Engineering Papers⌕ Search

Engineering topics

Chen, Gang

Publications and source records attributed to Chen, Gang.

At least 235 records · Page 13

First-principles simulation of electron mean-free-path spectra and thermoelectric properties in silicon

The mean free paths (MFPs) of energy carriers are of critical importance to the nano-engineering of better thermoelectric materials. Despite significant progress in the first-principles–based understanding of the spectral distribution of phonon MFPs in recent years, the spectral distribution of electron MFPs remains unclear. We compute the energy-dependent electron scatterings and MFPs in silicon from first principles. The electrical conductivity accumulation with respect to electron MFPs is compared to that of the phonon thermal conductivity accumulation to illustrate the quantitative impact of nanostructuring on electron and phonon transport. By combining all electron and phonon transport properties from first principles, we predict the thermoelectric properties of the bulk and nanostructured silicon, and find that silicon with 20 nm nanograins can result in a higher than five times enhancement in their thermoelectric figure of merit as the grain boundaries scatter phonons more significantly than that of electrons due to their disparate MFP distributions.

36 MATERIALS SCIENCE↗

Enhancement of thermoelectric performance in n-type PbTe 1-y Se y by doping Cr and tuning Te:Se ratio

Lead telluride and its alloys have been extensively studied for medium temperature thermoelectric applications due to decent figure-of-merit (ZT) at temperature close to 900 K. However, little emphasis has been given to improve the ZT near room temperature. We report a systematic study of Cr doping in PbTe 1-y Se y with y=0, 0.25, 0.5, 0.75, 0.85, and 1. We found the peak ZT temperature increased with increasing concentration of Se. The highest ZT of ~0.6 at room temperature in Te-rich Cr 0.015 Pb 0.985 Te 0.75 Se 0.25 was obtained due to a lowered thermal conductivity and enhanced power factor resulted from high Seebeck coefficient of about -220 µV K -1 and high Hall mobility ~1120 cm 2 V -1 s -1 at room temperature. A room temperature ZT of ~0.5 and peak ZT of ~1 at about 573–673 K is shown by Se-rich sample Cr 0.01 Pb 0.99 Te 0.25 Se 0.75 . This improvement of the room temperature ZT improved the average ZT over a wide temperature range and could potentially lead to a single leg efficiency of thermoelectric conversion for Te-rich Cr 0.015 Pb 0.985 Te 0.75 Se 0.25 up to ~11% and Se-rich Cr 0.01 Pb 0.99 Te 0.25 Se 0.75 up to ~13% with cold side and hot side temperature at 300 K and 873 K, respectively, if matched with appropriate p-type legs.

42 ENGINEERING↗

Experimental study of the proposed super-thermal-conductor: BAs

Recent calculations predict a super-thermal-conductivity of ~2000 Wm -1 K -1 , comparable to that of diamond, in cubic boron arsenide (BAs) crystals, which may offer inexpensive insulators with super-thermal-conductivity for microelectronic device applications. We have synthesized and characterized here single crystals of BAs with a zinc blende cubic structure and lattice parameters of a = 4.7830(7) Å. A relatively high thermal conductivity of ~200 Wm -1 K -1 is obtained, close to those of best non-carbon crystal insulators, such as SiC, although still an order of magnitude smaller than the value predicted. Based on our XPS, X-ray single crystal diffraction, and Raman scattering results, steps to achieve the predicted super-thermal conductivity in BAs are proposed.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

15.7% Efficient 10-μm-Thick Crystalline Silicon Solar Cells Using Periodic Nanostructures

Only ten micrometer thick crystalline silicon solar cells deliver a short-circuit current of 34.5 mA cm -2 and power conversion efficiency of 15.7%. Here, the record performance for a crystalline silicon solar cell of such thinness is enabled by an advanced light-trapping design incorporating a 2D inverted pyramid photonic crystal and a rear dielectric/reflector stack.

14 SOLAR ENERGY↗

Hydrodynamic phonon transport in suspended graphene

Current reports of thermal transport in nanomaterials have demonstrated the breakdown of Fourier’s law through observations of ballistic transport. Despite its unique features, another instance of the breakdown of Fourier’s law, hydrodynamic phonon transport, has drawn less attention because it has been observed only at extremely low temperatures and narrow temperature ranges in bulk materials. Here, we predict on the basis of first-principles calculations that the hydrodynamic phonon transport can occur in suspended graphene at significantly higher temperatures and wider temperature ranges than in bulk materials. The hydrodynamic transport is demonstrated through drift motion of phonons, phonon Poiseuille flow and second sound. The significant hydrodynamic phonon transport in graphene is associated with graphene’s two-dimensional features. This research opens a new avenue for understanding and manipulating heat flow in two-dimensional materials.

36 MATERIALS SCIENCE↗

Status Report of the DPHEP Collaboration: A Global Effort for Sustainable Data Preservation in High Energy Physics

Data from High Energy Physics (HEP) experiments are collected with significant financial and human effort and are mostly unique. An inter-experimental study group on HEP data preservation and long-term analysis was convened as a panel of the International Committee for Future Accelerators (ICFA). The group was formed by large collider-based experiments and investigated the technical and organizational aspects of HEP data preservation. An intermediate report was released in November 2009 addressing the general issues of data preservation in HEP and an extended blueprint paper was published in 2012. In July 2014 the DPHEP collaboration was formed as a result of the signature of the Collaboration Agreement by seven large funding agencies (others have since joined or are in the process of acquisition) and in June 2015 the first DPHEP Collaboration Workshop and Collaboration Board meeting took place. This status report of the DPHEP collaboration details the progress during the period from 2013 to 2015 inclusive.

Amerio, Silvia↗

Thermal Interface Conductance Between Aluminum and Silicon by Molecular Dynamics Simulations

The thermal interface conductance between Al and Si was simulated by a non-equilibrium molecular dynamics method. In the simulations, the coupling between electrons and phonons in Al are considered by using a stochastic force. The findings demonstrate the size dependence of the interface thermal conductance and the effect of electron–phonon coupling on the interface thermal conductance. To understand the mechanism of interface resistance, the vibration power spectra are calculated. We postulate that the atomic level disorder near the interface is an important aspect of interfacial phonon transport, which leads to a modification of the phonon states near the interface. There, the vibrational spectrum near the interface greatly differs from the bulk. This change in the vibrational spectrum affects the results predicted by AMM and DMM theories and indicates new physics is involved with phonon transport across interfaces.

42 ENGINEERING↗

Enhancement of Thermoelectric Performance of n-Type PbSe by Cr Doping with Optimized Carrier Concentration

Ti, V, Cr, Nb, and Mo are found to be effective at increasing the Seebeck coefficient and power factor of n-type PbSe at temperatures below 600 K. It is found that the higher Seebeck coefficients and power factors are due to higher Hall mobility ≈1000 cm 2 V -1 s -1 at lower carrier concentration. A larger average ZT value (relevant for applications) can be obtained by an optimization of carrier concentration to ≈10 18 -10 19 cm -3 . Even though the highest room temperature power factor ≈3.3 × 10 -3 W m -1 K -2 is found in 1 at% Mo-doped PbSe, the highest ZT is achieved in Cr-doped PbSe. Combined with the lower thermal conductivity, ZT is improved to ≈0.4 at room temperature and peak ZTs of ≈1.0 are observed at ≈573 K for Pb 0.9925 Cr 0.0075 Se and ≈673 K for Pb 0.995 Cr 0.005 Se. Finally, the calculated device efficiency of Pb 0.995 Cr 0.005 Se is as high as ≈12.5% with cold side 300 K and hot side 873 K, higher than those of all the n-type PbSe materials reported in the literature.

36 MATERIALS SCIENCE↗

Electrically tunable near-field radiative heat transfer via ferroelectric materials

We explore ways to actively control near-field radiative heat transfer between two surfaces that relies on electrical tuning of phonon modes of ferroelectric materials. Ferroelectrics are widely used for tunable electrical devices, such as capacitors and memory devices; however, their tunable properties have not yet been examined for heat transfer applications. We show via simulations that radiative heat transfer between two ferroelectric materials can be enhanced by over two orders of magnitude over the blackbody limit in the near field, and can be tuned as much as 16.5% by modulating the coupling between surface phonon polariton modes at the two surfaces via varying external electric fields. We then discuss how to maximize the modulation contrast for tunable thermal devices using the studied mechanism.

75 CONDENSED MATTER PHYSICS, SUPERCONDUCTIVITY AND↗

Examining thermal transport through a frequency-domain representation of time-domain thermoreflectance data

Laser-based time-domain thermoreflectance (TDTR) and frequency-domain thermoreflectance (FDTR) techniques are widely used for investigating thermal transport at micro- and nano-scales. We demonstrate that data obtained in TDTR measurements can be represented in a frequency-domain form equivalent to FDTR, i.e., in the form of a surface temperature amplitude and phase response to time-harmonic heating. Such a representation is made possible by using a large TDTR delay time window covering the entire pulse repetition interval. We demonstrate the extraction of frequency-domain data up to 1 GHz from TDTR measurements on a sapphire sample coated with a thin layer of aluminum, and show that the frequency dependencies of both the amplitude and phase responses agree well with theory. The proposed method not only allows a direct comparison of TDTR and FDTR data, but also enables measurements at high frequencies currently not accessible to FDTR. The frequency-domain representation helps uncover aspects of the measurement physics which remain obscured in a traditional TDTR measurement, such as the importance of modeling the details of the heat transport in the metal transducer film for analyzing high frequency responses.

47 OTHER INSTRUMENTATION↗

Thermoelectric Skutterudite Compositions and Methods for Producing the Same

Compositions related to skutterudite-based thermoelectric materials are disclosed. Such compositions can result in materials that have enhanced ZT values relative to one or more bulk materials from which the compositions are derived. Thermoelectric materials such as n-type and p-type skutterudites with high thermoelectric figures-of-merit can include materials with filler atoms and/or materials formed by compacting particles (e.g., nanoparticles) into a material with a plurality of grains each having a portion having a skutterudite-based structure. Methods of forming thermoelectric skutterudites, which can include the use of hot press processes to consolidate particles, are also disclosed. The particles to be consolidated can be derived from (e.g., grinded from), skutterudite-based bulk materials, elemental materials, other non-Skutterudite-based materials, or combinations of such materials.

Ren, Zhifeng↗

Thermoelectric skutterudite compositions and methods for producing the same

Compositions related to skutterudite-based thermoelectric materials are disclosed. Such compositions can result in materials that have enhanced ZT values relative to one or more bulk materials from which the compositions are derived. Thermoelectric materials such as n-type and p-type skutterudites with high thermoelectric figures-of-merit can include materials with filler atoms and/or materials formed by compacting particles (e.g., nanoparticles) into a material with a plurality of grains each having a portion having a skutterudite-based structure. Methods of forming thermoelectric skutterudites, which can include the use of hot press processes to consolidate particles, are also disclosed. The particles to be consolidated can be derived from (e.g., grinded from), skutterudite-based bulk materials, elemental materials, other non-Skutterudite-based materials, or combinations of such materials.

36 MATERIALS SCIENCE↗