Engineering topics

Buice, Carl U.

Publications and source records attributed to Buice, Carl U..

3 records

NASA NTRS1996

Experimental Investigation of Flow Through an Asymmetrical Plane Diffuser

The objective of this study is to provide careful qualification and detailed measurements in a re-creation of the Obi experiment. The work will include extensive documentation of the flow two-dimensionality and detailed measurements required for testing of flow computations. Also important to this study is the close interaction of the experimental and computational groups to improve the utility of the data obtained and the accuracy of computation.

Buice, Carl U.↗

NASA NTRS1995

Experimental investigation of flow through an asymmetric plane diffuser

There is a need for experimental measurements in complex turbulent flows that originate from very well-defined initial conditions. Testing of large-eddy simulations and other higher-order computation schemes requires inlet boundary condition data that are not normally measured. The use of fully developed upstream conditions offers a solution to this dilemma so that the upstream conditions can be adequately computed at any level of sophistication. The plane diffuser experiment by Obi et al. (1993) has received a lot of attention because it has fully-developed inlet conditions and it includes separation from a smooth wall, subsequent reattachment and redevelopment of the downstream boundary layer. The objective of this study is to provide careful qualification and detailed measurements in a recreation of the Obi experiment. The work will include extensive documentation of the flow two-dimensionality and detailed measurements required for testing of flow computations.

Buice, Carl U.↗

NASA NTRS1995

Flow Over Swept Flaps and Flap Tips

Preliminary measurements have been made of the flow over the tip of an unswept wing flap. To achieve an acceptable Reynolds number based on flap chord, the flap chord was chosen equal to the chord of the main airfoil (c = 19 in. approx. 0.48 m). The model was mounted in a 30 in. x 30 in. wind tunnel running at up to 100 ft/sec. (30 m/s): severe wind-tunnel interference was accepted, and any computations would be done using the tunnel walls as the boundaries of the computational domain. Maximum Reynolds number based on flap chord and tunnel speed was about 1.O x lO(exp 6). The grant ended before a full set of measurements could be made, but the work done so far yields a useful picture of the flow. The vortex originates at about mid-chord on the flap and rises rapidly above the chord line. It has a concentrated core, with total pressure lower than the ambient static pressure, and there is no evidence of large-scale wandering. A simple method of model construction, giving light weight and excellent surface finish, was developed.

Bradshaw, Peter↗