Engineering topics

Carlson, John R.

Publications and source records attributed to Carlson, John R..

24 records · Page 2

NASA NTRS1989

Integration effects of pylon geometry on a high-wing transport airplane

An investigation was conducted in the Langley 16-Foot Transonic Tunnel to determine the installation effects of a series of pylons that had differing cross-sectional shapes on the pressure distributions and aerodynamic characteristics of a 1/24-scale high wing transport. The tests were conducted at Mach numbers at 0.70 and 0.80 at angles of attack from -3 degrees to 4 degrees with the pylons tested at various toe angles between 5 degrees inboard and 5 degrees outboard. Results of this study indicate that the installed drag was lowest for the pylons with a compression pylon type design which kept the flow under the wing in the pylon/wing junction comparable to the clean wing velocities.

Carlson, John R.↗

NASA NTRS1987

Intergration effects of D-shaped, underwing, aft-mounted, separate-flow, flow-through nacelles on a high-wing transport

An experimental investigation was conducted in the Langley 16-Foot Transonic Tunnel at freestream Mach numbers from 0.70 to 0.82 and angles of attack from -3.0 to 4.0 deg to determine the integration effects of D-shaped, underwing, aft-mounted, separate-flow, flow-through nacelles on a high-wing transonic transport configuration. The results showed that the aft-mounted nacelle/pylon produced an increase in lift over that of the wing-body configuration by pressurizing much of the wing lower surface in front of the pylon. For the D-shaped nacelle, a substantial region of supersonic flow over the wing, aft of the lip of the nacelle, cancelled the reduction in drag caused by the increase in pressures ahead of the lip, to increase interference and form drag compared with a similar circular-shaped nacelle. The installed drag of the D=shaped nacelle was essentially the same as that of an aft-mounted circular nacelle from a previous investigation.

Lamb, Milton↗

NASA NTRS1987

Evaluation and application of VSAERO to a nonaxisymmetric afterbody with thrust vectoring

The incorporation of multifunction nozzles into fighter aircraft can enhance fighter maneuverability and performance. Development of computational methods will be vital for determining efficient methods of aerodynamic integration of these nozzles. This paper will discuss the utilization of a current technology subsonic panel method (VSAERO) for predicting the flow about a nonaxisymmetric nozzle afterbody with and without a thrust vectoring concept. Two modelings for the vectored exhaust are presented. Highly favorable comparisons were obtained with a rudimentary modeling of the vectored exhaust.

Carlson, John R.↗

NASA NTRS1987

An experimental investigation of an advanced turboprop installation on a swept wing at subsonic and transonic speeds

An investigation was conducted in the Langley 16-Foot Transonic Tunnel to determine the effects of a turboprop-nacelle installation on the pressure distributions over a swept, supercritical wing. The tests were conducted at Mach numbers from 0.20 to 0.80, at angles of attack from 0 to 5 degrees, nacelle nozzle pressure ratios from 1.0 to 1.6, and at propeller tip speeds from 700 to 800 ft/sec. The results of this study indicate that the turboprop nacelle interference, with and without power, on a swept wing is greater on the inboard wing panel than on the outboard wing panel. The over-the-wing nacelle installation with the propeller upwash on the inboard panel had flow separation problems at a Mach number of 0.80. No severe flow separation problems appear to exist for either propeller rotation direction for the under-the-wing nacelle installation. The local flow disturbances caused by the under-the-wing nacelle installation were in general less severe than for the over-the-wing nacelle installation.

Carlson, John R.↗

NASA NTRS1987

Integration effects of pylon geometry and rearward mounted nacelles for a high-wing transport

Results of a wind-tunnel study of the effect of pylon cross-sectional shape and tow angle on airplane drag and an aft-mounted nacelle are presented. The 1/24-scale wide-body high-wing transport model was tested in the Langley 16-Foot Transonic Tunnel at free-stream Mach 0.7-0.8 and angles of attack from -3 to 4 degrees. A compression-type pylon is found to have the lowest drag at both Mach 0.7 and 0.8 and to be capable of suppressing the velocities in the inboard region of the pylon-wing junction, reducing the extent of supersonic flow and the probability of flow separation. It is also shown that the D-shaped aft-mounted nacelle has a low interference drag, as do previously tested circular nacelles in the same position.

Carlson, John R.↗

NASA NTRS1986

Evaluation of three numerical methods for propulsion integration studies on transonic transport configurations

An effort has been undertaken at the NASA Langley Research Center to assess the capabilities of available computational methods for use in propulsion integration design studies of transonic transport aircraft, particularly of pylon/nacelle combinations which exhibit essentially no interference drag. The three computer codes selected represent state-of-the-art computational methods for analyzing complex configurations at subsonic and transonic flight conditions. These are: EULER, a finite volume solution of the Euler equation; VSAERO, a panel solution of the Laplace equation; and PPW, a finite difference solution of the small disturbance transonic equations. In general, all three codes have certain capabilities that allow them to be of some value in predicting the flows about transport configurations, but all have limitations. Until more accurate methods are available, careful application and interpretation of the results of these codes are needed.

Yaros, Steven F.↗