Engineering topics
Publications and source records attributed to Buckley, D..
Small metal or other electrically conductive parts of same shape but different composition quickly sorted with differential-coil eddy-current sorter. Developed to distinguish between turbine blades of different alloys, hardnesses, and residual stress, sorter generally applicable to parts of simple and complex shape.
The HEAO-1 satellite has produced the most complete, all-sky, X-ray survey. The sources extend to levels as faint as 1/2 Uhuru Flux Unit (UFU), with uncertain completeness below 1.25 UFU. Approximately 350 out of 840 sources have certain or highly probable optical counterparts. The identifications are necessary for estimating distances to the objects, so that properties are measured intrinsic to the source, and for establishing the classifications of the astronomical systems. There is also the opportunity to obtain TENMA and EXOSAT observations of X-ray spectra and time variability, since in general almost nothing is known of the X-ray characteristics of these weaker sources. Methods are here reviewed and the new active galactic nuclei X-ray counterparts are discussed.
Based on data obtained with the HEAO-1 Scanning Modulation Collimator (MC) experiment, candidate Be star systems and BL Lac objects are reported. Identification of the V = 6.6 star HD91188 as a Be star is confirmed, and X-ray luminosities ranging from 9 x 10 to the 32nd to 1.4 x 10 to the 34th ergs/s are derived. A B2 spectral type with a reddening E(B - V) = 0.42 is deduced for a V = 9.87 star which appears in an MC location diamond for the source 1H0550 + 286. A V = 16.5 ultraviolet excess object in the location 2A1058 - 226 = 3A1057 - 224 = 4U1057 - 21 = H1100 - 230 gave a 20 cm flux of 83 mJy, and a V = 16.2 ultraviolet excess object at 3A1422 + 425 = 1H143 + 423 was found to have a 20 cm flux of 33 mJy, suggesting their classification as BL Lac objects.
The effects of both mechanical surface treatments and heat treatments on the erosion resistance of 6061 aluminum alloy were studied in order to gain a better understanding of material properties which affect erosion behavior. It was found that mechanical surface treatments have little or no effect on the erosion resistance. This is due to the formation by particle impact of a work-hardened surface layer, independent of the initial surface condition. The erosion resistance of aluminum single crystals was found to be independent of orientation, which is due to destruction of the surface microstructure and formation of a polycrystalline surface layer by the particle impact as observed by X-ray diffraction. Although on solution treatment of annealed aluminum 6061 the increase in hardness is accompanied by an increase in erosion resistance, precipitation treatment (which causes a further increase in hardness) results in a slightly lower erosion resistance.