Chahal, Prem | Engineering Papers

DOE OSTI2024

Low-Power Characterization and Integration of Carbon Black Resistive Ink for Aerosol Jet-Printed RF Components

Aerosol jet printing (AJP) is gaining attention in additive manufacturing research, especially in the discipline of microwave engineering. Currently, no reliable AJP method exists to fabricate resistors that are both electrically small and with a resistance compatible with waveguide impedances for use in microwave components. In this work, the commercially available Metalon JR-038 is characterized and used to fabricate a resistor that is 100 μ m long by 250 μ m wide for the first time to the best of our knowledge. Furthermore, this resistor was then used to fabricate a Ka-band Wilkinson power divider using only the AJP process.

36 MATERIALS SCIENCE↗

DOE OSTI2024

Aerosol-Jet Printed Transferable Millimeter-Wave Circuits

Printed millimeter wave (mmW) electronics have been of high interest in the field of communications for some time now due to the potential ability to fabricate mmW systems that utilize 3-Dimension Heterogeneous Integration (3DHI) to improve performance beyond traditional systems. Here, in this paper, a method for fabricating transferable mmW structures via aerosol-jet printing (AJP) is presented. A PDMS stamp assisted liftoff procedure is developed to separate the printed part from a rigid printing support surface and apply it to an adhesive target surface. Several microstrip (MS) line structures are demonstrated to characterize the effect of stamp transfer on the RF performance of the printed circuits. The effects of printed vias on RF probe pads and shifts in the resonant frequencies of a Beatty standard line after transfer are considered and characterized using S-parameter measurements.

42 ENGINEERING↗