Engineering Papers⌕ Search

Engineering topics

Bryant, Scott H.

Publications and source records attributed to Bryant, Scott H..

8 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS2007

Range Measurement as Practiced in the Deep Space Network

Range measurements are used to improve the trajectory models of spacecraft tracked by the Deep Space Network. The unique challenge of deep-space ranging is that the two-way delay is long, typically many minutes, and the signal-to-noise ratio is small. Accurate measurements are made under these circumstances by means of long correlations that incorporate Doppler rate-aiding. This processing is done with commercial digital signal processors, providing a flexibility in signal design that can accommodate both the traditional sequential ranging signal and pseudonoise range codes. Accurate range determination requires the calibration of the delay within the tracking station. Measurements with a standard deviation of 1 m have been made.

range measurement↗
NASA NTRS2001

Deep Space Network turbo decoder implementation

A new decoder is being developed by the Jet Propulsion Laboratory for NASA's Deep Space Network. This unit will decode the new turbo codes, which have recently been approved by the Consultative Committee for Space Data Systems (CCSDS). Turbo codes provide up to 0.8 dB improvement in Eb/No over the current best codes used by deep space missions.

turbo codes↗
NASA NTRS2001

Telemetry, tracking, and command consolidation in the Deep Space Network

Currently, in NASA's Deep Space Network (DSN), telemetry, tracking, and command (TT&C) functions are distributed between multiple subsystem computers. Control design of these subsystems did not consider the interaction necessary between the functions, which create opportunities for loss of data. Also, the current controller design can force the use of equipment that is not needed for the task at hand, to the detriment of others. As part of the Network Simplification Project (NSP), the TTC implementation has been re-examined, New telemetry and commanding equipment is being built, and the control of the TT&C functions is being consolidated into two controllers, Uplink and Downlink. The new equipment uses commercial components, as opposed to the custom built equipment it is replacing, which improves reliability and simplifies maintenance.

tracking↗
NASA NTRS2001

New tracking implementation in the Deep Space Network

As part of the Network Simplification Project, the tracking system of the Deep Space Network is being upgraded. This upgrade replaces the discrete logic sequential ranging system with a system that is based on commercial Digital Signal Processor boards. The new implementation allows both sequential and pseudo-noise types of ranging. The other major change is a modernization of the data formatting. Previously, there were several types of interfaces, delivering both intermediate data and processed data (called 'observables'). All of these interfaces were bit-packed blocks, which do not allow for easy expansion, and many of these interfaces required knowledge of the specific hardware implementations. The new interface supports four classes of data: raw (direct from the measuring equipment), derived (the observable data), interferometric (multiple antenna measurements), and filtered (data whose values depend on multiple measurements). All of the measurements are reported at the sky frequency or phase level, so that no knowledge of the actual hardware is required. The data is formatted into Standard Formatted Data Units, as defined by the Consultative Committee for Space Data Systems, so that expansion and cross-center usage is greatly enhanced.

ranging↗