Engineering Papers⌕ Search

Engineering topics

Chen, R. T. N.

Publications and source records attributed to Chen, R. T. N..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1986

Influence of high-order dynamics on helicopter flight-control system bandwidth

The increasing use of highly augmented digital flight-control systems in modern military helicopters prompted an examination of the influence of the influence of rotor dynamics and other high-order dynamics on control-system performance. A study was conducted at NASA Ames Research Center to correlate theoretical predictions of feedback gain limits in the roll axis with experimental test data obtained from a variable-stability research helicopter. Feedback gains, the break frequency of the presampling sensor filter, and the computational frame time of the flight computer were systematically varied. The results, which showed excellent theoretical and experimental correlation, indicate that the rotor-dynamics, sensor-filter, and digital-data processing delays can severely limit the usable values of the roll-rate and roll-attitude feedback gains.

Chen, R. T. N.↗
NASA NTRS1986

New capabilities and recent research programs of the NASA/Army CH-47B variable-stability helicopter

The CH-47B is the third in a series of variable-stability helicopters developed and operated by NASA since 1952 to investigate helicopter and VTOL handling qualities. Recently, several new capabilities were added to this helicopter to enable it to better support new and evolving research requirements. The installation of a programmable force-feel system for the evaluation pilot's conventional cyclic stick, and a four-axis side-stick controller permit a range of in-flight investigations concerning manipulator characteristics and augmentation system features that had not been possible with earlier NASA research helicopters. A recently installed color electronic display system with a programmable symbol generator will permit the investigation of display formats for a variety of VTOL and helicopter missions. Finally, a powerful new general-purpose flight computer is now in operation. It is programmable in high-level languages and will provide more efficient support of research programs. In addition to these new hardware capabilities, flight-control software has been developed to improve the in-flight simulation capability of the aircraft. A brief description of the CH-47B's variable-stability research equipment is provided, recent research programs are summarized, and some remarks concerning the potential of the helicopter are presented.

Hindson, W. S.↗
NASA NTRS1986

The role of modeling and flight testing in rotorcraft parameter identification

The importance of recognizing that each lower-order model used for rotorcraft parameter identification has a limited range of applicability is illustrated in some detail. Examples are given to illustrate the use of conditioning the test input signals and the potential of using multi-axis test inputs to enhance the parameter identifiability. The paper discusses the benefits and limitations of using frequency sweeps as flight-test input signals for identification of frequency response for rotorcraft and for the subsequent fitting of parametric transfer-function models. This paper demonstrates the major role played by analytical modeling and the understanding of the physics involved in the rotorcraft flight dynamics, particularly understanding the limit of lower-order models, in achieving successful rotorcraft parameter identification.

Chen, R. T. N.↗
NASA NTRS1985

Analytical and flight investigation of the influence of rotor and other high-order dynamics on helicopter flight-control system bandwidth

The increasing use of highly augmented digital flight-control systems in modern military helicopters prompted an examination of the influence of rotor dynamics and other high-order dynamics on control-system performance. A study was conducted at NASA Ames Research Center to correlate theoretical predictions of feedback gain limits in the roll axis with experimental test data obtained from a variable-stability research helicopter. Feedback gains, the break frequency of the presampling sensor filter, and the computational frame time of the flight computer were systematically varied. The results, which showed excellent theoretical and experimental correlation, indicate that the rotor-dynamics, sensor-filter, and digital-data processing delays can severely limit the usable values of the roll-rate and roll-attitude feedback gains.

Chen, R. T. N.↗
NASA NTRS1984

Rotorcraft flight-propulsion control integration

The parallel development of digital engine and flight controls for U.S. Army helicopters has made possible the future derivation of a fully integrated digital flight/propulsion control system. A NASA/Army research program has been undertaken to exploit these possibilities, ultimately yielding a generation of helicopters with exceptional agility and maneuverability in military roles and low pilot workloads in all-weather civil aviation missions. The program's three phases respectively address system modeling and analysis, flight hardware and software development, and flight evaluations aboard a research vehicle.

Mihaloew, J. R.↗
NASA NTRS1983

A summary of NASA/FAA experiments concerning helicopter IFR airworthiness criteria

A sequence of ground and flight simulation experiments was conducted to investigate helicopter instrument-flight-rules airworthiness criteria. The first six of these experiments and major results are summarized. Five of the experiments were conducted on large-amplitude motion base simulators. The NASA-Army V/STOLAND UH-1H variable-stability helicopter was used in the flight experiment. Artificial stability and control augmentation, longitudinal and lateral control, and in pitch and roll attitude augmentation were investigated. Previously announced in STAR as N82-23219

Lebacqz, J. V.↗
NASA NTRS1982

A mathematical model of a single main rotor helicopter for piloted simulation

A mathematical model, suitable for piloted simulation of the flying qualities of helicopters, is a nonlinear, total force and moment model of a single main rotor helicopter. The model has ten degrees of freedom: six rigid body, three rotor flapping, and the rotor rotational degrees of freedom. The rotor model assumes rigid blades with rotor forces and moments radially integrated and summed about the azimuth. The fuselage aerodynamic model uses a detailed representation over a nominal angle of attack and sideslip range of + or - 15 deg., as well as a simplified curve fit at large angles of attack or sideslip. Stabilizing surface aerodynamics are modeled with a lift curve slope between stall limits and a general curve fit for large angles of attack. A generalized stability and control augmentation system is described. Additional computer subroutines provide options for a simplified engine/governor model, atmospheric turbulence, and a linearized six degree of freedom dynamic model for stability and control analysis.

Talbot, P. D.↗
NASA NTRS1982

Flight dynamics of rotorcraft in steep high-g turns

An analyticl procedure developed to permit a systematic examination of rotorcraft flight dynamics in steep high-g turns is presented. The procedure is used in a numerical investigation of a tilt-rotor aircraft and three single-rotor helicopters that have different types of main rotor systems. The results indicate (1) that strong coupling in longitudinal and lateral-directional motions exists for these rotorcraft in high-g turns; (2) that for single-rotor helicopters, the direction of turn has a significant influence on flight dynamics; and (3) that a stability and control augmentation system that is designed on the basis of standard small-disturbance equations of motion from steady straight and level flight and that otherwise performs satisfactorily in operations near 1 g, becomes significantly degraded in steep turning flight.

Chen, R. T. N.↗
NASA NTRS1982

Unified results of several analytical and experimental studies of helicopter handling qualities in visual terrain flight

The studies were undertaken to investigate the effects of rotor design parameters, interaxis coupling, and various levels of stability and control augmentation on the flying qualities of helicopters performing low-level, terrain-flying tasks in visual meteorological conditions. Some unified results are presented, and the validity and limitations of the flying-qualities data obtained are interpreted. Selected results, related to various design parameters, provide guidelines for the preliminary design of rotor systems and aircraft augmentation systems.

Chen, R. T. N.↗
NASA NTRS1982

Results of NASA/FAA ground and flight simulation experiments concerning helicopter IFR airworthiness criteria

A sequence of ground and flight simulation experiments was conducted to investigate helicopter instrument-flight-rules airworthiness criteria. The first six of these experiments and major results are summarized. Five of the experiments were conducted on large-amplitude motion base simulators. The NASA-Army V/STOLAND UH-1H variable-stability helicopter was used in the flight experiment. Artificial stability and control augmentation, longitudinal and lateral control, and in pitch and roll attitude augmentation were investigated.

Lebacqz, J. V.↗
NASA NTRS1981

Kinematic properties of rotary-wing and fixed-wing aircraft in steady coordinated high-g turns

An analytical approach to the study of flight dynamics of aircraft operating in a high-angle-of-attack flight regime and of helicopters operating in extreme thrust conditions is presented. Steady coordinated high-g turns are used to establish the initial equilibrium flight conditions near stall angles of attack. The kinematic properties of the aircraft in steady coordinated turns are examined: in high-g turns, pitch rate (independent of the angle of attack) is of a much larger magnitude than roll and yaw rate; a substantial roll rate is found to develop in steep turns for all angles of attack; the angle of attack also has a significant effect on the pitch attitude, with decreasing influence as the normal load factor increases. The exact small disturbance equations of motion of the aircraft in general steady turns are also developed for application to both rotary-wing and fixed-wing aircraft in extreme conditions. These equations are in a first-order, vector-matrix format, and are thus compatible with many efficient software packages developed in modern system theory.

Chen, R. T. N.↗
NASA NTRS1981

Kinematic properties of the helicopter in coordinated turns

A study on the kinematic relationship of the variables of helicopter motion in steady, coordinated turns involving inherent sideslip is described. A set of exact kinematic equations which govern a steady coordinated helical turn about an Earth referenced vertical axis is developed. A precise definition for the load factor parameter that best characterizes a coordinated turn is proposed. Formulas are developed which relate the aircraft angular rates and pitch and roll attitudes to the turn parameters, angle of attack, and inherent sideslip. A steep, coordinated helical turn at extreme angles of attack with inherent sideslip is of primary interest. The bank angle of the aircraft can differ markedly from the tilt angle of the normal load factor. The normal load factor can also differ substantially from the accelerometer reading along the vertical body axis of the aircraft. Sideslip has a strong influence on the pitch attitude and roll rate of the helicopter. Pitch rate is independent of angle of attack in a coordinated turn and in the absence of sideslip, angular rates about the stability axes are independent of the aerodynamic characteristics of the aircraft.

Chen, R. T. N.↗
NASA NTRS1981

Influence of sideslip on the kinematics of the helicopter in steady coordinated turns

A steep coordinated helical turn at extreme angles of attack with inherent sideslip is of primary interest in this study. Unlike fixed-wing aircraft, the helicopter in a steady coordinated turn will inherently sideslip. A set of exact kinematic equations describing this motion in steady helical turns has been developed, and a rational definition for the load factor that best characterizes a coordinated turn for a helicopter has been proposed. An analysis has also been completed on the effects of sideslip on the kinematic relationships in a coordinated turn which is based on new closed-form solutions which relate the aircraft angular rates and pitch and roll attitudes to the turn parameters, angle of attack, and sideslip. The results show that the bank angle of the aircraft can differ markedly from the tilt angle of the normal load factor and that the normal load factor can also differ substantially from the accelerometer reading along the vertical body axis of the aircraft. Generally, sideslip has a strong influence on the pitch attitude and roll rate of the helicopter. The study also indicates that pitch rate is independent of angle of attack in a coordinated turn and that in the absence of sideslip, angular rates about the stability axes are independent of the aerodynamic characteristics of the aircraft.

Chen, R. T. N.↗
NASA NTRS1980

Selection of some rotor parameters to reduce pitch-roll coupling of helicopter flight dynamics

The results of a study conducted to investigate further a means of choosing primary rotor parameters to reduce the coupling of longitudinal and lateral flapping in hover and in forward flight are presented. The rotor parameters included - flapping hinge offset, flapping hinge restraint, pitch-flap coupling, and blade Lock number - are known to influence the agility, stability, and operational safety of helicopters. Effects of the nonuniform downwash model of White and Blake on the blade flapping motion are examined, and the theoretical calculation is then correlated with experimental test data. The condition for achieving perfect decoupling of the flapping response due to aircraft pitch and roll rates, which was previously obtained for a hovering rotor, is evaluated in forward flight. The results show that negligible coupling is achieved in forward flight; moreover, there is the additional benefit of a slight reduction in the coupling of the roll rate to coning. It is also indicated that the values of the rotor parameters chosen according to the decoupling condition are moderate and that the flapping motion is stable with the parameters chosen.

Chen, R. T. N.↗
NASA NTRS1980

Effects of rotor parameter variations on handling qualities of unaugmented helicopters in simulated terrain flight

A coordinated analysis and ground simulator experiment was performed to investigate the effects on single rotor helicopter handling qualities of systematic variations in the main rotor hinge restraint, hub hinge offset, pitch-flap coupling, and blade lock number. Teetering rotor, articulated rotor, and hingeless rotor helicopters were evaluated by research pilots in special low level flying tasks involving obstacle avoidance at 60 to 100 knots airspeed. The results of the experiment are in the form of pilot ratings, pilot commentary, and some objective performance measures. Criteria for damping and sensitivity are reexamined when combined with the additional factors of cross coupling due to pitch and roll rates, pitch coupling with collective pitch, and longitudinal static stability. Ratings obtained with and without motion are compared. Acceptable flying qualities were obtained within each rotor type by suitable adjustment of the hub parameters, however, pure teetering rotors were found to lack control power for the tasks. A limit for the coupling parameter L sub q/L sub p of 0.35 is suggested.

Talbot, P. D.↗
NASA NTRS1980

Effects of primary rotor parameters on flapping dynamics

The effects of flapping dynamics of four main rotor design features that influence the agility, stability, and operational safety of helicopters are studied. The parameters include flapping hinge offset, flapping hinge restraint, pitch-flap coupling, and blade lock number. First, the flapping equations of motion are derived that explicitly contain the design parameters. The dynamic equations are then developed for the tip-path plane, and the influence of individual and combined variations in the design parameters determined. The steady state flapping response is examined with respect to control input and aircraft angular rate which leads to a feedforward control law for control decoupling through cross feed, and a feedback control law to decouple the steady state flapping response. The condition for achieving perfect decoupling of the flapping response due to aircraft pitch and roll rates without using feedback control is also found for the hover case. It is indicated that the frequency of the regressing flapping mode of the rotor system can become low enough to require consideration in the assessment of handling characteristics.

Chen, R. T. N.↗
NASA NTRS1979

A simplified rotor system mathematical model for piloted flight dynamics simulation

The model was developed for real-time pilot-in-the-loop investigation of helicopter flying qualities. The mathematical model included the tip-path plane dynamics and several primary rotor design parameters, such as flapping hinge restraint, flapping hinge offset, blade Lock number, and pitch-flap coupling. The model was used in several exploratory studies of the flying qualities of helicopters with a variety of rotor systems. The basic assumptions used and the major steps involved in the development of the set of equations listed are described. The equations consisted of the tip-path plane dynamic equation, the equations for the main rotor forces and moments, and the equation for control phasing required to achieve decoupling in pitch and roll due to cyclic inputs.

Chen, R. T. N.↗