Engineering topics

Cabot, William H.

Publications and source records attributed to Cabot, William H..

8 records

NASA NTRS1994

Local dynamic subgrid-scale models in channel flow

The dynamic subgrid-scale (SGS) model has given good results in the large-eddy simulation (LES) of homogeneous isotropic or shear flow, and in the LES of channel flow, using averaging in two or three homogeneous directions (the DA model). In order to simulate flows in general, complex geometries (with few or no homogeneous directions), the dynamic SGS model needs to be applied at a local level in a numerically stable way. Channel flow, which is inhomogeneous and wall-bounded flow in only one direction, provides a good initial test for local SGS models. Tests of the dynamic localization model were performed previously in channel flow using a pseudospectral code and good results were obtained. Numerical instability due to persistently negative eddy viscosity was avoided by either constraining the eddy viscosity to be positive or by limiting the time that eddy viscosities could remain negative by co-evolving the SGS kinetic energy (the DLk model). The DLk model, however, was too expensive to run in the pseudospectral code due to a large near-wall term in the auxiliary SGS kinetic energy (k) equation. One objective was then to implement the DLk model in a second-order central finite difference channel code, in which the auxiliary k equation could be integrated implicitly in time at great reduction in cost, and to assess its performance in comparison with the plane-averaged dynamic model or with no model at all, and with direct numerical simulation (DNS) and/or experimental data. Other local dynamic SGS models have been proposed recently, e.g., constrained dynamic models with random backscatter, and with eddy viscosity terms that are averaged in time over material path lines rather than in space. Another objective was to incorporate and test these models in channel flow.

Cabot, William H.↗

NASA NTRS1993

Dynamic localization and second-order subgrid-scale models in large eddy simulations of channel flow

The objective here is to test the Dynamic Localization (DL) model in a wall-bounded channel flow for numerical stability and accuracy of results. Algebraic stress models suggest that the model for the residual subgrid-scale (SGS) Reynolds stress and scalar flux should generally have terms comprising most of the unique products of the resolved strain (S) and rotation (R) tensors with S and the resolved scalar gradient. The standard dynamic SGS model uses a simple (Smagorinsky) base model for the residual Reynolds stress, which is made proportional to S, and down-gradient base models for residual scalar fluxes; these correspond to the lowest, 'first-order' terms in algebraic stress models. Temporal scaling terms in these base models are formed from the magnitude of the resolved strain rate. While this is appropriate for simple shear flows, it may not be appropriate for more complicated flows (relevant to geophysical and astrophysical problems) that include any combination of shear, rotation, buoyancy, etc. On the other hand, the coefficient in the dynamic SGS model readily adjusts itself to different flow conditions and may adequately take account of these effects without the need for more complicated base models. Cabot (1993) has begun to test the dynamic SGS model in buoyant flows (Rayleigh-Benard and internally heated convection) with and without buoyancy terms explicitly included in the scaling terms of the base model; no great differences were found in large eddy simulation (LES) results for the different base model scalings. The second objective in this work is to test base models with additional, 'second-order' terms (e.g., S(sup 2) and RS for the residual Reynolds stress). These terms have been found to improve large-scale flow predictions by kappa-epsilon models in the presence of rotation and shear. Second-order base models will be tested here in the LES of channel flow with and without solid-body rotation and compared with results from the standard first-order base models to determine if there are significant differences or improvements in results that would warrant the added complexity of the second-order base models.

Cabot, William H.↗

NASA NTRS1993

Large eddy simulations of time-dependent and buoyancy-driven channel flows

The primary goal of this work has been to assess the performance of the dynamic SGS model in the large eddy simulation (LES) of channel flows in a variety of situations, viz., in temporal development of channel flow turned by a transverse pressure gradient and especially in buoyancy-driven turbulent flows such as Rayleigh-Benard and internally heated channel convection. For buoyancy-driven flows, there are additional buoyant terms that are possible in the base models, and one objective has been to determine if the dynamic SGS model results are sensitive to such terms. The ultimate goal is to determine the minimal base model needed in the dynamic SGS model to provide accurate results in flows with more complicated physical features. In addition, a program of direct numerical simulation (DNS) of fully compressible channel convection has been undertaken to determine stratification and compressibility effects. These simulations are intended to provide a comparative base for performing the LES of compressible (or highly stratified, pseudo-compressible) convection at high Reynolds number in the future.

Cabot, William H.↗

NASA NTRS1991

Numerical simulations of turbulent thermal convection with differential rotation

The solar nebula, from which the planets in our solar system formed, featured a disk of gas and dust grains in rapid, differential rotation, and at some stage was likely to have been unstable to thermal convection. This situation is suspected by many to lead to significant turbulent Reynolds stress production and angular momentum transport in such systems, and estimates of transport rates have been attempted from unsubstantiated phenomenological models. In order to determine the circumstances and physical conditions under which our own planetary system formed and to explain recent observations of young stellar systems, it is necessary to develop realistic models of heat and angular momentum transport for such flows. Developing an understanding of complicated flows featuring thermal convection, rotation, and shear is also of wide interest in stellar astrophysics and in planetary and terrestrial atmospheric studies. The ultimate objective is to develop workable models based on the numerical simulations for constructing global solar nebula models; viz., relatively simple prescriptions for heat and angular momentum fluxes from given system parameters (e.g., ratios of rotation, shear, and convective lapse rates) are characterized, quantified, and developed. Toward this end, our program has been to attempt to understand the behavior of the direct numerical simulations of Boussinesq convection, which, despite the complexity of the results, is still an overly simplified approximation to the real system and should be more amenable to analysis. These results are also intended to be tested against turbulence models, especially those designed for atmospheric boundary layers, and may provide a basis for subgrid-scale models. In order to make the numerical simulations more realistic with regard to the solar nebula problem, a fully compressible code that will allow incorporation of large density stratifications and realistic thermodynamic and radiative properties is developed. In order to explore the properties of these flows at the very high values of Re found in natural systems and the very low values of Pr found in most astrophysical contexts, we will need to employ large-eddy simulations for which we want to determine the most appropriate subgrid-scale model to incorporate.

Cabot, William H.↗

NASA NTRS1990

A dynamic subgrid-scale eddy viscosity model

One major drawback of the eddy viscosity subgrid-scale stress models used in large-eddy simulations is their inability to represent correctly with a single universal constant different turbulent field in rotating or sheared flows, near solid walls, or in transitional regimes. In the present work, a new eddy viscosity model is presented which alleviates many of these drawbacks. The model coefficient is computed dynamically as the calculation progresses rather than input a priori. The model is based on an algebraic identity (Germano 1990) between the subgrid-scale stresses at two different filtered levels and the resolved turbulent stresses. The subgrid-scale stresses obtained using the proposed model vanish in laminar flow and at a solid boundary, and have the correct asymptotic behavior in the near-wall region of a turbulent boundary layer. The results of large-eddy simulations of transitional and turbulent channel flow that use the proposed model are in good agreement with the direct simulation data.

Germano, Massimo↗

NASA NTRS1990

Subgrid-scale backscatter in transitional and turbulent flows

Most subgrid-scale (SGS) models for large-eddy simulations are absolutely dissipative (that is, they remove energy from the large scales at each point in the physical space). The actual SGS stresses, however, may transfer energy to the large scales (backscatter) at a given location. Direct numerical simulations of turbulent channel flow and compressible isotropic turbulence are used to study the backscatter phenomena. In all flows considered roughly 50 percent of the grid points were experiencing backscatter when a Fourier cutoff filter was used. The backscatter fraction was less with a Gaussian filter, and intermediate with a box filter in physical space. Moreover, the backscatter and forward scatter contributions to the SGS dissipation were comparable, and each was often much larger than the total SGS dissipation. The SGS dissipation (normalized by total dissipation) increased with filter width almost independently of filter type and Reynolds number. The amount of backscatter showed an increasing trend with Reynolds numbers. In the near-wall region of the channel, events characterized by strong Reynolds shear stress correlated fairly well with areas of high SGS dissipation (both forward and backward). In compressible isotropic turbulence similar results were obtained, independent of fluctuation Mach number.

Piomelli, Ugo↗

NASA NTRS1990

A subgrid-scale model based on the second-order velocity structure function

A series of tests were performed to help extend the use of a subgrid-scale model to compressible and wall-bounded flows. A priori tests were done in the case of the incompressible turbulent channel flow. They showed that a 1-D formulation of the structure-function model is more appropriate, leading to a satisfactory behavior of the model at the walls without requiring any damping function. This model is consistent with the original formulation of Metais & Lesieur (1990). In large-eddy simulations of compressible isotropic turbulence, both models performed well up to an initial rms Mach number of 0.6.

Comte, P.↗

NASA NTRS1989

Direct numerical simulations of turbulent convection with a variable gravity and Keplerian rotation

Thermal convection was proposed as a possible mechanism for generation and maintenance of turbulence in the inner accretion disk regime of the primordial solar nebula. It is of fundamental interest to design experiments with the basic physical features of the solar nebula conditions cannot be produced in the laboratory, numerical simulations of hydrodynamic flows, which have been very successful in describing aerodynamic flows, can be suitable modified to provide experimental data for solar nebula modelling. The goals are to modify an extant, proven hydrodynamics code with the most important features of the solar nebula and other thin accretion disks: bouyancy terms to generate convection, internal heating representing the release of gravitational potential energy, a variable gravity linearly proportional the the distance from the vertical midplane due to centrifugal balance, rapid rotation with axis aligned with gravity, and Keplerian rotational shear; to determine the effect that these features have on the turbulent convection by introducing them individually and to determine the cumulative nature of the turbulent convection for accretion disk conditions; and to model the convection and the turbulence. In this manner, prior solar nebula models can be tested and their deficiencies rectified.

Cabot, William H.↗