Engineering Papers⌕ Search

Engineering topics

Chen, P.

Publications and source records attributed to Chen, P..

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
DOE OSTI2018

Large quantum-spin-Hall gap in single-layer 1T' WSe 2

Two-dimensional (2D) topological insulators (TIs) are promising platforms for low-dissipation spintronic devices based on the quantum-spin-Hall (QSH) effect, but experimental realization of such systems with a large band gap suitable for room-temperature applications has proven difficult. Here, we report the successful growth on bilayer graphene of a quasi-freestanding WSe 2 single layer with the 1T' structure that does not exist in the bulk form of WSe 2 . Using angle-resolved photoemission spectroscopy (ARPES) and scanning tunneling microscopy/spectroscopy (STM/STS), we observe a gap of 129 meV in the 1T' layer and an in-gap edge state located near the layer boundary. The system's 2D TI characters are confirmed by first-principles calculations. The observed gap diminishes with doping by Rb adsorption, ultimately leading to an insulator-semimetal transition. The discovery of this large-gap 2D TI with a tunable band gap opens up opportunities for developing advanced nanoscale systems and quantum devices.

36 MATERIALS SCIENCE↗
DOE OSTI2017

The ultraviolet spectroscopic evolution of the low-luminosity tidal disruption event iPTF16fnl

In this work, we present the ultraviolet (UV) spectroscopic evolution of a tidal disruption event (TDE) for the first time. After the discovery of the nearby TDE iPTF16fnl, we obtained a series of observations with the Space Telescope Imaging Spectrograph (STIS) onboard the HubbleSpaceTelescope (HST). The dominant emission features closely resemble those seen in the UV spectra of the TDE ASASSN-14li and are also similar to those of N-rich quasars. There is evolution in the shape and central wavelength of the dominant emission features over the course of our observations, such that at early times the lines tend to be broad and redshifted, while at later times they are narrower and peak near the wavelengths of their atomic transitions. Like ASASSN-14li, but unlike N-rich quasars, iPTF16fnl shows neither Mg II 2798 Å nor C III] 1909 Å emission features. We also present optical photometry and spectroscopy, which suggest that the complex He II profiles observed in the optical spectra of many TDEs are in part due to the presence of N III and C III Wolf–Rayet features, which can potentially serve as probes of the far-UV when space-based observations are not possible. Finally, we use Swift X-ray Telescope and Ultraviolet/Optical Telescope (UVOT) observations to place strong limits on the X-ray emission and determine the characteristic temperature, radius and luminosity of the emitting material. Lastly, we find that iPTF16fnl is subluminous and evolves more rapidly than other optically discovered TDEs.

79 ASTRONOMY AND ASTROPHYSICS↗
DOE OSTI2017

Emergence of charge density waves and a pseudogap in single-layer TiTe 2

Two-dimensional materials constitute a promising platform for developing nanoscale devices and systems. Their physical properties can be very different from those of the corresponding three-dimensional materials because of extreme quantum confinement and dimensional reduction. Here in this paper we report a study of TiTe 2 from the single-layer to the bulk limit. Using angle-resolved photoemission spectroscopy and scanning tunneling microscopy and spectroscopy, we observed the emergence of a (2 × 2) charge density wave order in single-layer TiTe 2 with a transition temperature of 92 ± 3 K. Also observed was a pseudogap of about 28 meV at the Fermi level at 4.2 K. Surprisingly, no charge density wave transitions were observed in two-layer and multi-layer TiTe 2 , despite the quasi-two-dimensional nature of the material in the bulk. The unique charge density wave phenomenon in the single layer raises intriguing questions that challenge the prevailing thinking about the mechanisms of charge density wave formation.

36 MATERIALS SCIENCE↗
DOE OSTI2017

The laboratory environmental algae pond simulator (LEAPS) photobioreactor: Validation using outdoor pond cultures of Chlorella sorokiniana and Nannochloropsis salina

A bench-scale photobioreactor system, the Laboratory Environmental Algae Pond Simulator (LEAPS), was designed and constructed to simulate outdoor pond cultivation for a wide range of geographical locations and seasons. The LEAPS consists of six well-mixed glass column photobioreactors submerged in a temperature controlled waterbath (-2 °C to >60 °C) and illuminated from above by a programmable multicolor LED lighting system (0 to 2,500 µmol/m 2 -sec). Measured incident light intensities and water temperatures deviated from the respective light and temperature setpoints on average only 2.3% and 0.9%, demonstrating accurate simulation of light and temperature conditions measured in outdoor ponds. In order to determine whether microalgae strains cultured in the LEAPS exhibit the same linear phase biomass productivity as in outdoor ponds, Chlorella sorokiniana and Nannochloropsis salina were cultured in the LEAPS bioreactors using light and temperature scripts measured previously in the respective outdoor pond studies. For Chlorella sorokiniana, the summer season biomass productivity in the LEAPS was 6.6% and 11.3% lower than in the respective outdoor ponds in Rimrock, Arizona, and Delhi, California; however, these differences were not statistically significant. For Nannochloropsis salina, the winter season biomass productivity in the LEAPS was 9.2% higher than in the respective outdoor ponds in Tucson, Arizona, a difference shown to be not statistically significant. Potential reasons for the positive or negative divergence in LEAPS performance, relative to outdoor ponds, are discussed. To demonstrate the utility of the LEAPS in predicting productivity, two other strains – Scenedesmus obliquus and Stichococcus minor – were evaluated using the summer season script for Rimrock, Arizona. For both strains, the productivity was around 11.6 g/m 2 -day at 25 cm culture depth. In conclusion, the LEAPS is an accurate pond simulator and thus offers a reliable, fast, and cost-effective way to screen microalgae strains and operating conditions for high biomass productivity and co-product yields.

59 BASIC BIOLOGICAL SCIENCES↗
DOE OSTI2017

Pressure–Temperature Phase Diagram Reveals Spin–Lattice Interactions in Co[N(CN) 2 ] 2

Diamond anvil cell techniques, synchrotron-based infrared and Raman spectroscopies, and lattice dynamics calculations are combined with prior magnetic property work to reveal the pressure–temperature phase diagram of Co[N(CN)2]2. The second-order structural boundaries converge on key areas of activity involving the spin state exposing how the pressure-induced local lattice distortions trigger the ferromagnetic → antiferromagnetic transition in this quantum material.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2016

Hidden Order and Dimensional Crossover of the Charge Density Waves in TiSe 2

Charge density wave (CDW) formation, a key physics issue for materials, arises from interactions among electrons and phonons that can also lead to superconductivity and other competing or entangled phases. The prototypical system TiSe 2 , with a particularly simple (2 × 2 × 2) transition and no Kohn anomalies caused by electron-phonon coupling, is a fascinating but unsolved case after decades of research. Our angle-resolved photoemission measurements of the band structure as a function of temperature, aided by first-principles calculations, reveal a hitherto undetected but crucial feature: a (2 × 2) electronic order in each layer sets in at ~232 K before the widely recognized three-dimensional structural order at ~205 K. The dimensional crossover, likely a generic feature of such layered materials, involves renormalization of different band gaps in two stages.

36 MATERIALS SCIENCE↗
DOE OSTI2016

Dimensional Effects on the Charge Density Waves in Ultrathin Films of TiSe 2

Charge density wave (CDW) formation in solids is a critical phenomenon involving the collective reorganization of the electrons and atoms in the system into a wave structure, and it is expected to be sensitive to the geometric constraint of the system at the nanoscale. Here, we study the CDW transition in TiSe 2 , a quasi-two-dimensional layered material, to determine the effects of quantum confinement and changing dimensions in films ranging from a single layer to multilayers. Of key interest is the characteristic length scale for the transformation from a two-dimensional case to the three-dimensional limit. Angle-resolved photoemission (ARPES) measurements of films with thicknesses up to six layers reveal substantial variations in the energy structure of discrete quantum well states; however, the temperature-dependent band-gap renormalization converges at just three layers. The results indicate a layer-dependent mixture of two transition temperatures and a very-short-range CDW interaction within a three-dimensional framework.

36 MATERIALS SCIENCE↗