Engineering topics

Brinson, H. F.

Publications and source records attributed to Brinson, H. F..

At least 37 records · Page 2

NASA NTRS1984

A nonlinear viscoelastic characterization of graphite/epoxy composites

A nonlinear viscoelastic model based on the procedure of Findley et al., (1948) has been used to accurately represent the creep of several graphite/epoxy composites. Applying this approach to unidirectional 0, 90 and 10 deg off-axis tensile specimens, the viscoelastic response of a lamina can be characterized. The resulting lamina model has been useful for representing the behavior of a lamina in a numerical procedure to predict creep and delayed failures of general laminates. Also, independently, the Findley procedure has been used to characterize the nonlinear viscoelastic behavior of general laminates.

Dillard, D. A.↗

NASA NTRS1984

Viscoelastic modelling of epoxy-resins for adhesive and composite applications

Nonlinear viscoelastic and thermoelastic characterization procedures were applied to a rubber toughened adhesive that is commercially available as FM-300. Long time (accelerated testing) predictions on the basis of stress-time-superposition and time-temperature-superposition were compared with actual long term data. Good verification was obtained.

Hiel, C.↗

NASA NTRS1983

Nonlinear viscoelastic characterization of structural adhesives

Measurements of the nonliner viscoelastic behavior of two adhesives, FM-73 and FM-300, are presented and discussed. Analytical methods to quantify the measurements are given and fitted into a framework of an accelerated testing and analysis procedure. The single integral model used is shown to function well and is analogous to a time-temperature stress-superposition procedure (TTSSP). Advantages and disadvantages of the creep power law method used in this study are given.

Rochefort, M. A.↗

NASA NTRS1983

The nonlinear viscoelastic response of resin matrix composites

The current paper describes the utilization of a thermodynamic based analytical nonlinear viscoelastic approach to represent lamina properties. Test data to verify the analysis for both transverse and shear properties of a T300/934 composite are presented. Master curves as a function of stress level and temperature are generated. Favorable comparisons between the traditional graphical and the current analytical approaches are shown.

Hiel, C. C.↗

NASA NTRS1983

Environmental effects and viscoelastic behavior of laminated graphite/epoxy composites

Primarily because of the polymeric matrix, graphite/epoxy composites are viscoelastic materials which exhibit creep and delayed failures. Guided by the time-temperature superposition principle, the authors are developing accelerated characterization techniques to predict the long term compliance behavior and creep rupture strength of composite materials based on short term tests at elevated temperatures. The effect of a post-cure cycle on the compliance and creep rupture strength of composite materials is discussed. The Zhurkov type failure law is applied to experimental creep rupture data of a typical laminate and is shown to correlate the data. A beneficial mechanical strengthening effect is described which significantly affects the failure strengths of specimens which have been under creep loading for a period of time. This aging effect is reversible if the specimen is allowed to recover before being loaded to failure. Other environmental aspects of composite materials are also reviewed.

Dillard, D. A.↗

NASA NTRS1983

A numerical procedure for predicting creep and delayed failures in laminated composites

A numerical procedure is described for predicting the viscoelastic response of general laminates. A nonlinear compliance model is used to predict the creep response of the individual laminae. A biaxial delayed failure model predicts ply failure. The numerical procedure, based on lamination theory, increases by increments through time to predict creep compliance and delayed failures in laminates. Numerical stability problems and experimental verification are discussed. Although the program has been quite successful in predicting creep of general laminates, the assumptions associated with lamination theory have resulted in erroneous bounds on the predicted material response. Delayed failure predictions have been conservative. Several improvements are suggested to increase the accuracy of the procedure.

Dillard, D. A.↗

NASA NTRS1983

A non-linear viscoelastic characterisation method for matrix resin composites

Lifetime prediction of matrix resin composites is an important problem because of their viscoelastic character. If the Time-Temperature-Stress-Superposition principle is valid, results from short time tests at high stress levels can give the necessary information for the prediction of long time behavior. At such stress levels the viscoelastic response is nonlinear. In this contribution the basis of a computer routine is presented starting from a thermodynamical formulation given by Schapery. This method gives in an accurate way the different material parameters in that nonlinear constitutive equation for different stresses and temperatures.

Hiel, C. C.↗

NASA NTRS1982

Nonlinear viscoelastic characterization of polycarbonate

Uniaxial tensile creep and recovery data from polycarbonate at six temperatures and six stress levels are analyzed for nonlinear viscoelastic constitutive modeling. A theory to account for combined effects of two or more accelerating factors is presented.

Caplan, E. S.↗

NASA NTRS1982

The prediction of long term viscoelastic properties of fiber reinforced plastics

A method for the experimental and analytical accelerated characterization of long term viscoelastic properties is presented. The time-temperature-stress superposition principle (TTSSP) is shown to serve as the basis for determining long term compliance data from short term creep test results. Nonlinear viscoelastic theories are discussed to provide the framework for the mathematically modeling of such a process. A time dependent Tsai-Hill-Zhurkov failure theory is used to determine long term failure properties from short term data. Compliance and failure data are incorporated in an incremental lamination theory to make long term laminate predictions. Comparisons are made between theory and experiment.

Brinson, H. F.↗

NASA NTRS1982

Predicting viscoelastic response and delayed failures in general laminated composites

Although graphite fibers behave in an essentially elastic manner, the polymeric matrix of graphite/epoxy composites is a viscoelastic material which exhibits creep and delayed failures. The creep process is quite slow at room temperature, but may be accelerated by higher temperatures, moisture absorption, and other factors. Techniques are being studied to predict long-term behavior of general laminates based on short-term observations of the unidirectional material at elevated temperatures. A preliminary numerical procedure based on lamination theory is developed for predicting creep and delayed failures in laminated composites. A modification of the Findley nonlinear power law is used to model the constitutive behavior of a lamina. An adaptation of the Tsai-Hill failure criterion is used to predict the time-dependent strength of a lamina. Predicted creep and delayed failure results are compared with typical experimental data.

Dillard, D. A.↗

NASA NTRS1981

Creep rupture of polymer-matrix composites

The time-dependent creep-rupture process in graphite-epoxy laminates is examined as a function of temperature and stress level. Moisture effects are not considered. An accelerated characterization method of composite-laminate viscoelastic modulus and strength properties is reviewed. It is shown that lamina-modulus master curves can be obtained using a minimum of normally performed quality-control-type testing. Lamina-strength master curves, obtained by assuming a constant-strain-failure criterion, are presented along with experimental data, and reasonably good agreement is shown to exist between the two. Various phenomenological delayed failure models are reviewed and two (the modified rate equation and the Larson-Miller parameter method) are compared to creep-rupture data with poor results.

Brinson, H. F.↗

NASA NTRS1981

Creep and creep rupture of laminated graphite/epoxy composites

An incremental numerical procedure based on lamination theory is developed to predict creep and creep rupture of general laminates. Existing unidirectional creep compliance and delayed failure data is used to develop analytical models for lamina response. The compliance model is based on a procedure proposed by Findley which incorporates the power law for creep into a nonlinear constitutive relationship. The matrix octahedral shear stress is assumed to control the stress interaction effect. A modified superposition principle is used to account for the varying stress level effect on the creep strain. The lamina failure model is based on a modification of the Tsai-Hill theory which includes the time dependent creep rupture strength. A linear cumulative damage law is used to monitor the remaining lifetime in each ply.

Dillard, D. A.↗

NASA NTRS1981

The viscoelastic response of a graphite/epoxy laminate

An accelerated characterization procedure has been developed for time-dependent compliances and strengths of resin-matrix composites. The procedure, which is based on a time-temperature-stress superposition principle, is applied to a graphite/epoxy laminate T300/934. Creep rupture analytical models are discussed, and model predictions are compared with experimental data. Master curves for the creep compliances are given.

Brinson, H. F.↗

NASA NTRS1981

The influence of environmental effects on the mechanical properties of graphite/epoxy laminates

The time dependent deformational and creep rupture processes in graphite/epoxy laminates are examined as a function of temperature and stress level. The role of accelerated characterization of design materials is discussed, and the use of a nonlinear time-temperature-stress-superposition principle in the determination of compliance master curves as a function of stress and temperature is considered. Creep rupture analytical models are discussed as applied to polymer-matrix composites, and the data is shown to be in general agreement with a logarithmic stress and temperature-dependent delayed fracture model. Comparisons between creep and rupture experiments and phenomenological models are presented.

Brinson, H. F.↗

NASA NTRS1980

Accelerated characterization of graphite/epoxy composites

A method to predict the long term compliance of unidirectional off-axis laminates from short term laboratory tests is presented. The method uses an orthotropic transformation equation and the time-stress-temperature superposition principle. Short term tests are used to construct master curves for two off-axis unidirectional laminates with fiber angles of 10 and 90 degrees. Analytical predictions of long term compliance for 30 and 60 degrees laminates are made. Comparisons with experimental data are also given.

Griffith, W. I.↗

NASA NTRS1980

The viscoelastic behavior of the principal compliance matrix of a unidirectional graphite/epoxy composite

A testing program was conducted to determine the time-temperature response of the principal compliances of a unidirectional graphite/epoxy composite. It was shown that the two components of the compliance matrix are time and temperature independent. In addition, the compliance matrix is symmetric for the viscoelastic composite. The time-temperature superposition principle is used to determine shift factors. It was shown that the shift factors are independent of fiber orientation for fiber angles that vary from 10 to 90 deg with respect to the load direction.

Morris, D. H.↗

NASA NTRS1980

Creep-rupture of polymer-matrix composites

An accelerated characterization method for resin matrix composites is reviewed. Methods for determining modulus and strength master curves are given. Creep rupture analytical models are discussed as applied to polymers and polymer matrix composites. Comparisons between creep rupture experiments and analytical models are presented. The time dependent creep rupture process in graphite epoxy laminates is examined as a function of temperature and stress level.

Brinson, H. F.↗

NASA NTRS1980

The accelerated characterization of viscoelastic composite materials

Necessary fundamentals relative to composite materials and viscoelasticity are reviewed. The accelerated characterization techniques of time temperature superposition and time temperature stress superposition are described. An experimental procedure for applying the latter to composites is given along with results obtained on a particular T300/934 graphite/epoxy. The accelerated characterization predictions are found in good agreement with actual long term tests. A postcuring phenomenon is discussed that necessitates thermal conditioning of the specimen prior to testing. A closely related phenomenon of physical aging is described as well as the effect of each on the glass transition temperature and strength. Creep rupture results are provided for a variety of geometries and temperatures for T300/934 graphite/epoxy. The results are found to compare reasonably with a modified kinetic rate theory.

Griffith, W. I.↗