Engineering topics

Branch, Ruth A.

Publications and source records attributed to Branch, Ruth A..

3 records

DOE OSTI2024

Characterizing Interference in a Wave-Powered Buoy

Oceanographic measurement buoys are power constrained by the capacity of their batteries and the available solar power. Many buoys are in locations with abundant wave energy, but wave energy converters are not being used to power them. One reason wave energy converters may not have not been developed for wave measurement buoys is that many buoys measure waves by precisely following the wave motion. Wave energy converters may inhibit this wave-following ability by altering a buoy's response to incoming waves. In this report, we present the results of field tests that measured the extent to which buoy motion was changed by modifications to the buoy for wave energy harvesting. The motion of the buoy was significantly modified by the addition of the hardware components necessary for harvesting wave energy. The ratio of the mass of the wave energy converter to the mass of the buoy was high for the system tested, which strongly affected buoy motion. A lower value for this ratio would decrease the effect of the wave energy converter on the motion of the buoy, thereby decreasing the impact on the buoy's ability to measure waves but also decreasing the power production capabilities. Therefore, the use of wave energy converters to power wave measurement buoys may be feasible for large buoys that measure low-frequency waves and have low power requirements.

16 TIDAL AND WAVE POWER↗

DOE OSTI2023

Powering the Blue Economy: Marine Energy at Kelp Farm Sites

Marine energy (ME) has the potential to power businesses in the blue economy. Kelp farms are an emerging maritime market of the blue economy and are predicted to grow, but they are not currently using ME for their power needs. As the number and size of kelp farms increase, more offshore power will be needed onsite for operations, monitoring, and harvesting. ME devices such as tidal current energy converters and wave energy converters (WECs) may be used to supply power for these needs. This article assesses the status of kelp farming in the continental United States, investigates the electricity needs of kelp farms, and examinesthe feasibility of generating the required electricity from wave and tidal current energy. The United States currently has 165 kelp farms that have either active or pending permits. The farms use electricity for boat operations, kelp drying, environmental monitoring, offshore lighting, and the raising and lowering of lines. Most kelp farms are in protected, nearshore waters that do not have significant wave energy resources. The limited available wave energy could be used to power small devices, but WECs have not yet been developed for that application. Some kelp farms are in locations that feature significant tidal energy resources, but small tidal current energy converters that are compatible with existing farm operations are not yet commercially available. As low-power WECs and tidal current energy converters are developed, kelp farms could be research partners and early adopters of the new technologies, which would encourage their broader use by other blue economy businesses.

16 TIDAL AND WAVE POWER↗

DOE OSTI2023

Low Tidal Current Speed Electricity Generation for Power at an Aquaculture Farm

Aquaculture farms are often located where tidal currents speeds are strong enough to ensure the currents supply fresh nutrients but not so strong that they harm the farm infrastructure. Traditional tidal turbines have cut-in speeds of 1 m/s and cannot generate electricity at current speeds below that threshold. Current energy converters that rely on vortex induced vibration (VIV) for movement can generate electricity at current speeds below 1 m/s. Here we discuss a project where researchers from the Pacific Northwest National Laboratory (PNNL) collaborate with researchers from the University of Michigan to investigate the feasibility of using a VIV current energy converter to generate electricity at an aquaculture farm. The VIV current energy converter uses flow induced oscillations of tandem cylinders and adaptive damping to harness the maximum horizontal marine hydrokinetic (MHK) energy by mimicking fish undulations. The current energy converter will be field tested and its power output measured over a range of current speeds. In addition to working with the University of Michigan, the PNNL researchers are collaborating with the Hog Island Oyster Company to assess their electricity usage and quantify the current energy resources at their Humboldt Bay facility. The electricity usage and current resource assessment at the aquaculture farm will be compared to the power produced by VIVACE to determine the feasibility of using VIVACE for power production at the farm.

Branch, Ruth A.↗