Engineering Papers⌕ Search

Engineering topics

Branz, H M

Publications and source records attributed to Branz, H M.

At least 19 records

Light Trapping for Thin Silicon Solar Cells by Femtosecond Laser Texturing: Preprint

Femtosecond laser texturing is used to create nano- to micron-scale surface roughness that strongly enhances light-trapping in thin crystalline silicon solar cells. Light trapping is crucial for thin solar cells where a single light-pass through the absorber is insufficient to capture the weakly absorbed red and near-infrared photons, especially with an indirect-gap semiconductor absorber layersuch as crystalline Si which is less than 20 um thick. We achieve enhancement of the optical absorption from light-trapping that approaches the Yablonovitch limit.

14 SOLAR ENERGY↗

Characterization of Epitaxial Film Silicon Solar Cells Grown on Seeded Display Glass: Preprint

We report characterizations of epitaxial film crystal silicon (c-Si) solar cells with open-circuit voltages (Voc) above 560 mV. The 2-um absorber cells are grown by low-temperature (<750 degrees C) hot-wire CVD (HWCVD) on Corning EAGLE XG display glass coated with a layer-transferred (LT) Si seed. The high Voc is a result of low-defect epitaxial Si (epi-Si) growth and effective hydrogenpassivation of defects. The quality of HWCVD epitaxial growth on seeded glass substrates depends on the crystallographic quality of the seed and the morphology of the epitaxial growth surface. Heterojunction devices consist of glass/c-Si LT seed/ epi n+ Si:P/epi n- Si:P/intrinsic a-Si:H/p+ a-Si:H/ITO. Similar devices grown on electronically 'dead' n+ wafers have given Voc630 mV and8%efficiency with no light trapping features. Here we study the effects of the seed surface polish on epi-Si quality, how hydrogenation influences the device character, and the dominant junction transport physics.

14 SOLAR ENERGY↗

Hydrogenation of Dislocation-Limited Heteroepitaxial Silicon Solar Cells: Preprint

Post-deposition hydrogenation by remote plasma significantly improves performance of heteroepitaxial silicon solar cells. Heteroepitaxial deposition of thin crystal silicon on sapphire for photovoltaics (PV) is an excellent model system for the study and improvement of deposition on inexpensive Al2O3-coated (100) biaxially-textured metal foils. Without hydrogenation, PV conversion efficienciesare less than 1% on our model system. Performance is limited by carrier recombination at electrically active dislocations that result from lattice mismatch, and other defects. We find that low-temperature hydrogenation at 350 degrees C is more effective than hydrogenation at 610 degrees C. In this work, we use measurements such as spectral quantum efficiency, secondary ion mass spectrometry(SIMS), and vibrational Si-H spectroscopies to understand the effects of hydrogenation on the materials and devices. Quantum efficiency increases most at red and green wavelengths, indicating hydrogenation is affecting the bulk more than the surface of the cells. SIMS shows there are 100X more hydrogen atoms in our cells than dangling bonds along dislocations. Yet, Raman spectroscopy indicatesthat only low temperature hydrogenation creates Si-H bonds; trapped hydrogen does not stably passivate dangling-bond recombination sites at high temperatures.

14 SOLAR ENERGY↗

Heteroepitaxial Film Silicon Solar Cell Grown on Ni-W Foils

Heteroepitaxial semiconductor films on low-cost, flexible metal foil templates are a potential route to inexpensive, high-efficiency solar cells. Here, we report epitaxial growth of Si films on low-cost, flexible, biaxially-textured Ni-W substrates. A robust buffer architecture comprised of multiple epitaxial oxide layers has been developed to grow high quality, heteroepitaxial Si films without any undesired reaction between the Si film and the metal substrate and with a single biaxial texture. XRD analysis including {omega}-scans, {phi}-scans, and pole figures confirms that the buffers and silicon are all epitaxial, with excellent cube-on-cube epitaxy. A photo-conversion efficiency of 1.1% is demonstrated from a proof-of-concept heteroepitaxial film Si solar cell.

14 SOLAR ENERGY↗

17.1%-Efficient Multi-Scale-Textured Black Silicon Solar Cells without Dielectric Antireflection Coating: Preprint

In this work we present 17.1%-efficient p-type single crystal Si solar cells with a multi-scale-textured surface and no dielectric antireflection coating. Multi-scale texturing is achieved by a gold-nanoparticle-assisted nanoporous etch after conventional micron scale KOH-based pyramid texturing (pyramid black etching). By incorporating geometric enhancement of antireflection, this multi-scaletexturing reduces the nanoporosity depth required to make silicon 'black' compared to nanoporous planar surfaces. As a result, it improves short-wavelength spectral response (blue response), previously one of the major limiting factors in 'black-Si' solar cells. With multi-scale texturing, the spectrum-weighted average reflectance from 350- to 1000-nm wavelength is below 2% with a 100-nm deepnanoporous layer. In comparison, roughly 250-nm deep nanopores are needed to achieve similar reflectance on planar surface. Here, we characterize surface morphology, reflectivity and solar cell performance of the multi-scale textured solar cells.

14 SOLAR ENERGY↗

Epitaxial Crystal Silicon Absorber Layers and Solar Cells Grown at 1.8 Microns per Minute: Preprint

We have grown device-quality epitaxial silicon thin films at growth rates up to 1.8 ..mu..m/min, using hot-wire chemical vapor deposition from silane at substrate temperatures below 750 degrees C. At these rates, which are more than 30 times faster than those used by the amorphous and nanocrystalline Si industry, capital costs for large-scale solar cell production would be dramatically reduced,even for cell absorber layers up to 10 ?m thick. We achieved high growth rates by optimizing the three key parameters: silane flow, depletion, and filament geometry, based on our model developed earlier. Hydrogen coverage of the filament surface likely limits silane decomposition and growth rate at high system pressures. No considerable deterioration in PV device performance is observed whengrown at high rate, provided that the epitaxial growth is initiated at low rate. A simple mesa device structure (wafer/epi Si/a-Si(i)/a-Si:H(p)/ITO) with a 2.3 um epitaxial silicon absorber layer was grown at 700 nm/min. The finished device had an open-circuit voltage of 0.424 V without hydrogenation treatment.

14 SOLAR ENERGY↗

Junction Transport in Epitaxial Film Silicon Heterojunction Solar Cells: Preprint

We report our progress toward low-temperature HWCVD epitaxial film silicon solar cells on inexpensive seed layers, with a focus on the junction transport physics exhibited by our devices. Heterojunctions of i/p hydrogenated amorphous Si (a-Si) on our n-type epitaxial crystal Si on n++ Si wafers show space-charge-region recombination, tunneling or diffusive transport depending on both epitaxial Siquality and the applied forward voltage.

14 SOLAR ENERGY↗

Reduced Light-Induced Degradation in a Si:H: The Role of Network Nanostructure

In this work, we report our recent observations on strong reduction in Staebler-Wronski (SWE) effect in device quality a-Si:H that has been post-deposition annealed up to 400C, and make a connection between these observations and changes in a-Si:H network nanostructure and H bonding, both from our own FTIR and NMR measurements and from the SAXS and NMR literature. The results suggest that it is the smallest (atomic size) voids in a-Si:H that are most likely responsible for the Staebler-Wronski effect. Thermal treatments up to 400C lead to coalescence and restructuring of these voids leading to reduction of SWE.

14 SOLAR ENERGY↗

Understanding the Clean Interface Between Covalent Si and Ionic Al2O3

The atomic and electronic structures of the (001)-Si/(001)-{gamma}-Al{sub 2}O{sub 3} heterointerface are investigated by first principles total energy calculations combined with a newly developed 'modified basin-hopping' method. It is found that all interface Si atoms are fourfold coordinated due to the formation of Si-O and unexpected covalent Si-Al bonds in the new abrupt interface model. And the interface has perfect electronic properties in that the unpassivated interface has a large LDA band gap and no gap levels. These results show that it is possible to have clean semiconductor-oxide interfaces.

14 SOLAR ENERGY↗