Engineering Papers⌕ Search

Engineering topics

Calegari Andrade, Marcos F.

Publications and source records attributed to Calegari Andrade, Marcos F..

12 records
All sourcesNASA NTRSDOE OSTI
DOE OSTI2026

Activationof Oxygen Evolution Electrocatalysis viaReduced Ruthenium–Oxygen–Ruthenium Coordination

Noble metal oxides such as RuO2 are the state-of-the-art electrocatalysts for anodic reactions in acidic electrolytes, but their scarcity and moderate activity greatly limit emerging renewable energy technologies. Here, we show that oxidized overlayers of ruthenium on earth-abundant manganese oxide (MnO2/o-RuOx) nanocrystal supports exhibit Ru chemical states associated with reduced Ru–O–Ru coordination that enable dynamic switching of hydrogen bonding, with *OH intermediates hydrogen bonding to surface O and *OOH intermediates bonding to protruding RuOx clusters. The resulting electrocatalysts exhibit an overpotential of 218.9 ± 0.3 mV at 10 mA cm–2 for the oxygen evolution reaction in acid, corresponding to a 2425% increase in Ru mass activity compared to RuO2, enabling the construction of electrolyzers that achieved 3 A cm–2 at 1.646 V, 5.54 A cm–2 at 1.8 V, and exhibited over 3000-h stability at 100 mA cm–2. These findings motivate further efforts to develop nanomaterials that harness reduced Ru–O–Ru coordination to enable emerging renewable energy technologies.

58 GEOSCIENCES↗
DOE OSTI2024

Molecular-scale insights into the electrical double layer at oxide-electrolyte interfaces

The electrical double layer (EDL) at metal oxide-electrolyte interfaces critically affects fundamental processes in water splitting, batteries, and corrosion. However, limitations in the microscopic-level understanding of the EDL have been a major bottleneck in controlling these interfacial processes. Herein, we use ab initio-based machine learning potential simulations incorporating long-range electrostatics to unravel the molecular-scale picture of the EDL at the prototypical anatase TiO 2 -electrolyte interface under various pH conditions. Our large-scale simulations, capable of capturing interfacial water dissociation/recombination reactions and electrolytic proton transport, provide unprecedented insights into the detailed structure of the EDL. Moreover, the larger capacitance of the EDL under basic relative to acidic conditions, originating from the higher affinity of the cations for the oxide surface, is found to give rise to distinct charging mechanisms on negative and positive surfaces. Our results are validated by the agreement between the computed EDL capacitance and experimental data.

Chemical physics↗
DOE OSTI2024

Nuclear Quantum Effects on the Electronic Structure of Water and Ice

The electronic properties and optical response of ice and water are intricately shaped by their molecular structure, including the quantum mechanical nature of the hydrogen atoms. Despite numerous previous studies, a comprehensive understanding of the nuclear quantum effects (NQEs) on the electronic structure of water and ice at finite temperatures remains elusive. Here, we utilize molecular simulations that harness efficient machine-learning potentials and many-body perturbation theory to assess how NQEs impact the electronic bands of water and hexagonal ice. By comparing path-integral and classical simulations, we find that NQEs lead to a larger renormalization of the fundamental gap of ice, compared to that of water, ultimately yielding similar bandgaps in the two systems, consistent with experimental estimates. Our calculations suggest that the increased quantum mechanical delocalization of protons in ice, relative to water, is a key factor leading to the enhancement of NQEs on the electronic structure of ice.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2024

Confinement Effects on Proton Transfer in TiO 2 Nanopores from Machine Learning Potential Molecular Dynamics Simulations

Improved understanding of proton transfer in nanopores is critical for a wide range of emerging applications, yet experimentally probing mechanisms and energetics of this process remains a significant challenge. To help reveal details of this process, we developed and applied a machine learning potential derived from first-principles calculations to examine water reactivity and proton transfer in TiO 2 slit-pores. Here, we find that confinement of water within pores smaller than 0.5 nm imposes strong and complex effects on water reactivity and proton transfer. Although the proton transfer mechanism is similar to that at a TiO 2 interface with bulk water, confinement reduces the activation energy of this process, leading to more frequent proton transfer events. This enhanced proton transfer stems from the contraction of oxygen–oxygen distances dictated by the interplay between confinement and hydrophilic interactions. Our simulations also highlight the importance of the surface topology, where faster proton transport is found in the direction where a unique arrangement of surface oxygens enables the formation of an ordered water chain. In a broader context, our study demonstrates that proton transfer in hydrophilic nanopores can be enhanced by controlling pore size, surface chemistry, and topology.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Integrating Machine Learning Potential and X-ray Absorption Spectroscopy for Predicting the Chemical Speciation of Disordered Carbon Nitrides

Precise determination of atomic structural information in functional materials holds transformative potential and broad implications for emerging technologies. Spectroscopic techniques, such as X-ray absorption near-edge structure (XANES), have been widely used for material characterization; however, extracting chemical information from experimental probes remains a significant challenge, particularly for disordered materials. We present an integrated approach that combines atomic simulations, data-driven techniques, and experimental measurements to investigate chemical speciation of amorphous carbon nitride systems as a case study. Here, we discuss the development of machine learning potentials that can efficiently explore the vast configuration space of amorphous carbon nitrides. By employing statistical methods, this structural database enables the elucidation of the most representative local structures and how they evolve with chemical compositions and density. Density functional theory simulations are used to establish a correlation between the local structure and spectroscopic signatures, which then serve as the basis for interpreting and extracting chemical content from experimental data. Although our framework is specifically demonstrated for XANES and carbon nitrides, the approach described herein is readily adaptable as applied to other experimental characterization probes and materials classes.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Probing the active sites of oxide encapsulated electrocatalysts with controllable oxygen evolution selectivity

Electrocatalysts encapsulated by nanoscopic overlayers can control the rate of redox reactions at the outer surface of the overlayer or at the buried interface between the overlayer and the active catalyst, leading to complex behavior in the presence of two competing electrochemical reactions. This study investigated oxide encapsulated electrocatalysts (OECs) comprised of iridium (Ir) thin films coated with an ultrathin (2–10 nm thick) silicon oxide (SiO x ) or titanium oxide (TiO x ) overlayer. The performance of SiO x |Ir and TiO x |Ir thin film electrodes towards the oxygen evolution reaction (OER) and Fe(II)/Fe(III) redox reactions were evaluated. An improvement in selectivity towards the OER was observed for all OECs. Overlayer properties, namely ionic and electronic conductivity, were assessed using a combination of electroanalytical methods and molecular dynamics simulations. SiO x and TiO x overlayers were found to be permeable to H 2 O and O 2 such that the OER can occur at the MO x |Ir (M = Ti, Si) buried interface, which was further supported with molecular dynamics simulations of model SiO 2 coatings. In contrast, Fe(II)/Fe(III) redox reactions occur to the same degree with TiO x overlayers having thicknesses less than 4 nm as bare electrocatalyst, while SiO x overlayers inhibit redox reactions at all thicknesses. This observation is attributed to differences in electronic transport between the buried interface and outer overlayer surface, as measured with through-plane conductivity measurements of wetted overlayer materials. These findings reveal the influence of oxide overlayer properties on the activity and selectivity of OECs and suggest opportunities to tune these properties for a wide range of electrochemical reactions.

08 HYDROGEN↗
DOE OSTI2023

Elucidating the water–anatase TiO 2 (101) interface structure using infrared signatures and molecular dynamics

The structure and dynamics of water on solid surfaces critically affect the chemistry of materials in ambient and aqueous environments. Here, we investigate the hydrogen bonding network of water adsorbed on the majority (101) surface of anatase TiO 2 , a widely used photocatalyst, using polarization- and azimuth-resolved infrared spectroscopy combined with neural network potential molecular dynamics simulations. Our results show that one monolayer of water saturates the undercoordinated titanium (Ti 5c ) sites, forming one-dimensional chains of molecule hydrogen bonded to surface undercoordinated bridging oxygen (O 2c ) atoms. As the coverage increases, water adsorption on O 2c sites leads to significant restructuring of the water monolayer and the formation of a two-dimensional hydrogen bond network characterized by tightly bound pairs of water molecules on adjacent Ti 5c and O 2c sites. This structural motif likely persists at ambient conditions, influencing the reactions occurring there. In conclusion, the results reported here provide critical details of the structure of the water–anatase (101) interface that were previously hypothesized but unconfirmed experimentally.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Characterizing Structure-Dependent TiS 2 /Water Interfaces Using Deep-Neural-Network-Assisted Molecular Dynamics

As a promising layered electrode material, TiS 2 -based capacitive deionization (CDI) devices for water desalination have attracted significant attention. However, TiS 2 /H 2 O interfacial features, potentially important for device optimization, remain unidentified. Using Deep Potential Molecular Dynamics (DPMD), we characterized distinct aqueous interfaces introduced by four TiS 2 terminations expected to be present as water intercalates into TiS 2 , namely, Armchair, Zigzag, Zigzag-L, and Zigzag-R. First, we assessed important representative physical properties of the system to validate the deep potentials (DPs). DPMD simulations agree well with experiments and first-principles simulations, suggesting the DPs are accurate and reliable. Subsequent simulations of these TiS 2 /water interfaces revealed how TiS 2 surface termination influences the structure of interfacial water. This effect is most evident in the first and second water layers close to the TiS 2 surface, and more pronounced when spontaneous dissociative adsorption of water occurs. The extent of water dissociation on each surface was evaluated using enhanced sampling. Zigzag-L is the only interface where proton transfer from adsorbed water to TiS 2 surface S atoms is thermodynamically and kinetically favored. The coexistence of surface four-fold-coordinated Ti (Ti 4c ) and one-fold-coordinated S (S 1c ) is found to be essential to making proton transfer feasible on the Zigzag-L surface. Furthermore, remaining unprotonated S 1c atoms can act as good proton acceptors after water dissociation. Thus, TiS 2 with Zigzag-L termination may be a surface to avoid in CDI device construction, given that pH fluctuations adversely affect performance. Furthermore, this work provides new understanding of TiS 2 /H 2 O interfacial features that could aid future design and optimization of TiS 2 -based CDI devices for water desalination.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
DOE OSTI2023

Water dissociation at the water–rutile TiO 2 (110) interface from ab initio-based deep neural network simulations

The interaction of water with TiO 2 surfaces is of crucial importance in various scientific fields and applications, from photocatalysis for hydrogen production and the photooxidation of organic pollutants to self-cleaning surfaces and bio-medical devices. In particular, the equilibrium fraction of water dissociation at the TiO 2 –water interface has a critical role in the surface chemistry of TiO 2 , but is difficult to determine both experimentally and computationally. Among TiO 2 surfaces, rutile TiO 2 (110) is of special interest as the most abundant surface of TiO 2 ’s stable rutile phase. While surface-science studies have provided detailed information on the interaction of rutile TiO 2 (110) with gas-phase water, much less is known about the TiO 2 (110)–water interface, which is more relevant to many applications. In this work, we characterize the structure of the aqueous TiO 2 (110) interface using nanosecond timescale molecular dynamics simulations with ab initio-based deep neural network potentials that accurately describe water/TiO 2 (110) interactions over a wide range of water coverages. Simulations on TiO 2 (110) slab models of increasing thickness provide insight into the dynamic equilibrium between molecular and dissociated adsorbed water at the interface and allow us to obtain a reliable estimate of the equilibrium fraction of water dissociation. We find a dissociation fraction of 22 ± 6% with an associated average hydroxyl lifetime of 7.6 ± 1.8 ns. These quantities are both much larger than corresponding estimates for the aqueous anatase TiO 2 (101) interface, consistent with the higher water photooxidation activity that is observed for rutile relative to anatase.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗