Engineering topics

Captain, K. M.

Publications and source records attributed to Captain, K. M..

6 records

NASA NTRS1981

Experimental and analytical studies of advanced air cushion landing systems

Several concepts are developed for air cushion landing systems (ACLS) which have the potential for improving performance characteristics (roll stiffness, heave damping, and trunk flutter), and reducing fabrication cost and complexity. After an initial screening, the following five concepts were evaluated in detail: damped trunk, filled trunk, compartmented trunk, segmented trunk, and roll feedback control. The evaluation was based on tests performed on scale models. An ACLS dynamic simulation developed earlier is updated so that it can be used to predict the performance of full-scale ACLS incorporating these refinements. The simulation was validated through scale-model tests. A full-scale ACLS based on the segmented trunk concept was fabricated and installed on the NASA ACLS test vehicle, where it is used to support advanced system development. A geometrically-scaled model (one third full scale) of the NASA test vehicle was fabricated and tested. This model, evaluated by means of a series of static and dynamic tests, is used to investigate scaling relationships between reduced and full-scale models. The analytical model developed earlier is applied to simulate both the one third scale and the full scale response.

Lee, E. G. S.↗

NASA NTRS1978

Air cushion landing system

Static and dynamic performance of air cushion landing system is simulated in computer program that treats four primary ACLS subsystems: fan, feeding system, trunk, and cushion. Configuration of systems is sufficiently general to represent variety of practical designs.

Boghami, K. M.↗

NASA NTRS1978

Heave-pitch-roll analysis and testing of air cushion landing systems

The analytical tools (analysis and computer simulation) needed to explain and predict the dynamic operation of air cushion landing systems (ACLS) is described. The following tasks were performed: the development of improved analytical models for the fan and the trunk; formulation of a heave pitch roll analysis for the complete ACLS; development of a general purpose computer simulation to evaluate landing and taxi performance of an ACLS equipped aircraft; and the verification and refinement of the analysis by comparison with test data obtained through lab testing of a prototype cushion. Demonstration of simulation capabilities through typical landing and taxi simulation of an ACLS aircraft are given. Initial results show that fan dynamics have a major effect on system performance. Comparison with lab test data (zero forward speed) indicates that the analysis can predict most of the key static and dynamic parameters (pressure, deflection, acceleration, etc.) within a margin of a 10 to 25 percent.

Boghani, A. B.↗

NASA NTRS1978

Characteristics of an Air Cushion Landing System incorporating an inelastic trunk

A series of static and dynamic tests performed on an Air Cushion Landing System (ACLS) incorporating inelastic trunk are described. The tests were performed on an apparatus which had provisions to isolate heave-pitch and roll motion on the prototype cushion. The results of the test show that the sides of the trunk behave differently from the trunk ends. The tests also demonstrate that the current ACLS designs suffer from low heave damping, low roll stiffness and fan stall problems.

Boghani, A. B.↗

NASA NTRS1977

Air-cushion landing systems

Computer program based on heave/pitch analysis simulates dynamic behavior during landing impact and taxi over irregular runway. Program can be adapted to run on any computer with FORTRAN compiler.

Captain, K. M.↗

NASA NTRS1975

Dynamic heave-pitch analysis of air cushion landing systems

A program to develop analytical tools for evaluating the dynamic performance of Air Cushion Landing Systems (ACLS) is described. The heave (vertical) motion of the ACLS was analyzed, and the analysis was extended to cover coupled heave-pitch motions. The mathematical models developed are based on a fundamental analysis of the body dynamics and fluid mechanics of the aircraft-cushion-runway interaction. The air source characteristics, flow losses in the feeding ducts, trunk and cushion, the effects of fluid compressibility, and dynamic trunk deflections, including ground contact are considered. A computer program, based on the heave-pitch analysis, was developed to simulate the dynamic behavior of an ACLS during landing impact and taxi over an irregular runway. The program outputs include ACLS motions, loadings, pressures, and flows as a function of time. To illustrate program use, three basic types of simulations were carried out. The results provide an initial indication of ACLS performance during (1) a static drop, (2) landing impact, and (3) taxi over a runway irregularity.

Captain, K. M.↗