Engineering Papers⌕ Search

Engineering topics

Chapman, G. T.

Publications and source records attributed to Chapman, G. T..

At least 37 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Investigation of the asymmetric aerodynamic characteristics of cylindrical bodies of revolution with variations in nose geometry and rotational orientation at angles of attack to 58 degrees and Mach numbers to 2

Wind-tunnel tests were conducted to investigate the side forces and yawing moments that can occur at high angles of attack and zero sideslip for cylindrical bodies of revolution. Two bodies having several tangent ogive forebodies with fineness ratios of 0.5, 1.5, 2.5, and 3.5 were tested. The forebodies with fineness ratios of 2.5 and 3.5 had several bluntnesses. The cylindrical afterbodies had fineness ratios of 7 and 13. The model components - tip, forebody, and afterbody - were tested in various rotational positions about their axes of symmetry. Most of the tests were conducted at a Mach number of 0.25, a Reynolds number of 0.32 x 10 to the 6th power, and with the afterbody that had a fineness ratio of 7 and with selected forebodies. The effect of Mach number was determined with the afterbody that had a fineness ratio of 13 and with selected forebodies at mach numbers from 0.25 to 2 at Reynolds number = 0.32 X 10 to the 6th power. Maximum angle of attack was 58 deg.

Kruse, R. L.↗
NASA NTRS1979

Overview of two-dimensional airfoil research at Ames Research Center

The five basic elements of the two dimensional airfoil research program at Ames Research Center are illustrated. These elements are experimental, theoretical (including computational), validation, design optimization, and industry interaction. Each area is briefly discussed.

Chapman, G. T.↗
NASA NTRS1978

Application of shock tubes to transonic airfoil testing at high Reynolds numbers

Performance analysis of a gas-driven shock tube shows that transonic airfoil flows with chord Reynolds numbers of the order of 100 million can be produced, with limitations being imposed by the structural integrity of the facility or the model. A study of flow development over a simple circular arc airfoil at zero angle of attack was carried out in a shock tube at low and intermediate Reynolds numbers to assess the testing technique. Results obtained from schlieren photography and airfoil pressure measurements show that steady transonic flows similar to those produced for the same airfoil in a wind tunnel can be generated within the available testing time in a shock tube with properly contoured test section walls.

Cook, W. J.↗
NASA NTRS1978

The shock tube as a device for testing transonic airfoils at high Reynolds numbers

A performance analysis of gas-driven shock tubes shows that transonic airfoil flows with chord Reynolds numbers in the range of 100 million can be generated behind the primary shock in a large shock tube. A study of flow over simple airfoils has been carried out at low and intermediate Reynolds numbers to assess the testing technique. Results obtained from schlieren photos and airfoil pressure measurements show that steady transonic flows similar to those observed for the airfoils in wind tunnels can be generated within the available testing time in a shock tube with either properly-contoured test section walls or a properly-designed slotted-wall test section. The study indicates that the shock tube is a useful facility for studying two-dimensional high Reynolds number transonic airfoil flows.

Cook, W. J.↗
NASA NTRS1977

Side forces on a tangent ogive forebody with a fineness ratio of 3.5 at high angles of attack and Mach numbers from 0.1 to 0.7

An experimental investigation was conducted in the Ames 12-Foot Wind Tunnel to determine the subsonic aerodynamic characteristics, at high angles of attack, of a tangent ogive forebody with a fineness ratio of 3.5. The investigation included the effects of nose bluntness, nose strakes, nose booms, a simulated canopy, and boundary-layer trips. The forebody was also tested with a short afterbody attached. Static longitudinal and lateral-directional stability data were obtained at Reynolds numbers ranging from 0.3 mil. to 3.8 mil. (based on base diameter) at a Mach number of 0.25, and at a Reynolds number of 0.8 mil. at Mach numbers ranging from 0.1 to 0.7. Angle of attack was varied from 0 to 88 deg at zero sideslip, and the sideslip angle was varied from -10 to 30 deg at angles of attack of 40, 55, and 70 deg.

Keener, E. R.↗
NASA NTRS1977

Side forces on forebodies at high angles of attack and Mach numbers from 0.1 to 0.7: two tangent ogives, paraboloid and cone

An experimental investigation was conducted in the Ames 12-Foot Wind Tunnel to determine the subsonic aerodynamic characteristics of four forebodies at high angles of attack. The forebodies tested were a tangent ogive with fineness ratio of 5, a paraboloid with fineness ratio of 3.5, a 20 deg cone, and a tangent ogive with an elliptic cross section. The investigation included the effects of nose bluntness and boundary-layer trips. The tangent-ogive forebody was also tested in the presence of a short afterbody and with the afterbody attached. Static longitudinal and lateral/directional stability data were obtained. The investigation was conducted to investigate the existence of large side forces and yawing moments at high angles of attack and zero sideslip. It was found that all of the forebodies experience steady side forces that start at angles of attack of from 20 deg to 35 deg and exist to as high as 80 deg, depending on forebody shape. The side is as large as 1.6 times the normal force and is generally repeatable with increasing and decreasing angle of attack and, also, from test to test. The side force is very sensitive to the nature of the boundary layer, as indicated by large changes with boundary trips. The maximum side force caries considerably with Reynolds number and tends to decrease with increasing Mach number. The direction of the side force is sensitive to the body geometry near the nose. The angle of attack of onset of side force is not strongly influenced by Reynolds number or Mach number but varies with forebody shape. Maximum normal force often occurs at angles of attack near 60 deg. The effect of the elliptic cross section is to reduce the angle of onset by about 10 deg compared to that of an equivalent circular forebody with the same fineness ratio. The short afterbody reduces the angle of onset by about 5 deg.

Keener, E. R.↗
NASA NTRS1977

A subsonic flow investigation on a research body at high angles of attack

Tests conducted in the Ames 12-foot pressure wind tunnel on a rotating research body at angles of attack of 45 to 90 deg yielded results that were inconsistent with simple cross-flow theory. Consequently, force and pressure distribution tests along with oil and sublimation flow-visualization studies were conducted in the same tunnel on a nonrotating model to attempt to explain the behavior observed in the rotary tests. These studies indicate that at appropriate conditions of Reynolds number and angle of attack, inflectional instabilities occur in the boundary layer that materially affect separation and, hence, the aerodynamic forces. Calculations of cross-flow Reynolds numbers are made and compared with other works on inflectional instability.

Clarkson, M. H.↗
NASA NTRS1976

Asymmetric aerodynamic forces on aircraft at high angles of attack - some design guides

Aerodynamic side forces on forebodies are considered that are produced by two types of flow: asymmetric vortices on bodies of revolution and nonuniform flow separation on square bodies with rounded corners under spinning conditions. Steady side forces that can be as large as the normal force are produced by asymmetric vortices on pointed forebodies. This side force has a large variation with Reynolds number, decreases rapidly with Mach number, and can be nearly eliminated with small nose bluntness or strakes. The angle of attack where the side force first occurs depends primarily on body geometry. The theoretical techniques to predict these side forces are necessarily semi-empirical because the basic phenomenon is not well understood. The side forces produced by nonuniform flow separation under spinning conditions depend extensively on spin rate, angle of attack, and Reynolds number. The application of simple crossflow theory to predict this side force is inadequate much below angles of attack of 90 deg.

Chapman, G. T.↗
NASA NTRS1976

Effects of Mach number and afterbody length on aerodynamic side forces at zero sideslip on symmetric bodies at high angles of attack

Wind-tunnel measurements of side force over the Mach number range of 0.25 to 2 for pointed forebody-alone and for ogive-cylinder models of various fineness ratios up to 16, are presented. The angle of attack where side force first occurs (onset), where it returns to zero (upper limit), and its magnitude are examined. The onset angle depends only on body geometry, longer bodies having lower onset angles. The upper limit, which is about 80 deg at M = 0.25, decreases with Mach number. The maximum side forces decrease with increasing Mach number, approaching zero within the Mach number range of 0.8 to 1.2; within this range, the Mach number at which the forces approach zero varies directly with forebody slenderness.

Keener, E. R.↗
NASA NTRS1975

Experimental determination of post-stall rotary derivatives for airplane-like configurations at several Reynolds numbers

Military and civilian airplane losses due to out-of-control spin motions are significant. Knowledge of rotary coefficients is necessary to understand the cause of spin entry and to devise proper recovery techniques. An exploratory wind-tunnel investigation has been conducted on simple airplane-like configurations on a rotary sting apparatus at rotation rates up to 10 rps. Rotary coefficients have been measured at unit Reynolds numbers from 2,000,000 to 24,600,000 per m and at angles of attack from 45 to 90 deg. Results show that the aerodynamic characteristics at steady spin rates are highly dependent on both spin rate and Reynolds number.

Clarkson, M. H.↗
NASA NTRS1975

Use of shock tubes in high Reynolds number transonic testing

The shock tube as a device to fulfill current needs for testing of transonic airfoils at high Reynolds numbers is considered. Performance analysis of a gas-driven shock tube shows that transonic airfoil flows with chord Reynolds numbers in the range of 100 million can be produced. A study of flow development over a simple airfoil has been carried out in a shock tube at low and intermediate Reynolds numbers to assess the testing technique. Results obtained from schlieren photography and airfoil pressure measurements show that steady transonic flows similar to those produced for the same airfoil in a wind tunnel can be generated within the available testing time in a shock tube with properly contoured test section walls. The study indicates that the shock tube is a viable alternative as a facility for studying high Reynolds number transonic airfoil flows.

Cook, W. J.↗
NASA NTRS1974

Onset of aerodynamic side forces at zero sideslip on symmetric forebodies at high angles of attack

Selected results are presented from extensive wind-tunnel tests that include variations in axial and cross-sectional shape, fineness ratio, bluntness, strakes, and boundary-layer trips over a wide range of conditions (angles of attack to 90 deg, angles of sideslip to 30 deg, Reynolds numbers from subcritical to supercritical, and Mach numbers from 0.1 to 0.7). Pointed forebodies at zero sideslip can experience side forces as large as maximum normal forces. The angle of attack at the onset of side force can be correlated with nose angle and afterbody length. Furthermore, these side forces can be reduced or eliminated by bluntness or nose strakes.

Keener, E. R.↗
NASA NTRS1973

Theory for radiatively driven harmonic acoustic waves in a confined gas.

A detailed theoretical study is made of radiatively driven acoustic waves inside a closed cylindrical tube. The formulation accounts for all the essential phenomena for a gas in vibrational equilibrium - namely, gas motion, longitudinal and radial viscous dissipation, longitudinal and radial heat conduction, and radiative transfer with spectral detail included. An approximate expression is derived for the pressure response. This solution is applicable to arbitrary spectral distribution of the radiative absorption coefficient, under conditions attainable in the laboratory. The solution includes both tuned and untuned acoustic conditions as well as the spectrophone limit - that is, the condition where the length of the tube is much smaller than the length of the acoustic wave. The influence of spectral detail on the pressure response is illustrated.

Chapman, G. T.↗
NASA NTRS1973

Experiments on radiatively driven harmonic acoustic waves in a confined gas.

Measurements are presented of the acoustic pressure resulting from the periodic absorption and emission of radiative energy by an infrared-active gas contained in a closed, cylindrical tube. The acoustic waves are generated by means of an external, sinusoidally time-modulated blackbody source. The pressure measurements are for both resonant and nonresonant conditions at acoustic frequencies from about 60 to 600 Hz. Comparison of the measurements with predictions shows that the response is due primarily to the modified-classical acoustic wave, but that a small contribution from the so-called radiation-induced wave can be measured in certain of the tests. Strong effects of vibrational nonequilibrium, similar to those observed previously in spectrophone studies, were found in some of the tests.

Compton, D. L.↗
NASA NTRS1972

Characteristics of the unsteady shock-induced laminar boundary layer on a flat plate.

The unsteady shock-induced laminar boundary layer on a flat plate is theoretically studied for shock speeds ranging from 1.12 to 9 km/sec. Boundary layer flows for real air, assumed to be in thermochemical equilibrium, are analyzed by extending Lam's work on shock-induced laminar boundary layers to equilibrium dissociated and ionized flows. A complete description of the unsteady nature of the boundary layer is presented in terms of heat transfer and several boundary layer thickness quantities as functions of a single time-position variable. Boundary layer development is considered for two points of view. Time-dependent boundary layer development and approach to steady state for any fixed position on the plate is described, as is the configuration of the boundary layer with position on the plate at any point in time.

Cook, W. J.↗
NASA NTRS1972

Free flight determination of boundary layer transition on small scale cones in the presence of surface ablation

To assess the possibility of achieving extensive laminar flow on conical vehicles during hyperbolic entry, the Ames Research Center has had an ongoing program to study boundary-layer transition on ablating cones. Boundary layer transition results are presented from ballistic range experiments with models that ablated at dimensionless mass transfer rates comparable to those expected for full scale flight at speeds up to 17 km/sec. It was found possible to measure the surface recession and hence more accurately identify regions of laminar, transitional, and turbulent flow along generators of the recovered cones. Some preliminary results using this technique are presented.

Wilkins, M. E.↗
NASA NTRS1972

Some gamma-ray shielding measurements made at altitudes greater than 115000 feet using large Ge(Li) detectors

A series of balloon-flight experiments at altitudes greater than 115,000 feet were conducted to gain information relative to the use of composite shields (passive and/or active) for shielding large-volume, lithium-drifted, germanium (Ge(Li)) detectors used in gamma-ray spectrometers. Data showing the pulse-height spectra of the environmental gamma radiation as measured at 5.3 and 3.8 gms sq cm residual atmosphere with an unshielded diode detector are also presented.

Chapman, G. T.↗