Engineering PapersSearch

Engineering topics

Caudill, L. O.

Publications and source records attributed to Caudill, L. O..

Stratospheric ozone and hydroxyl radical measurements by balloon-borne lidar

An experiment is reported in which a balloon-borne lidar system was used to measure ozone and the hydroxyl radical in the stratosphere by two lidar techniques. Ozone was measured in the 20-37 km altitude range using differential absorption lidar, and the hydroxyl radical was measured in the 34-37 km range using remote laser-induced fluorescence. Ozone concentrations were determined with a vertical resolution of 0.5 km, and in addition, horizontally resolved ozone measurements with 0.15-km resolution were obtained over a 2-km range. The temporal variation of the hydroxyl radical concentration ranged from 40 parts/trillion shortly after noon to about 5 parts/trillion two hours after sunset. Possible modifications to the system are discussed which can yield an improvement in the sensitivity of between one and two orders of magnitude, thus permitting measurements of the hydroxyl radical in the 20-30-km altitude range.

Heaps, W. S.

Cloud top remote sensing by airborne lidar

Observations of cloud top height, backscattering, and signal depolarization have been obtained by a lidar system operating onboard a high-altitude research aircraft. The transmitter for the cloud lidar system is a doubled Nd:YAG laser operating at 5 Hz. The system functions as a fully automated sensor under microprocessor control and operates from a nominal 19-km altitude. Measurements have been acquired over a wide variety of cloud cover in conjunction with passive visible and infrared measurements. Initial observation results are reported

Spinhirne, J. D.

Skylab-earth laser-beacon experiment - Results and analysis

Photographs of a ground-based laser beacon were taken by astronauts on board the Skylab spacecraft. Unexpected large and elliptical laser-beam images were recorded. The photographic results are presented and discussed in terms of possible atmospheric scattering mechanisms. Current beacon experiments with the Landsat spacecraft are also discussed.

Bufton, J. L.

Satellite laser ranging work at the Goddard Space Flight Center

Laser ranging systems, their range and accuracy capabilities, and planned improvements for future systems are discussed, the systems include one fixed and two mobile lasers ranging systems. They have demonstrated better than 10 cm accuracy both on a carefully surveyed ground range and in regular satellite ranging operations. They are capable of ranging to all currently launched retroreflector equipped satellites with the exception of Timation III. A third mobile system is discussed which will be accurate to better than 5 cm and will be capable of ranging to distant satellites such as Timation III and LAGEOS.

Mcgunigal, T. E.

Satellite laser ranging work at the Goddard Space Flight Center

The pulsed-laser satellite ranging systems presently being operated by the Goddard Space Flight Center are described along with their range and accuracy capabilities. The major subsystems are outlined, operation of the fixed system and the two mobile systems is discussed, and the performance of all three systems is evaluated. It is noted that these systems have an accuracy of better than 10 cm on a carefully surveyed range as well as in regular satellite ranging operations and are capable of ranging to all currently launched retroreflector-equipped satellites with the exception of Timation III. Future improvements discussed include a third mobile system which will be able to range distant satellites, such as Timation III, with an accuracy of better than 5 cm and the use of a frequency-doubled Nd:YAG laser in place of the ruby lasers now being employed.

Mcgunigal, T. E.

Satellite laser ranging work at the Goddard Space Flight Center

The paper describes the satellite laser ranging system at the Goddard Space Flight Center, its range and accuracy capabilities, and planned improvements for future systems. Major subsystems are described, including the laser, optical/mechanical, receiver, computer/software, timing, and laser data preprocessing subsystems. Operational considerations are examined, with attention given the mobile station layout, manpower requirements, and transportability. System performance is considered, with emphasis on system accuracy (calibration, stability, clock synchronization, atmospheric propagation correction) and range capability.

Mcgunigal, T. E.

Long range laser traversing system

The relative azimuth bearing between first and second spaced terrestrial points which may be obscured from each other by intervening terrain is measured by placing at one of the points a laser source for projecting a collimated beam upwardly in the vertical plane. The collimated laser beam is detected at the second point by positioning the optical axis of a receiving instrument for the laser beam in such a manner that the beam intercepts the optical axis. In response to the optical axis intercepting the beam, the beam is deflected into two different ray paths by a beam splitter having an apex located on the optical axis. The energy in the ray paths is detected by separate photoresponsive elements that drive logic networks for proving indications of: (1) the optical axis intercepting the beam; (2) the beam being on the left of the optical axis and (3) the beam being on the right side of the optical axis.

Caudill, L. O.

Long range laser traversing system

A study was carried out to determine the feasibility of a man-portable receiver system for land survey, which would be capable of detecting the optical scatter due to molecular and aerosol constituents of the atmosphere from a vertical laser beam. Tests were run with a beacon and receiver separated by approximately one mile. The system was consistently able to detect the laser signal regardless of background conditions.

Caudill, L. O.