Engineering topics

Canabal, F.

Publications and source records attributed to Canabal, F..

3 records

NASA NTRS2019

Analysis of Base-Heating Environment During Ground Testing of a Lunar Lander Demonstrator

A three-dimensional, unstructured-grid, pressure-based, reacting flow, computational fluid dynamics (CFD) and heat transfer methodology was employed to study the base-heating environment of a lunar lander demonstrator, during terrestrial ground testing. Two base-heating environments were investigated: lunar lander demonstrator sitting on pad, and lunar lander demonstrator hovering at a distance above ground. Two unique and quite different base-flow physics are found for these two cases. In the case of demonstrator sitting on pad, the computed heat fluxes are high and the base flow is unsteady, caused by a Coanda effect precursor that makes the fountain jet oscillate about the center of the base. For the second case, due to the higher elevation of the demonstrator and the layout of the nozzles, the Coanda effect forces the fountain jet to be attached to two of the nozzle plumes, resulting in much lower computed base heat fluxes.

Wang, T. S.↗

NASA NTRS2011

Ares I-X Ascent Base Environments

Plume induced base heating environments were measured during the flight of the NASA Constellation Ares I-X developmental launch vehicle, successfully flown on October 28, 2009. The Ares IX first stage is a four segment Space Shuttle derived booster with base consisting of a flared aft skirt, deceleration and tumble motors, and a thermal curtain surrounding the first stage 7.2 area ratio nozzle. Developmental Flight Instrumentation (DFI) consisted of radiometers, calorimeters, pressure transducers and gas temperature probes installed on the aft skirt and nozzle to measure the base environments. In addition, thermocouples were also installed between the layers of the flexible thermal curtain to provide insight into the curtain response to the base environments and to assist in understanding curtain failure during reentry. Plume radiation environment predictions were generated by the Reverse Monte Carlo (RMC) code and the convective base heating predictions utilized heritage MSFC empirical methods. These predictions were compared to the DFI data and results from the flight videography. Radiation predictions agreed with the flight measured data early in flight but gauge failures prevented high altitude comparisons. The convective environment comparisons demonstrated the need to improve the prediction methodology; particularly for low altitude, local plume recirculation. The convective comparisons showed relatively good agreement at altitudes greater than 50,000 feet.

Mobley, B. L.↗

NASA NTRS1996

Ascent Aerodynamic Pressure Distributions on WB001

To support the reusable launch vehicle concept study, the aerodynamic data and surface pressure for WB001 were predicted using three computational fluid dynamic (CFD) codes at several flow conditions between code to code and code to aerodynamic database as well as available experimental data. A set of particular solutions have been selected and recommended for use in preliminary conceptual designs. These computational fluid dynamic (CFD) results have also been provided to the structure group for wing loading analysis.

Vu, B.↗