Engineering topics

Celarier, Edward A.

Publications and source records attributed to Celarier, Edward A..

10 records

NASA NTRS2017

The Version 3 OMI NO2 Standard Product

We describe the new version 3.0 NASA Ozone Monitoring Instrument (OMI) standard nitrogen dioxide (NO2) products (SPv3). The products and documentation are publicly available from the NASA Goddard Earth Sciences Data and Information Services Center (https://disc.gsfc.nasa.gov/datasets/OMNO2_V003/summary/). The major improvements include (1) a new spectral fitting algorithm for NO2 slant column density (SCD) retrieval and (2) higher-resolution (1° latitude and 1.25° longitude) a priori NO2 and temperature profiles from the Global Modeling Initiative (GMI) chemistry–transport model with yearly varying emissions to calculate air mass factors (AMFs) required to convert SCDs into vertical column densities (VCDs). The new SCDs are systematically lower (by ∼10-40%) than previous, version 2, estimates. Most of this reduction in SCDs is propagated into stratospheric VCDs. Tropospheric NO2 VCDs are also reduced over polluted areas, especially over western Europe, the eastern US, and eastern China. Initial evaluation over unpolluted areas shows that the new SPv3 products agree better with independent satellite- and ground-based Fourier transform infrared (FTIR) measurements. However, further evaluation of tropospheric VCDs is needed over polluted areas, where the increased spatial resolution and more refined AMF estimates may lead to better characterization of pollution hot spots.

Ozone Monitoring Instrument (OMI)↗

NASA NTRS2016

Aura OMI Observations of Regional SO2 and NO2 Pollution Changes from 2005 to 2015

The Ozone Monitoring Instrument (OMI) onboard NASA's Aura satellite has been providing global observations of the ozone layer and key atmospheric pollutant gases, such as nitrogen dioxide (NO2) and sulfur dioxide (SO2), since October 2004. The data products from the same instrument provide consistent spatial and temporal coverage and permit the study of anthropogenic and natural emissions on local-to-global scales. In this paper, we examine changes in SO2 and NO2 over some of the world's most polluted industrialized regions during the first decade of OMI observations. In terms of regional pollution changes, we see both upward and downward trends, sometimes in opposite directions for NO2 and SO2, for different study areas. The trends are, for the most part, associated with economic and/or technological changes in energy use, as well as regional regulatory policies. Over the eastern US, both NO2 and SO2 levels decreased dramatically from 2005 to 2015, by more than 40 and 80 percent, respectively, as a result of both technological improvements and stricter regulations of emissions. OMI confirmed large reductions in SO2 over eastern Europe's largest coal-fired power plants after installation of flue gas desulfurization devices. The North China Plain has the world's most severe SO2 pollution, but a decreasing trend has been observed since 2011, with about a 50 percent reduction in 2012-2015, due to an economic slowdown and government efforts to restrain emissions from the power and industrial sectors. In contrast, India's SO2 and NO2 levels from coal power plants and smelters are growing at a fast pace, increasing by more than 100 and 50 percent, respectively, from 2005 to 2015. Several SO2 hot spots observed over the Persian Gulf are probably related to oil and gas operations and indicate a possible underestimation of emissions from these sources in bottom-up emission inventories. Overall, OMI observations have proved valuable in documenting rapid changes in air quality over different parts of the world during last decade. The baseline established during the first 11 years of OMI is indispensable for the interpretation of air quality measurements from current and future satellite atmospheric composition missions.

SO2 and NO2↗

NASA NTRS2016

Aura OMI observations of regional SO2 and NO2 pollution changes from 2005 to 2015

The Ozone Monitoring Instrument (OMI) onboard NASA's Aura satellite has been providing global observations of the ozone layer and key atmospheric pollutant gases, such as nitrogen dioxide (NO2/ and sulfur dioxide (SO2/, since October 2004. The data products from the same instrument provide consistent spatial and temporal coverage and permit the study of anthropogenic and natural emissions on local-to-global scales. In this paper, we examine changes in SO2 and NO2 over some of the world's most polluted industrialized regions during the first decade of OMI observations. In terms of regional pollution changes, we see both upward and downward trends, sometimes in opposite directions for NO2 and SO2, for different study areas. The trends are, for the most part, associated with economic and/or technological changes in energy use, as well as regional regulatory policies. Over the eastern US, both NO2 and SO2 levels decreased dramatically from 2005 to 2015, by more than 40 and 80 %, respectively, as a result of both technological improvements and stricter regulations of emissions. OMI confirmed large reductions in SO2 over eastern Europe's largest coal-fired power plants after installation of flue gas desulfurization devices. The North China Plain has the world's most severe SO2 pollution, but a decreasing trend has been observed since 2011, with about a 50% reduction in 2012- 2015, due to an economic slowdown and government efforts to restrain emissions from the power and industrial sectors. In contrast, India's SO2 and NO2 levels from coal power plants and smelters are growing at a fast pace, increasing by more than 100 and 50 %, respectively, from 2005 to 2015. Several SO2 hot spots observed over the Persian Gulf are probably related to oil and gas operations and indicate a possible underestimation of emissions from these sources in bottom-up emission inventories. Overall, OMI observations have proved valuable in documenting rapid changes in air quality over different parts of the world during last decade. The baseline established during the first 11 years of OMI is indispensable for the interpretation of air quality measurements from current and future satellite atmospheric composition missions.

Pollution trends↗

NASA NTRS2012

Biases in Long-term NO2 Averages Inferred from Satellite Observations Due to Cloud Selection Criteria

Retrievals of atmospheric trace gas column densities from space are compromised by the presence of clouds, requiring most studies to exclude observations with significant cloud fractions in the instrument's field of view. Using NO2 observations at three ground stations representing urban, suburban, and rural environments, and tropospheric vertical column densities measured by the Ozone Monitoring Instrument (OMI) over each site, we show that the observations from space represent monthly averaged ground-level pollutant conditions well (R=0.86) under relatively cloud-free conditions. However, by analyzing the ground-level data and applying the OMI cloud fraction as a filter, we show there is a significant bias in long-term averaged NO2 as a result of removing the data during cloudy conditions. For the ground-based sites considered in this study, excluding observations on days when OMI-derived cloud fractions were greater than 0.2 causes 12:00-14:00 mean summer mixing ratios to be underestimated by 12%+/-6%, 20%+/-7%, and 40%+/-10% on average (+/-1 standard deviation) at the urban, suburban, and rural sites respectively. This bias was investigated in particular at the rural site, a region where pollutant transport is the main source of NO2, and where longterm observations of NOy were also available. Evidence of changing photochemical conditions and a correlation between clear skies and the transport of cleaner air masses play key roles in explaining the bias. The magnitude of a bias is expected to vary from site to site depending on meteorology and proximity to NOx sources, and decreases when longer averaging times of ground station data (e.g. 24-h) are used for the comparison.

SEASONAL-VARIATIONS↗

NASA NTRS2009

The Sensitivity of U.S. Surface Ozone Formation to NOx, and VOCs as Viewed from Space

We investigated variations in the sensitivity of surface ozone formation in summer to precursor species concentrations of volatile organic compounds (VOCs) and nitrogen oxides (NO(x)) as inferred from the ratio of tropospheric columns of formaldehyde and nitrogen dioxide from the Aura Ozone Monitoring Instrument (OMI). The data indicate that ozone formation became: 1. more sensitive to NO(x) over most of the U.S, from 2005 to 2007 because of substantial decreases in NO(x) emissions primarily from stationary sources, and 2. more sensitive to NO(x) with increasing temperature, in part because emissions of highly reactive, biogenic isoprene increase with temperature, thus increasing the total VOC reactivity. Based on our interpretation of the data, current strategies implemented to reduce unhealthy levels of surface ozone should focus more on reducing NO(x) emissions, except in some downtown areas which have historically benefited from reductions in VOC emissions.

Duncan, Bryan N.↗

NASA NTRS2006

Algorithm for NO2 Vertical Column Retrieval from the Ozone Monitoring Instrument

We describe the operational algorithm for the retrieval of stratospheric, tropospheric, and total column densities of nitrogen dioxide NO2 from earthshine radiances measured by the Ozone Monitoring Instrument (OMI), aboard the EOS-Aura satellite. The algorithm uses the DOAS method for the retrieval of slant column NO densities. Air mass factors (AMFs) calculated from a stratospheric NO2 profile are used to make initial estimates of the vertical column density. Using data collected over a 24-h period, a smooth estimate of the global stratospheric field is constructed. Where the initial vertical column densities exceed the estimated stratospheric field, we infer the presence of tropospheric NO2, and recalculate the vertical column density (VCD) using an AMF calculated from an assumed tropospheric NO2 profile. The parameters that control the operational algorithm were selected with the aid of a set of data assembled from stratospheric and tropospheric chemical transport models. We apply the optimized algorithm to OMI data and present global maps of NO2 VCDs for the first time.

Bucsela, Eric J.↗

NASA NTRS2004

First Global Maps of Stratospheric and Tropospheric NO2 from OMI

The Ozone Monitoring Instrument (OMI) was launched successfully in July 2004, as one of four instruments on the EOS Aura satellite. OMI makes hyperspectral measurements that are used to retrieve column densities of critical trace gases, including formaldehyde, BrO, SO2 and NO2 . We present the first results from the OM1 operational NO2 algorithm and demonstrate its ability to retrieve the tropospheric and stratospheric components of NO2. The DOAS method is used to determine slant column densities, and initial air mass factors (AMFs) are used. to give initial estimates of the vertical column densities (VCDs). VCDs from up to 15 consecutive orbits are collected, and a spatial filtering technique is applied to extract the synoptic-scale features characteristic of the stratospheric, field. features to be evidence of tropospheric excess NO2 , and apply an AMF appropriate to polluted conditions, to obtain an improved retrieval of the NO2 total VCD. We describe the assumptions underlying the algorithm in detail, and show global maps of NO2 VCDs, based on the first operational data from OMI.

Bucsela, Eric J.↗

NASA NTRS2000

Total Ozone Mapping Spectrometer (TOMS) Level-3 Data Products User's Guide

Data from the TOMS series of instruments span the time period from November 1978, through the present with about a one and a-half year gap from January 1994 through July 1996. A set of four parameters derived from the TOMS measurements have been archived in the form of daily global maps or Level-3 data products. These products are total column ozone, effective surface reflectivity, aerosol index, and erythermal ultraviolet estimated at the Earth surface. A common fixed grid of I degree latitude by 1.25 degree longitude cells over the entire globe is provided daily for each parameter. These data are archived at the Goddard Space Flight Center Distributed Active Archive Center (DAAQ in Hierarchical Data Format (HDF). They are also available in a character format through the TOMS web site at http://toms.gsfc.nasa.gov. The derivations of the parameters, the mapping algorithm, and the data formats are described. The trend uncertainty for individual TOMS instruments is about 1% decade, but additional uncertainty exists in the combined data record due to uncertainty in the relative calibrations of the various TOMS.

McPeters, Richard D.↗

NASA NTRS1992

Understanding crystallinity in aromatic polyimides

Aromatic polyimides are a class of polymers that show remarkable thermal stability, strength, and toughness. These properties make them attractive candidates for use in high-performance carbon fiber composites for airborne and spaceborne structural components. Our research centered on the development of an understanding of the underlying process of crystallite formation in a particular class of aryl polyimides for which there are some x-ray crystallographic data available. The ultimate aim of the project is to be able to develop a model sufficiently flexible to be able, on the basis of the chemical structure of a polymer in this class, to predict: (1) whether it will be prone to form crystallites; (2) crystallographic features of the crystallites; and (3) synthesis and/or processing conditions that will be favorable or unfavorable to crystallite formation. This will provide guidance to the laboratory chemists in their choice of candidate polymers and processing methods.

Celarier, Edward A.↗

NASA NTRS1991

Computational modelling of polymers

Polymeric materials and polymer/graphite composites show a very diverse range of material properties, many of which make them attractive candidates for a variety of high performance engineering applications. Their properties are ultimately determined largely by their chemical structure, and the conditions under which they are processed. It is the aim of computational chemistry to be able to simulate candidate polymers on a computer, and determine what their likely material properties will be. A number of commercially available software packages purport to predict the material properties of samples, given the chemical structures of their constituent molecules. One such system, Cerius, has been in use at LaRC. It is comprised of a number of modules, each of which performs a different kind of calculation on a molecule in the programs workspace. Particularly, interest is in evaluating the suitability of this program to aid in the study of microcrystalline polymeric materials. One of the first model systems examined was benzophenone. The results of this investigation are discussed.

Celarier, Edward A.↗