Engineering Papers⌕ Search

Engineering topics

Bowles, Roland L.

Publications and source records attributed to Bowles, Roland L..

33 records · Page 2
All sourcesNASA NTRSDOE OSTI
NASA NTRS1990

Airborne Wind Shear Detection and Warning Systems. Second Combined Manufacturers' and Technologists' Conference, part 2

The Second Combined Manufacturers' and Technologists' Conference was hosted jointly by NASA Langley (LaRC) and the Federal Aviation Administration (FAA) in Williamsburg, Virginia, on October 18 to 20, 1988. The meeting was co-chaired by Dr. Roland Bowles of LaRC and Herbrt Schlickenmaier of the FAA. The purpose of the meeting was to transfer significant, ongoing results gained during the second year of the joint NASA/FAA Airborne Wind Shear Program to the technical industry and to pose problems of current concern to the combined group. It also provided a forum for manufacturers to review forward-look technology concepts and for technologists to gain an understanding of the problems encountered by the manufacturers during the development of airborne equipment and the FAA certification requirements.

Spady, Amos A., Jr.↗
NASA NTRS1990

A Monte Carlo simulation technique for low-altitude, wind-shear turbulence

A case is made for including anisotropy in a Monte Carlo flight simulation scheme of low-altitude wind-shear turbulence by means of power spectral density. This study attempts to eliminate all flight simulation-induced deficiencies in the basic turbulence model. A full-scale low-altitude wind-shear turbulence simulation scheme is proposed with particular emphasis on low cost and practicality for near-ground flight. The power spectral density statistic is used to highlight the need for realistic estimates of energy transfer associated with low-altitude wind-shear turbulence. The simulation of a particular anisotropic turbulence model is shown to be a relatively simple extension from that of traditional isotropic (Dryden) turbulence.

Bowles, Roland L.↗
NASA NTRS1990

Reducing windshear risk through airborne systems technology

A preliminary set of performance criteria for predictive windshear detection and warning systems is defined. Candidate airborne remote sensor technologies based on microwave Doppler radar, Doppler lidar, and IR radiometric techniques are examined from the viewpoint of overall system requirements, and the performance of each sensor is evaluated for representative microburst environments and ground clutter conditions. Preliminary simulation results indicate that all three sensors have potential for detecting windshear, and provide adequate warning time to permit flight crews to avoid the affected area or escape from the encounter.

Bowles, Roland L.↗
NASA NTRS1990

Windshear detection and avoidance - Airborne systems survey

Functional requirements for airborne windshear detection and warning systems are discussed in terms of the threat posed to civil aircraft operations. A preliminary set of performance criteria for predictive windshear detection and warning systems is defined. Candidate airborne remote sensor technologies based on microwave Doppler radar, Doppler laser radar (lidar), and infrared radiometric techniques are discussed in the context of overall system requirements, and the performance of each sensor is assessed for representative microburst environments and ground clutter conditions. Preliminary simulation results demonstrate that all three sensors show potential for detecting windshear, and provide adequate warning time to allow flight crews to avoid the affected area or escape from the encounter. Radar simulation and analysis show that by using bin-to-bin automatic gain control, clutter filtering, limited detection range, and suitable antenna tilt management, windshear from wet microbursts can be accurately detected. Although a performance improvement can be obtained at higher radar frequency, the baseline X-band system also detected the presence of windshear hazard for a dry microburst. Simulation results of end-to-end performance for competing coherent lidar systems are presented.

Bowles, Roland L.↗
NASA NTRS1990

Three-dimensional simulation of the Denver 11 July Storm of 1988 - An intense microburst event

An account is given of results from a numerical simulation of an intense microburst-generating storm observed near Denver during a test operation of the Terminal Doppler Radar System, on July 11, 1988. The numerical simulation encompassed comparisons with 'observed' data from measurements by Doppler radar, aircraft flight data recorders, and surface field instruments. Model results are in excellent qualitative and quantitative agreement with major storm feature observations. The intense microburst that was generated some distance 'downshear' of the primary precipitation area was driven by cooling due to sublimating snow.

Proctor, Fred H.↗
NASA NTRS1988

Investigation of airborne lidar for avoidance of windshear hazards

The present generalized windshear hazard index is formulated in terms of wind conditions at the given aircraft position and of remotely-sensed information obtained along the extended flight path. Overall system functional requirements are addressed by comparing microwave Doppler radar, Doppler lidar, and IR radiometry candidate techniques, giving attention to airborne CO2 and Ho:YAG lidar windshear-detection systems; these furnish pilots with data on the line-of-sight component of windshear threats over as much as 1-3 km, for a warning time of 15-45 sec. While the technology for a 10.6-micron, CO2 laser-based lidar is available, additional development is required for 2-micron, Ho:YAG laser-based systems.

Targ, Russell↗
NASA NTRS1988

A simple, analytic 3-dimensional downburst model based on boundary layer stagnation flow

A simple downburst model is developed for use in batch and real-time piloted simulation studies of guidance strategies for terminal area transport aircraft operations in wind shear conditions. The model represents an axisymmetric stagnation point flow, based on velocity profiles from the Terminal Area Simulation System (TASS) model developed by Proctor and satisfies the mass continuity equation in cylindrical coordinates. Altitude dependence, including boundary layer effects near the ground, closely matches real-world measurements, as do the increase, peak, and decay of outflow and downflow with increasing distance from the downburst center. Equations for horizontal and vertical winds were derived, and found to be infinitely differentiable, with no singular points existent in the flow field. In addition, a simple relationship exists among the ratio of maximum horizontal to vertical velocities, the downdraft radius, depth of outflow, and altitude of maximum outflow. In use, a microburst can be modeled by specifying four characteristic parameters, velocity components in the x, y and z directions, and the corresponding nine partial derivatives are obtained easily from the velocity equations.

Oseguera, Rosa M.↗
NASA NTRS1988

Airborne Wind Shear Detection and Warning Systems: First Combined Manufacturers' and Technologists' Conference

The purpose of the meeting was to transfer significant, ongoing results gained during the first year of the joint NASA/FAA Airborne Wind Shear Program to the technical industry and to pose problems of current concern to the combined group. It also provided a forum for manufacturers to review forward-looking technology concepts and for technologists to gain an understanding of FAA certification requirements and the problems encountered by the manufacturers during the development of airborne equipment.

Spady, Amos A., Jr.↗
NASA NTRS1988

Response of wind shear warning systems to turbulence with implication of nuisance alerts

The objective was to predict the inherent turbulence response characteristics of candidate wind shear warning system concepts and to assess the potential for nuisance alerts. Information on the detection system and associated signal processing, physical and mathematical models, wind shear factor root mean square turbulence response and the standard deviation of the wind shear factor due to turbulence is given in vugraph form.

Bowles, Roland L.↗
NASA NTRS1988

The effect of spatial wind gradients on airplane aerodynamics

An account is given of the results of recent studies of the effect of a spatially sheared wind field on airplane aerodynamics; the wind shear was computed by a modified vortex-lattice computer program, and characterized through the formulation of wind shear aerodynamic coefficients. The magnitude of the aerodynamic effect was demonstrated by computing the change in conventional wing/tail configuration aerodynamics for a fixed flight path through a simulated microburst. A substantial portion of the control authority of the aircraft may be required to counteract the wind shear-induced forces and moments in the microburst environment; both aperiodic and oscillatory instabilities may be generated by shear-dependent dynamic modes.

Vicroy, Dan D.↗
NASA NTRS1988

Windshear detection and avoidance - Airborne systems perspective

The generalized windshear hazard index presently defined is derived from aircraft-position wind data and remotely sensed data obtained along the extended flight path by such candidate sensor technologies as microwave Doppler radar, Doppler lidar, and IR radiometry. Attention is given here to the results of a comparative evaluation of CO2 and Ho:YAG lidar sensor-employing windshear-detection systems, over a range 1-3 km ahead of the aircraft (corresponding to 15-45 sec of warning time). While the technology for a 10.6-micron CO2 lidar system is available, an optimum 2-micron REE laser crystal-based system remains to be developed.

Bowles, Roland L.↗
NASA NTRS1988

Windshear avoidance - Requirements and proposed system for airborne lidar detection

A generalized windshear hazard index is derived from considerations of wind conditions and an aircraft's present and potential altitude. Based on a systems approach to the windshear threat, lidar appears to be a viable methodology for windshear detection and avoidance, even in conditions of moderately heavy precipitation. The airborne CO2 and Ho:YAG lidar windshear detection systems analyzed can each give the pilot information about the line-of-sight component of windshear threat from his present position to a region extending 1 to 3 km in front of the aircraft. This constitutes a warning time of 15 to 45 s. The technology necessary to design, build and test such a brassboard 10.6-micron CO2 lidar is at hand.

Targ, Russell↗
NASA NTRS1987

Wind Shear/Turbulence Inputs to Flight Simulation and Systems Certification

The purpose of the workshop was to provide a forum for industry, universities, and government to assess current status and likely future requirements for application of flight simulators to aviation safety concerns and system certification issues associated with wind shear and atmospheric turbulence. Research findings presented included characterization of wind shear and turbulence hazards based on modeling efforts and quantitative results obtained from field measurement programs. Future research thrusts needed to maximally exploit flight simulators for aviation safety application involving wind shear and turbulence were identified. The conference contained sessions on: Existing wind shear data and simulator implementation initiatives; Invited papers regarding wind shear and turbulence simulation requirements; and Committee working session reports.

Bowles, Roland L.↗
NASA NTRS1987

Wind shear and turbulence simulation

The aviation community is increasing its reliance on flight simulators. This is true both in pilot training and in research and development. In moving research concepts through the development pipeline, there is a sequence of events which take place: analysis, ground based simulation, inflight simulation, and flight testing. Increasing fidelity as progress toward the flight testing arena is accompanied by increasing cost. The question that seems to be posed in relation to the meteorological aspects of flight simulation is, How much fidelity is enough and can it be quantified. As a part of the Langley Simulation Technology Program, there are three principal areas of focus, one being improved simulation of weather hazards. A close liaison with the JAWS project was established because of the Langley Simulation Technology interests regarding reliable simulation of severe convective weather phenomena and their impact on aviation systems. Simulation offers the only feasible approach for examining the utility of new technology and new procedures for coping with severe convective weather phenomena such as wind shear. These simulation concepts are discussed in detail.

Bowles, Roland L.↗