Engineering topics
Chapman, Bruce
Publications and source records attributed to Chapman, Bruce.
Comparison of SAR and CYNSS surface water extent metrics over the Yucatan Lake wetland site
Wetlands have a major role in the carbon cycle, outgassing large quantities of carbon dioxide and methane through processes that are directly and strongly influenced by the duration and timing of inundation. Therefore, understanding the seasonal pattern of inundation can be a component for regional to global scale carbon models. Measurement of inundation extent also establishes a benchmark for the current status of wetland areas, useful in assessing the future impacts of climate change. The incorporation of frequent measurements of inundation extent into large-scale hydrological models would permit the evaluation of more detailed seasonal and longer-term floodplain dynamics and their associated management implications.The Cyclone GNSS (CYGNSS) constellation of satellites launched in 2016, and carries receivers capable of receiving data from L-band GNSS reflections. Delay Doppler maps (DDM) are generated on board and telemetered to the ground, along with a small number of raw data takes that can be used for special processing on the ground for evaluation purposes. It has been previously shown that these data can be sensitive to inundation.The NASA ISRO Synthetic Aperture Radar, currently planned for launch in January 2023, has both an L-band and S-band SAR for earth imaging. The L-band SAR, which will image the Earth's land mass twice every 12 days, has a requirement for measuring wetland inundation extent at the 1 ha scale. One of the sites that will be used to validate this requirement is Yucatan Lake, Louisiana. This oxbow lake and surrounding area located adjacent to the Mississippi river experiences periodic and extensive flooding in the surrounding forest areas.In 2019, NASA's UAVSAR fully polarimetric airborne L-band SAR conducted a flight campaign to image a dozen sites in the SE USA at approximately 12-day intervals and both in the morning and evening, to simulate the type of data NISAR will obtain. One site imaged during this campaign was the Yucatan Lake area, spanning water stages from low to high flood conditions.It has been demonstrated previously that GNSS reflectometry such as that measured by CYGNSS may be used to characterize surface inundation. It has also been known for decades that L-band SAR may be used to characterize not only the presence of open water, but also the presence of subcanopy inundation in forested areas. In this paper we will present results comparing data from these two types of instruments.
Tracking changes in inundation extent of a boreal wetland in Alaska using L-band SAR
No abstract provided
Assessment Of Polsar And Insar Time-Series From The 2019 Nasa Am-Pm Campaign For Above-Ground Biomass Estimation
The forthcoming launch of the NASA-ISRO Synthetic ApertureRadar (NISAR) mission will open the path to a new typeof L-band measurements constituted by dense time-series ofpolarimetric backscatter and interferometric coherence withunprecedented spatial and temporal sampling. Here, we startthe development of a theoretical framework that links L-bandbackscatter time-series with interferometric coherence measurements.The water-cloud-model (WCM) and an extendedversion of the random-motion-over-ground (RMoG) modelare adopted to express radar measurements in terms of forestabove-ground biomass and tree height. Time-series datacollected during the 2019 UAVSAR AM-PM campaign inSoutheastern United States are used to evaluate the correlationof various PolSAR- and InSAR-derived parameters withfield-measured above-ground biomass.
2018 NISAR Applications Workshop: Wetlands; Workshop Report
Wetland ecosystems are a critical part of our natural environment, providing socioeconomic benefits to human communities and habitats to a rich diversity of plant and animal life. Socioeconomic benefits include improved water quality, flood control, foods, shoreline stabilization, groundwater recharge, and recreational opportunities. Wetlands also have a major role as carbon sinks and sources through processes that are influenced by the duration and timing of soil saturation and inundation. Thus, carbon and water cycle models must take into account wetland extent and seasonal patterns of wetland inundation. The joint NASA, US Geological Survey (USGS) and Fish and Wildlife Service (FWS) workshop focused on advancing wetland applications of the spaceborne NASA-ISRO Synthetic Aperture Radar (SAR) mission (NISAR), a jointly developed satellite between NASA and the Indian Space Research Organisation (ISRO) expected for launch early 2022. Participants from 15 national and international organizations --including US Federal Agencies, nonprofits, academics, and the private sector-- had been identified as key-players in facilitating integration of Earth Observations into decision support workflows. Discussions were held over two and a half days to convey the knowledge and measurement needs of the wetlands community and discuss the delivery of relevant geospatial products that could be derived from NISAR data. While the community typically characterizes wetlands by their hydrological process, vegetation and soil types, a central defining characteristic is that a wetland is a land area inundated or saturated in the rootzone for at least 2 weeks of the average vegetation growing season.
Validation of Forested Inundation Extent Revealed by L-Band Polarimetric and Interferometric SAR Data
UAVSAR, NASA's airborne Synthetic Aperture Radar (SAR), conducted an extended observational campaign in Central and South America in March 2013, primarily related to volcanic deformations along the Andean Mountain Range but also including a large number of flights studying other scientific phenomena. During this campaign, the L-Band SAR collected data over the Napo River in Ecuador. The objectives of this experiment were to acquire polarimetric and interferometric L-Band SAR data over an inundated tropical forest in Ecuador simultaneously with on-the-ground field work ascertaining the extent of inundation, and to then derive from this data a quantitative estimate for the error in the SAR-derived inundation extent. In this paper, we will first describe the processing and preliminary analysis of the SAR data. The polarimetric SAR data will be classified by land cover and inundation state. The interferometric SAR data will be used to identify those areas where change in inundation extent occurred, and to measure the change in water level between two observations separated by a week. Second, we will describe the collection of the field estimates of inundation, and have preliminary comparisons of inundation extent measured in the field field versus that estimated from the SAR data.
Overview and Applications of UAVSAR's Multi-Squint Polarimetric Imaging Mode
NASA's Jet Propulsion Laboratory has developed a reconfigurable polarimetric L-band synthetic aperture radar (SAR), specifically designed to acquire airborne repeat track interferometric (RTI) SAR data for application to monitoring surface deformation and vegetation structure measurements. The system employs a precision autopilot developed by NASA Dryden that allows the plane to fly precise trajectories usually within a 5 m tube. Also required for robust repeat pass applications is the ability to point the antenna in the same direction on repeat passes to a fraction of an azimuth beamwidth (8? for UAVSAR). This precise pointing is achieved using an electronically scanned antenna whose pointing is based on inertial navigation unit (INU) attitude angle data. The radar design is fully polarimetric with an 80 MHz bandwidth (2 m range resolution) and has a greater than 20 km range swath when flying at its nominal altitude of 12500 m. The ability to electronically steer the beam on a pulse-to-pulse basis has allowed a new mode of SAR data acquisition whereby the radar beam is steered to different squint angles on successive pulses thereby simultaneously generating images at multiple squint angles. This mode offers the possibility of generating vector deformation measurements with a single pair of repeat passes and to obtain greater kz diversity for vegetation studies with a reduced number of passes. This paper will present an overview of the mode, discuss its potential for deformation and vegetation, and show some examples using UAVSAR data.
SAR Imagery Applied to the Monitoring of Hyper-Saline Deposits: Death Valley Example (CA)
The present study aims at understanding the influence of salinity on the dielectric constant of soils and then on the backscattering coeff cients recorded by airborne/spaceborne SAR systems. Based on dielectric measurements performed over hyper-saline deposits in Death Valley (CA), as well as laboratory electromagnetic characterization of salts and water mixtures, we used the dielectric constants as input parameters of analytical IEM simulations to model both the amplitude and phase behaviors of SAR signal at C, and L-bands. Our analytical simulations allow to reproduce specif c copolar signatures recorded in SAR data, corresponding to the Cottonball Basin saltpan. We also propose the copolar backscattering ratio and phase difference as indicators of moistened and salt-affected soils. More precisely, we show that these copolar indicators should allow to monitor the seasonal variations of the dielectric properties of saline deposits.
Imaging Ionospheric Fine Structures Using Polarimetric SAR and GPS
No abstract available
The Mosaic Theme of the ALOS Kyoto and Carbon Project
This paper will address this last theme: the mosaicking of ALOS PALSAR imagery.
AIRSAR Web-Based Data Processing
The AIRSAR automated, Web-based data processing and distribution system is an integrated, end-to-end synthetic aperture radar (SAR) processing system. Designed to function under limited resources and rigorous demands, AIRSAR eliminates operational errors and provides for paperless archiving. Also, it provides a yearly tune-up of the processor on flight missions, as well as quality assurance with new radar modes and anomalous data compensation. The software fully integrates a Web-based SAR data-user request subsystem, a data processing system to automatically generate co-registered multi-frequency images from both polarimetric and interferometric data collection modes in 80/40/20 MHz bandwidth, an automated verification quality assurance subsystem, and an automatic data distribution system for use in the remote-sensor community. Features include Survey Automation Processing in which the software can automatically generate a quick-look image from an entire 90-GB SAR raw data 32-MB/s tape overnight without operator intervention. Also, the software allows product ordering and distribution via a Web-based user request system. To make AIRSAR more user friendly, it has been designed to let users search by entering the desired mission flight line (Missions Searching), or to search for any mission flight line by entering the desired latitude and longitude (Map Searching). For precision image automation processing, the software generates the products according to each data processing request stored in the database via a Queue management system. Users are able to have automatic generation of coregistered multi-frequency images as the software generates polarimetric and/or interferometric SAR data processing in ground and/or slant projection according to user processing requests for one of the 12 radar modes.
Estimating tropical-forest density profiles from multibaseline interferometric SAR
Vertical profiles of forest density are potentially robust indicators of forest biomass, fire susceptibility and ecosystem function. Tropical forests, which are among the most dense and complicated targets for remote sensing, contain about 45% of the world's biomass. Remote sensing of tropical forest structure is therefore an important component to global biomass and carbon monitoring. This paper shows preliminary results of a multibasline interfereomtric SAR (InSAR) experiment over primary, secondary, and selectively logged forests at La Selva Biological Station in Costa Rica. The profile shown results from inverse Fourier transforming 8 of the 18 baselines acquired. A profile is shown compared to lidar and field measurements. Results are highly preliminary and for qualitative assessment only. Parameter estimation will eventually replace Fourier inversion as the means to producing profiles.
The Interferometric Data Calibration for the AIRSAR PacRim II Mission
This paper focuses on the cross-track interferometric data calibration results and height accuracy analysis. We also present the key elements of the calibration techniques for cross-track interferometric SAR processed with the AIRSAR Integrated Processor.