Engineering Papers⌕ Search

Engineering topics

Chelluri, Bhanumathi

Publications and source records attributed to Chelluri, Bhanumathi.

Advanced Motors

Transportation energy usage is predicted to increase substantially by 2020. Hybrid vehicles and fuel cell powered vehicles are destined to become more prominent as fuel prices rise with the demand. Hybrid and fuel cell vehicle platforms are both dependent on high performance electric motors. Electric motors for transportation duty will require sizeable low-speed torque to accelerate the vehicle. As motor speed increases, the torque requirement decreases which results in a nearly constant power motor output.

33 ADVANCED PROPULSION SYSTEMS↗

Lightweight Aluminum/Nano composites for Automotive Drive Train Applications

During Phase I, we successfully processed air atomized aluminum powders via Dynamic Magnetic Compaction (DMC) pressing and subsequent sintering to produce parts with properties similar to wrought aluminum. We have also showed for the first time that aluminum powders can be processed without lubes via press and sintering to 100 % density. This will preclude a delube cycle in sintering and promote environmentally friendly P/M processing. Processing aluminum powders via press and sintering with minimum shrinkage will enable net shape fabrication. Aluminum powders processed via a conventional powder metallurgy process produce too large a shrinkage. Because of this, sinter parts have to be machined into specific net shape. This results in increased scrap and cost. Fully sintered aluminum alloy under this Phase I project has shown good particle-to-particle bonding and mechanical properties. We have also shown the feasibility of preparing nano composite powders and processing via pressing and sintering. This was accomplished by dispersing nano silicon carbide (SiC) powders into aluminum matrix comprising micron-sized powders (<100 microns) using a proprietary process. These composite powders of Al with nano SiC were processed using DMC press and sinter process to sinter density of 85-90%. The process optimization along with sintering needs to be carried out to produce full density composites.

32 ENERGY CONSERVATION, CONSUMPTION, AND UTILIZATI↗

High Performance PrFeB Permanent Magnets through Novel Pulse Alignment and Compaction Method for Cryogenic Permanent Magnet Undulators (CPMU)

The Phase I feasibility results of processing PrFeB magnets have shown highly promising magnetic property results with the potential to equal or exceed the best PrFeB properties reported. These findings will be advanced in Phase II through composition tuning, optimization of powder alignment from 95% to > 98%, sintering and heat treat adjustments. The objectives of Phase I were successfully achieved during Phase I work. These were to produce PrFeB magnets and test to establish a baseline process including material chemistry, alloy milling to 3 microns, compaction with domain alignment, and liquid Phase sintering and annealing – under both thermal and vacuum cycles. Success of proper chemistry and processing is determined by the finished magnet density and magnetic performance. A density of 7.45 +/-0.03 g/cm3 has been established as demonstrating full density.

36 MATERIALS SCIENCE↗