Engineering Papers⌕ Search

Engineering topics

Chen, F. R.

Publications and source records attributed to Chen, F. R..

Dual heterogeneous structures lead to ultrahigh strength and uniform ductility in a Co-Cr-Ni medium-entropy alloy

Alloys with ultra-high strength and sufficient ductility are highly desired for modern engineering applications but difficult to develop. Here we report that, by a careful controlling alloy composition, thermomechanical process, and microstructural feature, a Co-Cr-Ni-based medium-entropy alloy (MEA) with a dual heterogeneous structure of both matrix and precipitates can be designed to provide an ultra-high tensile strength of 2.2 GPa and uniform elongation of 13% at ambient temperature, properties that are much improved over their counterparts without the heterogeneous structure. Electron microscopy characterizations reveal that the dual heterogeneous structures are composed of a heterogeneous matrix with both coarse grains (10~30 μm) and ultra-fine grains (0.5~2 μm), together with heterogeneous L1 2 -structured nanoprecipitates ranging from several to hundreds of nanometers. The heterogeneous L1 2 nanoprecipitates are fully coherent with the matrix, minimizing the elastic misfit strain of interfaces, relieving the stress concentration during deformation, and playing an active role in enhanced ductility.

36 MATERIALS SCIENCE↗

Atomic configuration of irradiation-induced planar defects in 3C-SiC

The atomic configuration of irradiation-induced planar defects in single crystal 3C-SiC at high irradiation temperatures was shown in this research. A spherical aberration corrected scanning transmission electron microscope provided images of individual silicon and carbon atoms by the annular bright-field (ABF) method. Two types of irradiation-induced planar defects were observed in the ABF images including the extrinsic stacking fault loop with two offset Si-C bilayers and the intrinsic stacking fault loop with one offset Si-C bilayer. The results are in good agreement with images simulated under identical conditions.

36 MATERIALS SCIENCE↗

SiC/SiC Composites Irradiation Behaviour in Fusion Reactor Environment Conditions

We developed a new method to quantify the He atoms in the SiC/SiC Composites Irradiation Behaviour in Fusion Reactor Environment Conditions. We focus on the cavities measurements of the energy shift of the He K-edge of the electron energy loss spectrum. The method is based on mapping the density of He atoms inside the measured bubbles. Combining with the number density and the average diameter of the cavities, we are able to distinguish and estimate the amount of He atoms in the cavities and in the matrix, respectively. We found that small bubbles contain much higher density of He atoms than the larger ones. At irradiation temperature above 1000oC, all the He atoms are trapped inside the bubbles. On the contrary, it is not the case at the lower irradiation temperature.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

Satellite-Sensor Calibration Verification Using the Cloud-Shadow Method

An atmospheric-correction method which uses cloud-shaded pixels together with pixels in a neighboring region of similar optical properties is described. This cloud-shadow method uses the difference between the total radiance values observed at the sensor for these two regions, thus removing the nearly identical atmospheric radiance contributions to the two signals (e.g. path radiance and Fresnel-reflected skylight). What remains is largely due to solar photons backscattered from beneath the sea to dominate the residual signal. Normalization by the direct solar irradiance reaching the sea surface and correction for some second-order effects provides the remote-sensing reflectance of the ocean at the location of the neighbor region, providing a known 'ground target' spectrum for use in testing the calibration of the sensor. A similar approach may be useful for land targets if horizontal homogeneity of scene reflectance exists about the shadow. Monte Carlo calculations have been used to correct for adjacency effects and to estimate the differences in the skylight reaching the shadowed and neighbor pixels.

Reinersman, P.↗