Engineering Papers⌕ Search

Engineering topics

Chaussee, D. S.

Publications and source records attributed to Chaussee, D. S..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1988

A computational study of heat transfer for laminar hypervelocity flows

Computational Fluid Dynamics (CFD) codes are routinely used to predict the flowfield and the heating environment around complex reentry configurations. At hypervelocities, where the velocity is greater than 3 km/sec, the AFWAL version of the blunt body code predicts the correct surface pressure distributions but underpredicts laminar wall heat fluxes. This study was performed to determine the reasons for the underprediction. The computer code chosen solves thin-layer Navier-Stokes equations in a time-asymptotic manner and assumes a constant isentropic exponent. Flowfields around a spherical configuration at various entry velocities are computed. The computed pressure distributions agree well with the tabulated, inviscid results of Lyubimov and Rusanov for entry velocities ranging from 0.6 to 5.92 km/sec. At hypervelocities, the calculated stagnation point heat transfer rates were lower by roughly fifty percent when compared to engineering correlations available in the literature. Good comparisons between heat transfer rates are obtained at hypervelocity entry conditions provided the CFD code is modified to include equilibrium air properties.

Balakrishnan, A.↗
NASA NTRS1986

An upwind algorithm for the parabolized Navier-Stokes equations

A new upwind algorithm based on Roe's scheme has been developed to solve the two-dimensional parabolized Navier-Stokes (PNS) equations. This method does not require the addition of user specified smoothing terms for the capture of discontinuities such as shock waves. Thus, the method is easy to use and can be applied without modification to a wide variety of supersonic flowfields. The advantages and disadvantages of this adaptation are discussed in relation to those of the conventional Beam-Warming scheme in terms of accuracy, stability, computer time and storage, and programming effort. The new algorithm has been validated by applying it to three laminar test cases including flat plate boundary-layer flow, hypersonic flow past a 15 deg compression corner, and hypersonic flow into a converging inlet. The computed results compare well with experiment and show a dramatic improvement in the resolution of flowfield details when compared with the results obtained using the conventional Beam-Warming algorithm.

Lawrence, S. L.↗
NASA NTRS1986

High speed viscous flow calculations about complex configurations

Applications of the NASA Ames Parabolized Navier-Stokes (PNS) code to a variety of complex generic configurations is presented. The algorithm, boundary conditions, initial conditions, and grid generators are discussed as applied to these configurations. The PNS code was used as the mainline procedure to numerically simulate the viscous supersonic flow over these generic configurations. The turbulence model that was used in this study is the Baldwin-Lomax model. The boundary conditions are the usual viscous no slip at the wall, and a characteristic procedure is used to fit the bow shock wave which is the outermost boundary. An elliptic grid generator is employed to discretize the flow domain. In addition, an equilibrium air capability has been incorporated into the code. It uses the curve fits of Tannehill, et al. The flow regimes vary from a Mach number of 2 up to 25. Both laminar and turbulent flow are considered. Varying angles of attack have also been computed. Configurations vary from simple cone-type bodies to lifting winged bodies, such as the space shuttle or the generic supersonic cruise fighter.

Chaussee, D. S.↗
NASA NTRS1985

Numerical simulation of viscous supersonic flow over a generic fighter configuration

A procedure is presented, as well as some results, to calculate the flow over a generic fighter configuration. A parabolized marching Navier-Stokes code is used to obtain the solution over a wing-canopy body. The flow conditions simulate supersonic cruise with a freestream Mach number of 2.169 and angles of attack of 4 and 10 deg. The body surface is considered to be an adiabatic wall and the flow is assumed to be turbulent for the given Reynolds number.

Chaussee, D. S.↗
NASA NTRS1985

Use of a hyperbolic grid generation scheme in simulating supersonic viscous flow about three-dimensional winged configuration

The present paper describes a numerical mesh generation technique to be used with an implicit finite difference method for simulating visous supersonic flow about low-aspect-ratio wing body configurations using a single grid strategy. The computational domain is segmented into multiple regions, with borders located in supersonic areas to avoid the otherwise costly interfacing procedure between adjacent segments. The numerical procedure is applied to calculate the turbulent flow around the shuttle orbiter and a canard projectile at supersonic free stream Mach number.

Rizk, Y. M.↗
NASA NTRS1985

A comparative study of the parabolized Navier-Stokes code using various grid-generation techniques

The parabolized Navier-Stokes (PNS) equations are used to calculate the flow-field characteristics about the hypersonic research aircraft X-24C. A comparison of the results obtained using elliptic, hyperbolic and algebraic grid generators is presented. The outer bow shock is treated as a sharp discontinuity, and the discontinuities within the shock layer are captured. Surface pressures and heat-transfer results at angles of attack of 6 deg and 20 deg, obtained using the three grid generators, are compared. The PNS equations are marched downstream over the body in both Cartesian and cylindrical base coordinate systems, and the results are compared. A robust marching procedure is demonstrated by successfully using large marching-step sizes with the implicit shock fitting procedure. A correlation is found between the marching-step size, Reynolds number and the angle of attack at fixed values of smoothing and stability coefficients for the marching scheme.

Kaul, U. K.↗
NASA NTRS1984

Viscous computation of a space shuttle flow field

A procedure is presented, as well as some results, to calculate the flow over the winged orbiter. This necessitates the use of two computer codes. A parabolized marching Navier-Stokes code is used to obtain the solution up to the bow shock-wing shock interaction region and for the region after the interaction. An unsteady Navier-Stokes code is to be used in the region of the shock interaction. Only resuls for the marching code are presented. For the flow conditions calculated, M infinity = 7.9, alpha = 25 deg, T(wall) = 540 R, Re(L) = 60728 per inch, laminar or turbulent, the PNS code was marched up to an X/L = 0.7 which is where the bow shock-wing shock interaction region occurs.

Chaussee, D. S.↗
NASA NTRS1984

Application of the implicit MacCormack scheme to the parabolized Navier-Stokes equations

MacCormack's implicit finite-difference scheme was used to solve the two-dimensional parabolized Navier-Stokes (PNS) equations. This method for solving the PNS equations does not require the inversion of block tridiagonal systems of algebraic equations and permits the original explicit MacCormack scheme to be employed in those regions where implicit treatment is not needed. The advantages and disadvantages of the present adaptation are discussed in relation to those of the conventional Beam-Warming scheme for a flat plate boundary layer test case. Comparisons are made for accuracy, stability, computer time, computer storage, and ease of implementation. The present method was also applied to a second test case of hypersonic laminar flow over a 15% compression corner. The computed results compare favorably with experiment and a numerical solution of the complete Navier-Stokes equations.

Lawrence, J. L.↗
NASA NTRS1984

A comparative study of the parabolized Navier-Stokes code using various grid-generation techniques

The parabolized Navier-Stokes (PNS) equations are used to calculate the flow-field characteristics about the hypersonic research aircraft X-24C. A comparison of the results obtained using elliptic, hyperbolic, and algebraic grid generators is presented. The outer bow shock is treated as a sharp discontinuity, and the discontinuities within the shock layer are captured. Surface pressures and heat-transfer results at angles of attack of 6 deg and 20 deg, obtained using the three grid generators, are compared. The PNS equations are marched downstream over the body in both Cartesian and cylindrical base coordinate systems, and the results are compared. A robust marching procedure is demonstrated by successfully using large marching step sizes with the implicit shock fitting procedure. A correlation is found between the marching step size, Reynolds number, and the angle of attack at fixed values of smoothing and stability coefficients for the marching scheme.

Kaul, U. K.↗
NASA NTRS1984

Approximate-factorization algorithms - Theory and applications in viscous-flow computations

A systematic development of implicit approximate-factorization algorithms in delta form for both unsteady and steady viscous flow is presented. The algorithms are cast in conservation-law form and simplified by using a thin-layer approximation to the governing equations. The implementation of implicit surface viscous boundary conditions is discussed in detail, and an example is presented illustrating the advantage of using the implicit boundary conditions. Three-dimensional results from the steady form of the algorithm are presented and compared with experimental data.

Chaussee, D. S.↗
NASA NTRS1983

Calculation of viscous supersonic flows over finned bodies

The parabolized Navier-Stokes (PNS) equations are used to calculate the viscous, supersonic flow fields about a six-finned projectile and a generic four-finned missile at angles of attack. Since current computer speeds and storage preclude a fully three-dimensional calculation using the unsteady, Reynolds-averaged, Navier-Stokes equations, the applicability of the PNS equations to the above flow fields is of considerable interest. Two important aspects of the calculation are grid generation and the type of smoothing used to prevent nonphysical solutions. This paper includes a description of the grid-generation process. Results in the form of density contours and velocity vector plots are presented for the two configurations. The applicability of the PNS equations to the complicated flow fields considered is successfully demonstrated.

Rai, M. M.↗
NASA NTRS1983

Convair 990 transonic flow-field simulation about the forward fuselage

A three-dimensional, viscous flow code was used to calculate the transonic flow about the forebody of the Convair CV-990 (Galileo II) research aircraft stationed at NASA Ames Research Center. The computations were used to determine the location for a differential pressure system. In addition, attitude sensor placements were verified. These instruments comprise a meteorological measurement system, which will be used for global determination of three-dimensional wind data. The code solves the thin layer form of the Reynolds-averaged Navier-Stokes equations using an implicit numerical procedure. The governing equations are written in a generalized, nonorthogonal coordinate system, and are cast in a strong conservation law form. Laminar boundary layer results are presented for free stream Mach number of 0.8 and angles of attack of zero and 2 deg. Use of this computational tool reduced the development time for the location of the sensors and aided in the optimal placement on the aircraft of these devices.

Chaussee, D. S.↗
NASA NTRS1983

User's manual for three-dimensional analysis of propeller flow fields

A detailed operating manual is presented for the prop-fan computer code (in addition to supporting programs) recently developed by Kutler, Chaussee, Sorenson, and Pulliam while at the NASA'S Ames Research Center. This code solves the inviscid Euler equations using an implicit numerical procedure developed by Beam and Warming of Ames. A description of the underlying theory, numerical techniques, and boundary conditions with equations, formulas, and methods for the mesh generation program (MGP), three dimensional prop-fan flow field program (3DPFP), and data reduction program (DRP) is provided, together with complete operating instructions. In addition, a programmer's manual is also provided to assist the user interested in modifying the codes. Included in the programmer's manual for each program is a description of the input and output variables, flow charts, program listings, sample input and output data, and operating hints.

Chaussee, D. S.↗
NASA NTRS1983

Prediction of high speed propeller flow fields using a three-dimensional Euler analysis

To overcome the limitations of classical propeller theory, a computer program, NASPROP-E, was developed which solves for the flow field surrounding a multibladed propeller and axisymmetric nacelle combination using a finite difference method. The governing equations are the three dimensional unsteady Euler equations written in a cylindrical coordinate system. They are marched in time until a steady state solution is obtained. The Euler equations require no special treatment to model the blade work vorticity. The equations are solved using an implicit approximate factorization method. Numerical results are presented which have greatly increased the understanding of high speed propeller flow fields. Numerical results for swirl angle downstream of the propeller and propeller power coefficient are higher than experimental results. The radial variation of coefficient are higher than experimental results. The radial variation of swirl angle, however, is in reasonable agreement with the experimental results. The predicted variation of power coefficient with blade angle agrees very well with data.

Bober, L. J.↗
NASA NTRS1983

New implicit boundary procedures - Theory and applications

Analytical techniques for the application of implicit boundary conditions for inviscid flows to shock and body boundary layer conditions involving the Euler equations are presented. The theory of characteristics is used to update boundary points with spatial second order accuracy. The method is useful for implicit schemes which feature approximate factorization, and as such is incorporated into an existing PNS code. Examples are provided in terms of flows over a cone, over a maneuverable reentry vehicle, and over a finned vehicle. Improvements in the convergence rate are demonstrated for the conical flow solutions.

Rai, M. M.↗