Surface Gravimetry Using Rover Navigation Systems
This prototype seeks to demonstrate the utility of repurposing a Micro-ElectroMechancical (MEMS) Inertial measurement Unit (IMU) to perform surface gravimetry on a rover. Gravimetry is a common analytical tool used for probing density distributions in the subsurface of a planetary body. Historically, extraterrestrial gravimetry has been confined to orbital platforms. While orbital surveys allow for the construction of global gravity models, the spatial resolution of the data is constrained by the platform’s orbital altitude and high inherent speed. Data collected at or near the surface would increase spatial resolution and allow finer-scale crustal structure to be resolved. To date, there have been only two extraterrestrial surface gravity surveys: the Apollo 17 Traverse Gravimeter Experiment and a survey using the MEMS accelerometers contained within the Curiosity rover’s IMUs. The Curiosity survey highlighted the potential of using MEMS technology to perform planetary gravimetry, albeit with lower sensitivities than traditional surface gravimeters. MEMS accelerometers are included on every rover platform as part of the IMU navigation systems. MEMS accelerometers have low mass, cost, and power requirements while being robust across a range of environments, whereas traditional gravimeters are fragile, costly, and relatively massive (≥8kg versus ≈50g for MEMS IMUs). Thus, the emergence of MEMS gravimeters provides a low-risk and cost-effective method for performing planetary surface gravimetry [3,4]. Here, we present a method to recalibrate the MEMS accelerometers in rover IMUs to collect gravimetric measurements. Such measurements could assist current and future rover missions and support wider efforts to mature MEMS gravimeters.