Engineering Papers⌕ Search

Engineering topics

Carden, H. D.

Publications and source records attributed to Carden, H. D..

At least 19 records

Crash Tests of Protective Airplane Floors

Energy-absorbing floors reduce structural buckling and impact forces on occupants. 56-page report discusses crash tests of energy-absorbing aircraft floors. Describes test facility and procedures; airplanes, structural modifications, and seats; crash dynamics; floor and seat behavior; and responses of anthropometric dummies seated in airplanes. Also presents plots of accelerations, photographs and diagrams of test facility, and photographs and drawings of airplanes before, during, and after testing.

Carden, H. D.↗

Drop testing and analysis of six-foot diameter graphite-epoxy frames

Graphite-epoxy frames were drop tested onto a concrete floor to simulate crash loadings. The frames have Z-shaped cross-sections typical of designs often proposed for fuselage structure of advanced composite transports. The 6-foot diameter of the frames was chosen to reduce specimen fabrication costs and to facilitate testing. Response of the frames from accelerometer, strain gage, and photographic measurements are presented which characterize the behavior under 25-30 fps vertical impact velocity onto concrete. Failure of the graphite-epoxy frames involved a complete separation through the cross section near the impact point. All damage to the composite frame was confined to an area close to the impact point. Failure of aluminum frames tested for comparison were different from the composite specimens. The aluminum frames yielded (plastic hinges formed) at several locations around the lower portion of the frame without failing completely across the section.

Boitnott, R. L.↗

The dynamic response of composite beams to axial impact

Large deformation response of simple composite structural elements to intense dynamic loadings is studied by focusing on the response of beams. Overall goals are to: design a simple test fixture to introduce crash related bending loads in beams; determine any difference between large deformation static and large deformation dynamic response; determine the influence of laminate stacking arrangements on the dynamic response, failure mode, and energy absorbed; and predict the dynamic response. Twelve different laminate orientations were investigated. Modeling of the response was done with an existing finite element program. The program computed nonlinear transient response analysis of a structure objected to a time varying load.

Derian, E. J.↗

Impact dynamics research on composite transport structures

The experimental and analytical efforts being undertaken to investigate the response of composite and aluminum structures under crash loading conditions were reviewed. A Boeing 720 airplane was used in the controlled-impact demonstration test. Energy absorption of composite materials, the tearing of fuselage skin panels, the friction and abrasion behavior of composite skins, and the crushing behavior and dynamic response of composite beams were among the topics addressed.

Carden, H. D.↗

Energy-Absorbing Airframes for General Aviation

Concept for protecting people in lightweight airplane crashes involves redesigning area between interior floor and outer skin of airplane belly to create subfloor strong enough to bear stresses of flight but crush under force of impact. Several concepts evaluated and five selected and designed as lower fuselage sections tested in NASA's crash-testing program. Notched corner concept, Corrugated Beam concept, Foam-Filled Cylinder concept, Corrugated Half Shell concept, and Canted Bulkhead concept. Experimental and analytical results indicate all five concepts perform well; upper floor remains structurally intact whereas crush zone collapses under essentially constant load.

Carden, H. D.↗

Full-scale crash-test evaluation of two load-limiting subfloors for general aviation airframes

Three six place, low wing, twin engine general aviation airplane test specimens were crash tested at the Langley Impact Dynamics Research Facility under controlled free flight conditions. One structurally unmodified airplane was the base line specimen for the test series. The other two airplanes were structurally modified to incorporate load limiting (energy absorbing) subfloor concepts into the structure for full scale crash test evaluation and for comparison with the unmodified airplane test results. Typically, the lowest floor accelerations, the lowest anthropomorphic dummy responses, and the least seat crushing of standard and load limiting seats occurred in the airplanes modified with load limiting subfloors, wherein the greatest structural crushing of the subfloor took place. The better performing of the two load limiting subfloor concepts reduced the peak airplane floor accelerations to -25g to -30g as compared with approximately -40g to -55g for the unmodified airplane structure.

Carden, H. D.↗

Impact dynamics research on composite transport structures

The experimental and analytical efforts being undertaken to investigate the response of composite and aluminum structures under crash loading conditions were reviewed. A Boeing 720 airplane was used in the controlled-impact demonstration test. Energy absorption of composite materials, the tearing of fuselage skin panels, the friction and abrasion behavior of composite skins, and the crushing behavior and dynamic response of composite beams were among the topics addressed.

Carden, H. D.↗

Survey of NASA research on crash dynamics

Ten years of structural crash dynamics research activities conducted on general aviation aircraft by the National Aeronautics and Space Administration (NASA) are described. Thirty-two full-scale crash tests were performed at Langley Research Center, and pertinent data on airframe and seat behavior were obtained. Concurrent with the experimental program, analytical methods were developed to help predict structural behavior during impact. The effects of flight parameters at impact on cabin deceleration pulses at the seat/occupant interface, experimental and analytical correlation of data on load-limiting subfloor and seat configurations, airplane section test results for computer modeling validation, and data from emergency-locator-transmitter (ELT) investigations to determine probable cause of false alarms and nonactivations are assessed. Computer programs which provide designers with analytical methods for predicting accelerations, velocities, and displacements of collapsing structures are also discussed.

Thomson, R. G.↗

Performance of two load-limiting subfloor concepts in full-scale general aviation airplane crash tests

Three six-place, low wing, twin-engine general aviation airplane test specimens were crash tested at the langley Impact Dynamics research Facility under controlled free-flight conditions. One structurally unmodified airplane was the baseline airplane specimen for the test series. The other airplanes were structurally modified to incorporate load-limiting (energy-absorbing) subfloor concepts into the structure for full scale crash test evaluation and comparison to the unmodified airplane test results. Typically, the lowest floor accelerations and anthropomorphic dummy occupant responses, and the least seat crushing of standard and load-limiting seats, occurred in the modified load-limiting subfloor airplanes wherein the greatest structural crushing of the subfloor took place. The better performing of the two load-limiting subfloor concepts reduced the peak airplane floor accelerations at the pilot and four seat/occupant locations to -25 to -30 g's as compared to approximately -50 to -55 g's acceleration magnitude for the unmodified airplane structure.

Carden, H. D.↗

Flexible Aircraft Takeoff and Landing Analysis

Flexible Aircraft Takeoff and Landing Analysis Program, FATOLA, simulates aircraft takeoff and landing dynamics. Program includes maneuver logic and autopilots for glide slope, flare, landing, and takeoff and is modular so performance of aircraft in flight and during landing and ground maneuvers can be studied separately or in combination.

Carden, H. D.↗

Correlation and assessment of structural airplane crash data with flight parameters at impact

Crash deceleration pulse data from a crash dynamics program on general aviation airplanes and from transport crash data were analyzed. Structural airplane crash data and flight parameters at impact were correlated. Uncoupled equations for the normal and longitudinal floor impulses in the cabin area of the airplane were derived, and analytical expressions for structural crushing during impact and horizontal slide out were also determined. Agreement was found between experimental and analytical data for general aviation and transport airplanes over a relatively wide range of impact parameter. Two possible applications of the impulse data are presented: a postcrash evaluation of crash test parameters and an assumed crash scenario.

Carden, H. D.↗

Evaluation of Emergency-Locator-Transmitter performance in real and simulated crash tests

Emergency locator transmitter (ELT) activation problems were investigated by testing a sampling of ELT units in actual crashes and in a special test apparatus which simulated longitudinal crash pulses with superimposed local structural resonances. The probable causes of excessive false alarms and nonactivation of ELT's during crash situations were determined. Solutions to operational and technical problems were also examined as well as the sensitivity of ELT impact switches to orientation and to local structural vibrations.

Carden, H. D.↗

Aircraft subfloor response to crash loadings

Results are presented of an experimental and analytical study of the dynamic response to crash loadings of five different load-limiting subfloors for general aviation aircraft. These subfloors provide a high-strength structural floor platform to retain the seats and a crushable zone to absorb energy and limit vertical loads. Experimental static load-deflection data and dynamic deceleration response data for the five subfloors indicated that the high-strength floor platform performed well in that structural integrity and residual strength was maintained throughout the loading cycle. The data also indicated that some of the subfloor crush zones were more effective than others in providing nearly constant load for a range of displacement. The analytical data was generated by characterizing the nonlinear crush zones of the subfloor with static load-deflection data and using the DYCAST nonlinear finite element computer program. Comparisons between experimental and analytical data showed good correlation for the subfloors in which the static deformation mode closely approximated the dynamic deformation mode.

Carden, H. D.↗

NASA/FAA general aviation crash dynamics program

The program involves controlled full scale crash testing, nonlinear structural analyses to predict large deflection elastoplastic response, and load attenuating concepts for use in improved seat and subfloor structure. Both analytical and experimental methods are used to develop expertise in these areas. Analyses include simplified procedures for estimating energy dissipating capabilities and comprehensive computerized procedures for predicting airframe response. These analyses are developed to provide designers with methods for predicting accelerations, loads, and displacements on collapsing structure. Tests on typical full scale aircraft and on full and subscale structural components are performed to verify the analyses and to demonstrate load attenuating concepts. A special apparatus was built to test emergency locator transmitters when attached to representative aircraft structure. The apparatus is shown to provide a good simulation of the longitudinal crash pulse observed in full scale aircraft crash tests.

Thomson, R. G.↗

Evaluation of emergency-locator-transmitter performance in real and simulated crash tests

Emergency locator transmitter (ELT) activation problems were investigated by testing a sampling of ELT units in actual airplane crashes and in a special test apparatus which simulated longitudinal crash pulses with superimposed local structural resonances. Probable causes of excessive false alarms and nonactivations of ELT's during crash situations were determined and solutions to the current operational and technical problems were obtained. The results, which considered placement, mounting, and activation of ELT's under simulated crash impacts, and an evaluation of the sensitivity of ELT impact switches to orientation and to local structural vibrations are discussed.

Carden, H. D.↗

Analytical investigation of the landing dynamics of a large airplane with a load-control system in the main landing gear

The results of an evaluation of an active load-control landing gear computer program (ACOLAG) for predicting the landing dynamics of airplanes with passive and active main gears are presented. ACOLAG was used in an analytical investigation of the landing dynamics of a large airplane with both passive and active main gears. It was concluded that the program is valid for predicting the landing dynamics of airplanes with both passive and active main gears. It was shown that the active gear reduces airframe-gear forces and airplane motions following initial impact, and has the potential for significant reductions in structural fatigue damage relative to that which occurs with the passive gear.

Mcgehee, J. R.↗

NASA/FAA general aviation crash dynamics program - An update

Work in progress in the NASA/FAA General Aviation Crash Dynamics Program for the development of technology for increased crash-worthiness and occupant survivability of general aviation aircraft is presented. Full-scale crash testing facilities and procedures are outlined, and a chronological summary of full-scale tests conducted and planned is presented. The Plastic and Large Deflection Analysis of Nonlinear Structures and Modified Seat Occupant Model for Light Aircraft computer programs which form part of the effort to predict nonlinear geometric and material behavior of sheet-stringer aircraft structures subjected to large deformations are described, and excellent agreement between simulations and experiments is noted. The development of structural concepts to attenuate the load transmitted to the passenger through the seats and subfloor structure is discussed, and an apparatus built to test emergency locator transmitters in a realistic environment is presented.

Hayduk, R. J.↗

Vibration characteristics of walls and a plate glass window representative of those of a wood-frame house

Mechanical excitation was used, and measurements of acceleration response, natural frequencies, and nodal patterns were performed. Results indicate that the wall sections and the complete wall did not act as a unit in responding to sinusoidal vibration inputs. Calculated frequencies of the components that account for this independent behavior of the studs and face sheets agreed resonably well with experimental frequencies. Experimental vibrations of the plate glass window agreed with the calculated behavior, and responses of the window exposed to airplane flyover noise were readily correlated with the test results.

Carden, H. D.↗