioenergy crops, such as switchgrass. The intra- and extra-cellular iron incorporation approach improves biomass pretreatability and digestibility, providing upgraded feedstocks for the production of biofuels and bioproducts.

09 BIOMASS FUELS↗
DOE OSTI2021

Modelling a compressible packed bed flow-through washing and deacetylation reactor for corn stover pretreatment

The deacetylation process is a key step in the lignocellulosic biomass pretreatment process that currently is done in batch reactors. A flow-through diffuser type reactor is a promising approach to make the process more efficient and economically favorable. A washing step before deacetylation can further reduce chemical usage and increase the process efficiency. However, the highly compacted biomass particles can cause significant pressure-drop for fluid flow through the bed, which in the worst case can cause self-enhancing pressure-drop leading to reactor blocking. Detailed understanding of the fundamentals of flow through a compressible packed bed is necessary to scale up the washing and deacetylation process. This work closely examines the classical Kozeny Carman equation and proposes modifications to accurately predict the pressure-drop at different compaction states. Here, a compressible packed bed model is further developed based on the interaction between solid mechanics and fluid dynamics. Experimental measurements of water flow through a packed bed of corn stover show good agreement with the developed model. Corn stover washing process scale up simulations show that smaller reactor diameter, higher friction lining material, lower process throughput, and higher process temperature is favorable in stabilizing the bed from extensive compression when the bed height is fixed.

09 BIOMASS FUELS↗
DOE OSTI2020

Antimicrobial Properties of Corn Stover Lignin Fractions Derived from Catalytic Transfer Hydrogenolysis in Supercritical Ethanol with a Ru/C Catalyst

Converting lignin to value-added products at high yields provides an avenue for making ethanol biorefineries more profitable while reducing the carbon footprint of products generally derived from petroleum. In this study, corn stover lignin was depolymerized by catalytic transfer hydrogenolysis (CTH) in supercritical ethanol with a Ru/C catalyst. The lignin-derived bio-oil was then sequentially extracted utilizing hexane, petroleum ether, chloroform, and ethyl acetate as solvents in order of less polar to polar, and the subsequent bio-oils were characterized using GPC, GC/MS, and HSQC NMR. In this work, results show that the monomers in the bio-oil fractions contained primarily alkylated phenols, hydrogenated hydroxycinnamic acid derivatives, syringol and guaiacol-type lignins created from reductive cleavages of ether linkages, which were sequentially extracted into groups depending on the solvent polarity. The antimicrobial properties of the bio-oils were screened against Gram-positive (Bacillus subtilis, Lactobacillus amylovorus, and Staphylococcus epidermidis) and Gram-negative (Escherichia coli) bacteria and yeast (Saccharomyces cerevisiae) by examining microbial growth inhibition. Results show that CTH-derived bio-oils inhibited all tested organisms at concentrations less than 3 mg/mL. Total monomer concentration and the presence of specific monomers (i.e., syringyl propane) showed correlations to antimicrobial activity, likely due to cell death or membrane damage. This study provides insights into using sequential extraction to fractionate lignin-derived compounds and correlations between the properties of the extracted compounds and their antimicrobial activity.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2020

Deep Eutectic Solvent Extraction of High-Purity Lignin from a Corn Stover Hydrolysate

Here, a lactic acid/chlorine chloride-based deep eutectic solvent (DES) was used for the extraction of high-purity lignin (up to 94.7%) in high yield (up to 75%) from the hydrolysis/fermentation residue corn stover hydrolysate (CSH), which was generated from a pilot-plant-scale biorefinery. A range of extraction conditions were investigated, which involved varying reaction temperature, time, and DES composition. The relationship between lignin yield, purity, and structural characteristics with DES treatment conditions was determined. The extraction of high-purity lignin from hydrolysis/fermentation residues presents a promising approach for enhancing the economic feasibility of a lignocellulose biorefinery. It was also determined that DES extraction can produce lignin with a controlled range of molecular weight and functional group content.

09 BIOMASS FUELS↗
DOE OSTI2020

Deacetylation and Mechanical Refining (DMR) and Deacetylation and Dilute Acid (DDA) Pretreatment of Corn Stover, Switchgrass, and a 50/50 Corn Stover/Switchgrass Blend

The most economical feedstock available to future lignocellulosic biorefineries may be a feedstock blend. Corn stover, switchgrass, and a 50:50 blend of corn stover and switchgrass were subjected to three different dilute alkali deacetylation conditions in a 90 L reactor prior to either mechanical refining (DMR) in a disc refiner followed by a Szego mill or dilute acid pretreatment (DDA) at five different conditions in a 4 L batch steam explosion reactor. The forty-five DDA and nine DMR slurries were subjected to high solids enzymatic hydrolysis at an enzyme loading of 15 mg protein per gram cellulose using Novozymes Cellic CTec3 (DDA) or a 4:1 mix of Novozymes Cellic CTec3:HTec 3 (DMR). The highest glucose yield was achieved using DMR processed corn stover from the high severity deacetylation condition (92 °C and 100 kg NaOH/ODMT) at 95.9% ± 0.8%, while the greatest monomeric glucose yields for switchgrass were between 75% to 80%. The glucose yields from saccharification of the 50:50 corn stover/switchgrass blend was approximately the average of the two individual feedstocks for both DDA and DMR processes. Statistical analysis showed that for a given feedstock type dilute alkali deacetylation severity had a significant impact (p < 0.05) on enzymatic hydrolysis yields, and for a given deacetylation severity the feedstock type had a significant effect on glucose conversion with the addition of switchgrass resulting in lower glucose yields. A blending strategy to maximize enzymatic hydrolysis sugar yields while reducing carbohydrate solubilization during the alkaline treatment step was proposed that allows deacetylation of feedstocks with different recalcitrance at optimal conditions for that feedstock, then blending prior to enzymatic hydrolysis.

BIOMASS FUELS,INORGANIC, ORGANIC, PHYSICAL, AND AN↗
DOE OSTI2020

Ferrous and Ferric Ion-Facilitated Dilute Acid Pretreatment of Lignocellulosic Biomass under Anaerobic or Aerobic Conditions: Observations of Fe Valence Interchange and the Role of Fenton Reaction

Ferrous ion co-catalyst enhancement of dilute-acid (DA) pretreatment of biomass is a promising technology for increasing the release of sugars from recalcitrant lignocellulosic biomass. However, due to the reductive status of ferrous ion and its susceptibility to oxidation with exposure to atmosphere, its effective application presumably requires anaerobic aqueous conditions created by nitrogen gas-purging, which adds extra costs. The objective of this study was to assess the effectiveness of oxidative iron ion, (i.e., ferric ion) as a co-catalyst in DA pretreatment of biomass, using an anaerobic chamber to strictly control exposure to oxygen during setup and post-pretreatment analyses. Remarkably, the ferric ions were found to be as efficient as ferrous ions in enhancing sugar release during DA pretreatment of biomass, which may be attributed to the observation that a major portion of the initial ferric ions were converted to ferrous during pretreatment. Furthermore, the detection of hydrogen peroxide in the liquors after DA/Fe ion pretreatment suggests that Fenton reaction chemistry was likely involved in DA/Fe ion pretreatments of biomass, contributing to the observed ferric and ferrous interchanges during pretreatment. These results help define the extent and specification requirements for applying iron ions as co-catalysts in DA pretreatments of biomass.

09 BIOMASS FUELS↗