Engineering topics

Broussard, J. R.

Publications and source records attributed to Broussard, J. R..

18 records

NASA NTRS1986

Extensions to PIFCGT: Multirate output feedback and optimal disturbance suppression

New control synthesis procedures for digital flight control systems were developed. The theoretical developments are the solution to the problem of optimal disturbance suppression in the presence of windshear. Control synthesis is accomplished using a linear quadratic cost function, the command generator tracker for trajectory following and the proportional-integral-filter control structure for practical implementation. Extensions are made to the optimal output feedback algorithm for computing feedback gains so that the multirate and optimal disturbance control designs are computed and compared for the advanced transport operating system (ATOPS). The performance of the designs is demonstrated by closed-loop poles, frequency domain multiinput sigma and eigenvalue plots and detailed nonlinear 6-DOF aircraft simulations in the terminal area in the presence of windshear.

Broussard, J. R.↗

NASA NTRS1985

Optimal disturbance suppression with application to wind shear

A novel quadratic cost function composed of stochastic and deterministic contributions is used in the design of a digital flight control system for a small commercial jet with wind shear present. The optimal output feedback control design is configured to suppress the effect of the wind shear disturbance and maintain closed loop stability. A new algorithm is presented for finding the feedback gain. A proportional-integral control design with wind shear suppression is tested in a detailed nonlinear simulation of a commercial jet during the landing approach.

Broussard, J. R.↗

NASA NTRS1984

Investigation and appreciation of optimal output feedback. Volume 1: A convergent algorithm for the stochastic infinite-time discrete optimal output feedback problem

The stochastic, infinite time, discrete output feedback problem for time invariant linear systems is examined. Two sets of sufficient conditions for the existence of a stable, globally optimal solution are presented. An expression for the total change in the cost function due to a change in the feedback gain is obtained. This expression is used to show that a sequence of gains can be obtained by an algorithm, so that the corresponding cost sequence is monotonically decreasing and the corresponding sequence of the cost gradient converges to zero. The algorithm is guaranteed to obtain a critical point of the cost function. The computational steps necessary to implement the algorithm on a computer are presented. The results are applied to a digital outer loop flight control problem. The numerical results for this 13th order problem indicate a rate of convergence considerably faster than two other algorithms used for comparison.

Halyo, N.↗

NASA NTRS1984

Investigation, development and application of optimal output feedback theory. Volume 2: Development of an optimal, limited state feedback outer-loop digital flight control system for 3-D terminal area operation

This report contains the development of a digital outer-loop three dimensional radio navigation (3-D RNAV) flight control system for a small commercial jet transport. The outer-loop control system is designed using optimal stochastic limited state feedback techniques. Options investigated using the optimal limited state feedback approach include integrated versus hierarchical control loop designs, 20 samples per second versus 5 samples per second outer-loop operation and alternative Type 1 integration command errors. Command generator tracking techniques used in the digital control design enable the jet transport to automatically track arbitrary curved flight paths generated by waypoints. The performance of the design is demonstrated using detailed nonlinear aircraft simulations in the terminal area, frequency domain multi-input sigma plots, frequency domain single-input Bode plots and closed-loop poles. The response of the system to a severe wind shear during a landing approach is also presented.

Broussard, J. R.↗

NASA NTRS1984

Algorithms for output feedback, multiple-model, and decentralized control problems

The optimal stochastic output feedback, multiple-model, and decentralized control problems with dynamic compensation are formulated and discussed. Algorithms for each problem are presented, and their relationship to a basic output feedback algorithm is discussed. An aircraft control design problem is posed as a combined decentralized, multiple-model, output feedback problem. A control design is obtained using the combined algorithm. An analysis of the design is presented.

Halyo, N.↗

NASA NTRS1983

PIFCGT: A PIF autopilot design program for general aviation aircraft

This report documents the PIFCGT computer program. In FORTRAN, PIFCGT is a computer design aid for determing Proportional-Integral-Filter (PIF) control laws for aircraft autopilots implemented with a Command Generator Tracker (CGT). The program uses Linear-Quadratic-Regulator synthesis algorithms to determine feedback gains, and includes software to solve the feedforward matrix equation which is useful in determining the command generator tracker feedforward gains. The program accepts aerodynamic stability derivatives and computes the corresponding aerodynamic linear model. The nine autopilot modes that can be designed include four maneuver modes (ROLL SEL, PITCH SEL, HDG SEL, ALT SEL), four final approach models (APR GS, APR LOCI, APR LOCR, APR LOCP), and a BETA HOLD mode. The program has been compiled and executed on a CDC computer.

Broussard, J. R.↗

NASA NTRS1983

Design, implementation and flight testing of PIF autopilots for general aviation aircraft

The designs of Proportional-Integrated-Filter (PIF) auto-pilots for a General Aviation (NAVION) aircraft are presented. The PIF autopilot uses the sampled-data regulator and command generator tracking to determine roll select, pitch select, heading select, altitude select and localizer/glideslope capture and hold autopilot modes. The PIF control law uses typical General Aviation sensors for state feedback, command error integration for command tracking, digital complementary filtering and analog prefiltering for sensor noise suppression, a control filter for computation delay accommodation and the incremental form to eliminate trim values in implementation. Theoretical developments described in detail, were needed to combine the sampled-data regulator with command generator tracking for use as a digital flight control system. The digital PIF autopilots are evaluated using closed-loop eigenvalues and linear simulations. The implementation of the PIF autopilots in a digital flight computer using a high order language (FORTRAN) is briefly described. The successful flight test results for each PIF autopilot mode is presented.

Broussard, J. R.↗

NASA NTRS1983

ATOPS B-737 inner-loop control system linear model construction and verification

Nonlinear models and block diagrams of an inner-loop control system for the ATOPS B-737 Research Aircraft are presented. Continuous time linear model representations of the nonlinear inner-loop control systems are derived. Closed-loop aircraft simulations comparing nonlinear and linear dynamic responses to step inputs are used to verify the inner-loop control system models.

Broussard, J. R.↗

NASA NTRS1983

Design and flight testing of a digital landing approach autopilot

An important feature in General Aviation (GA) autopilots is the ability to intercept and hold the glideslope and localizer during a landing approach. Most General Aviation landing approach autopilots available today use analog systems. This paper presents the designs of digital landing approach autopilots for a General Aviation (NAVION) aircraft using modern linear quadratic control theory. Each constant gain, direct digitally designed autopilot operates synchronously at a slow rate (10 samples per second) and has modest memory requirements, i.e., a full state Kalman filter is not used. The autopilot is designed to track desired position trajectories constructed in an ILS or MLS terminal area using command generators. Alternative command errors for intercepting and holding the localizer beam centerline are investigated. Linear simulations and flight test results are presented demonstrating the successful application of the linear quadratic regulator approach.

Broussard, J. R.↗

NASA NTRS1983

Active flutter control using discrete optimal constrained dynamic compensators

A method for synthesizing digital active flutter suppression controllers using the concept of optimal output feedback is presented. A recently developd convergent algorithm is employed to determine constrained control law parameters that minimize an infinite-time discrete quadratic performance index. Low-order compensator dynamics are included in the control law and the compensator parameters are computed along with the output feedback gain as part of the optimization process. An input noise adjustment procedure is used to improve the stability margins of the digital active flutter controller. Results from investigations into sample rate variation, prefilter pole variation, and effects of varying flight condtions are discussed. The study indicates that a digital control law which accommodates computation delay can stabilize the wing with reasonable rms performance and adequate stability margins.

Broussard, J. R.↗

NASA NTRS1982

Pilot model hypothesis testing

The aircraft control time history predicted by the optimal control pilot model and actual pilot tracking data obtained from NASA Langley's differential maneuvering simulator (DMS) are analyzed. The analysis is performed using a hypothesis testing scheme modified to allow for changes in the true hypothesis. A finite number of pilot models, each with different hypothesized internal model representations of the aircraft dynamics, are constructed. The hypothesis testing scheme determines the relative probability that each pilot model best matches the DMS data. By observing the changes in probabilities, it is possible to determine when the pilot changes control strategy and which hypothesized pilot model best represent's the pilot's control behavior.

Broussard, J. R.↗

NASA NTRS1982

Design and flight testing of a digital optimal control general aviation autopilot

This paper presents the designs of Proportional-Integral-Filter (PIF) autopilots for a General Aviation (NAVION) aircraft. The PIF autopilots use modern control theory to determine heading select and altitude select and hold autopilot modes. The PIF control law uses typical General Aviation sensors for state feedback; command error integration for command tracking; digital complimentary filtering and analog prefiltering for sensor noise suppression; a control filter for computation delay accommodation; and the incremental form to eliminate trim values in implementation. Theoretical developments for the control law are described which combine the sampled-data regulator with command generator tracking for use as a digital flight control system. The digital PIF autopilots are evaluated using closed-loop eigenvalues and simulations. Successful flight test results for the PIF autopilots are presented for different turbulence conditions and quadratic weights.

Broussard, J. R.↗

NASA NTRS1981

A quadratic weight selection algorithm

A new numerical algorithm is presented which determines a positive semi-definite state weighting matrix in the linear-quadratic optimal control design problem. The algorithm chooses the weighting matrix by placing closed-loop eigenvalues and eigenvectors near desired locations using optimal feedback gains. A simplified flight control design example is used to illustrate the algorithms capabilities.

Broussard, J. R.↗

NASA NTRS1979

Modern digital flight control system design for VTOL aircraft

Methods for and results from the design and evaluation of a digital flight control system (DFCS) for a CH-47B helicopter are presented. The DFCS employed proportional-integral control logic to provide rapid, precise response to automatic or manual guidance commands while following conventional or spiral-descent approach paths. It contained altitude- and velocity-command modes, and it adapted to varying flight conditions through gain scheduling. Extensive use was made of linear systems analysis techniques. The DFCS was designed, using linear-optimal estimation and control theory, and the effects of gain scheduling are assessed by examination of closed-loop eigenvalues and time responses.

Broussard, J. R.↗

NASA NTRS1977

Digital flight control design for a tandem-rotor helicopter

Methods and results in the continuing development of a digital flight control system (DFCS) for the CH-47B helicopter are examined. The helicopter is the research vehicle for the NASA VTOL Approach and Landing Technology (VALT) Program. It is equipped with comprehensive equipment for the investigation of navigation, guidance, and control requirements for future VTOL aircraft. Two control modes (attitude-command and velocity-command) are implemented, and each mode provides 'Type 1' response to guidance commands. DFCS design is based upon optimal estimation and control methods, which are found to provide flexible and efficient means for defining practical digital control systems.

Stengel, R. F.↗

NASA NTRS1977

Prediction of pilot-aircraft stability boundaries and performance contours

Control-theoretic pilot models can provide important new insights regarding the stability and performance characteristics of the pilot-aircraft system. Optimal-control pilot models can be formed for a wide range of flight conditions, suggesting that the human pilot can maintain stability if he adapts his control strategy to the aircraft's changing dynamics. Of particular concern is the effect of sub-optimal pilot adaptation as an aircraft transitions from low to high angle-of-attack during rapid maneuvering, as the changes in aircraft stability and control response can be extreme. This paper examines the effects of optimal and sub-optimal effort during a typical 'high-g' maneuver, and it introduces the concept of minimum-control effort (MCE) adaptation. Limited experimental results tend to support the MCE adaptation concept.

Stengel, R. F.↗

NASA NTRS1976

The design of digital-adaptive controllers for VTOL aircraft

Design procedures for VTOL automatic control systems have been developed and are presented. Using linear-optimal estimation and control techniques as a starting point, digital-adaptive control laws have been designed for the VALT Research Aircraft, a tandem-rotor helicopter which is equipped for fully automatic flight in terminal area operations. These control laws are designed to interface with velocity-command and attitude-command guidance logic, which could be used in short-haul VTOL operations. Developments reported here include new algorithms for designing non-zero-set-point digital regulators, design procedures for rate-limited systems, and algorithms for dynamic control trim setting.

Stengel, R. F.↗

NASA NTRS1976

Digital controllers for VTOL aircraft

Using linear-optimal estimation and control techniques, digital-adaptive control laws have been designed for a tandem-rotor helicopter which is equipped for fully automatic flight in terminal area operations. Two distinct discrete-time control laws are designed to interface with velocity-command and attitude-command guidance logic, and each incorporates proportional-integral compensation for non-zero-set-point regulation, as well as reduced-order Kalman filters for sensor blending and noise rejection. Adaptation to flight condition is achieved with a novel gain-scheduling method based on correlation and regression analysis. The linear-optimal design approach is found to be a valuable tool in the development of practical multivariable control laws for vehicles which evidence significant coupling and insufficient natural stability.

Stengel, R. F.↗