Engineering Papers⌕ Search

Engineering topics

Chamberlin, Clyde E

Publications and source records attributed to Chamberlin, Clyde E.

Synthesis and Characterization of Bulk Vitreous Cadmium Germanium Arsenide

Abstract Cadmium-germanium-diarsenide (“CGA”) glasses were synthesized in bulk form (~2.4 cm3) using the procedures adapted from the literature. Several issues involved in the fabrication and quenching of amorphous CdGexAs2 (x = 0.45, 0.65, 0.85, 1.00) are described. An innovative processing route is presented to enable quenching of vitreous, crack-free ingots with sizes up to 10 mm diameter, and 30 – 40 mm long. Specimens from selected ingots were characterized using thermal analysis, optical microscopy, scanning electron microscopy, energy dispersive spectroscopy, particle-induced X-ray emission, Rutherford backscattering, secondary ion mass spectrometry, X-ray diffraction, density, and optical spectroscopy. Variations in properties as a function of processing conditions and composition are described. Results show that the density of defect states in the middle of the band gap and near the band edges can be decreased three ways: through suitable control of the processing conditions, by doping the material with hydrogen, and by increasing the concentration of Ge in the glass.

08 HYDROGEN↗

Technetium Waste Form Development - Progress Report

Analytical electron microscopy using SEM and TEM has been used to analyze a ~5 g. ingot with composition 71.3 wt% 316SS-5.3 wt% Zr-13.2 wt% Mo-4.0 wt% Rh-6.2 wt% Re prepared at the Idaho National Laboratory. Four phase fields have been identified two of which are lamellar eutectics, with a fifth possibly present. A Zr rich phase was found distributed as fine precipitate, ~10µm in diameter, often coating large cavities. A Mo-Fe-Re-Cr lamellar eutectic phase field appears as blocky regions ~30µm in diameter, surrounded by a Fe-Mo-Cr lamellar eutectic phase field, and that in turn is surrounded by a Zr-Fe-Rh-Mo-Ni phase field. The eutectic phase separation reactions are different. The Mo-Fe-Re-Cr lamellar eutectic appears a result of austenitic steel forming at lower volume fraction within an Mo-Fe-Re intermetallic phase, whereas the Fe-Mo-Cr lamellar eutectic may be a result of the same intermetallic phase forming within a ferritic steel phase. Cavitation may have arisen either as a result of bubbles, or from loss of equiaxed particles during specimen preparation.

12 MANAGEMENT OF RADIOACTIVE AND NON-RADIOACTIVE W↗