Engineering Papers⌕ Search

Engineering topics

Campbell, J. W.

Publications and source records attributed to Campbell, J. W..

32 records · Page 2

Three-dimensional random earth atmospheres for Monte Carlo trajectory analyses

A set of four computer tapes containing random three dimensional Earth atmospheres is available for Monte Carlo trajectory analyses. The tapes contain sufficient atmospheric tables to allow replications of any trajectory below an altitude of 99 km. The atmospheres were provided by an empirical model designed to generate random atmospheres whose distributions match those in a data base of sounding rocket measurements. A readily implementable means of linking the tapes to any existing trajectory simulation computer program is described involving the addition of three subroutines which are listed in an appendix.

Campbell, J. W.↗

Choosing reliability level for Shuttle-carried payloads

The paramount importance of high payload reliability is questioned in the light of payload recoverability in Spacelab and Space Shuttle experiments, and cost effectiveness through less stringent reliability requirements backed up by recovery and reflight of the experiment if necessary is considered. Ground rules and parameters for assessing reliability and recoverability in relation to mission cost effectiveness are advanced. Mission success probability (for one or several flights), experiment hardware cost, design reliability, cost of orbiting the experiment, support system reliability, and other relevant parameters are identified and discussed, and graphs of experimental total cost envelope are plotted. It is proposed that reliability and quality assurance standards be weighed against failure costs and penalties in the case of recoverable space systems.

Campbell, J. W.↗

A cost assessment of reliability requirements for shuttle-recoverable experiments

The relaunching of unsuccessful experiments or satellites will become a real option with the advent of the space shuttle. An examination was made of the cost effectiveness of relaxing reliability requirements for experiment hardware by allowing more than one flight of an experiment in the event of its failure. Any desired overall reliability or probability of mission success can be acquired by launching an experiment with less reliability two or more times if necessary. Although this procedure leads to uncertainty in total cost projections, because the number of flights is not known in advance, a considerable cost reduction can sometimes be achieved. In cases where reflight costs are low relative to the experiment's cost, three flights with overall reliability 0.9 can be made for less than half the cost of one flight with a reliability of 0.9. An example typical of shuttle payload cost projections is cited where three low reliability flights would cost less than $50 million and a single high reliability flight would cost over $100 million. The ratio of reflight cost to experiment cost is varied and its effect on the range in total cost is observed. An optimum design reliability selection criterion to minimize expected cost is proposed, and a simple graphical method of determining this reliability is demonstrated.

Campbell, J. W.↗

A Monte Carlo analysis of the Viking lander dynamics at touchdown

The performance of the Viking lander has been evaluated by using a Monte Carlo simulation, and all results are presented in statistical form. The primary objectives of this analysis were as follows: (1) to determine the three sigma design values of maximum rigid body accelerations and the minimum clearance of the lander body during landing; (2) to determine the probability of an unstable landing; and (3) to determine the probability of the lander body striking a rock. Two configurations were analyzed with the only difference being in the ability of the primary landing gear struts to carry tension loads.

Muraca, R. J.↗

The asymptotic distribution of maxima in bivariate samples

The joint distribution (as n tends to infinity) of the maxima of a sample of n independent observations of a bivariate random variable (X,Y) is studied. A method is developed for deriving the asymptotic distribution of the maxima, assuming that X and Y possess asymptotic extreme-value distributions and that the probability element dF(x,y) can be expanded in a canonical series. Applied both to the bivariate normal distribution and to the bivariate gamma and compound correlated bivariate Poisson distributions, the method shows that maxima from all these distributions are asymptotically uncorrelated.

Campbell, J. W.↗

The Development of a Stochastic Model of the Atmosphere Between 30 and 90 Km to Be Used in Determining the Effect of Atmospheric Variability on Space Shuttle Entry Parameters

A stochasitc model of the atmosphere between 30 and 90 km was developed for use in Monte Carlo space shuttle entry studies. The model is actually a family of models, one for each latitude-season category as defined in the 1966 U.S. Standard Atmosphere Supplements. Each latitude-season model generates a pseudo-random temperature profile whose mean is the appropriate temperature profile from the Standard Atmosphere Supplements. The standard deviation of temperature at each altitude for a given latitude-season model was estimated from sounding-rocket data. Departures from the mean temperature at each altitude were produced by assuming a linear regression of temperature on the solar heating rate of ozone. A profile of random ozone concentrations was first generated using an auxiliary stochastic ozone model, also developed as part of this study, and then solar heating rates were computed for the random ozone concentrations.

Campbell, J. W.↗

The effect of random fluctuations in atmospheric density on significant space shuttle reentry parameters.

The effects of realistic atmospheric density variations on reentry vehicles are investigated with the aid of a random model of atmospheric density and a series of Monte Carlo reentry trajectories generated for a typical delta-wing orbiter design. The random behavior of five major performance indicators is studied, namely, maximum dynamic pressure, maximum g load, maximum stagnation heating rate, down-range distance, and cross-range distance.

Campbell, J. W.↗

Reconnaissance of Mars satellites

Phobos and Deimos photographic reconnaissance feasibility during 1971 Orbiter and 1973 Viking missions, studying trajectory

Campbell, J. W.↗

Reconnaissance of Mars satellites

Phobos and Deimos photographic reconnaissance feasibility during 1971 orbiter and 1973 Viking missions, studying trajectory

Campbell, J. W.↗