Engineering PapersSearch

Engineering topics

Bowen, S. W.

Publications and source records attributed to Bowen, S. W..

At least 19 records

Dynamics of Rocky Mountain Lee Waves Observed During Success

On two days during SUCCESS, the DC-8 sampled wave clouds which formed downstream of the ridges east of the Rocky Mountains. Wave morphology for both flights is deduced from temperature and 3-dimensional wind measurements from the MMS, isentrope profiles from the MTP, and linear perturbation theory. The waves observed on 960430 are smaller and found to be decaying with altitude, while the waves sampled on 960502 are vertically propagating and consist of larger, multiple wave scales. Wave orientations are consistent with the underlying topography and regions of high ice crystal concentration. Updraft velocities were estimated from the derived wave properties and are consistent with MMS vertical winds.

Dean-Day, J.

Turbulence Measurements by the DC-8 Meteorological Measurement System

The instrumentation of a new MMS on the DC-8 aircraft is briefly described. Methods to compute and evaluate the turbulent dissipation rate epsilon, based on theory and MMS data, are discussed. Examples of turbulence measurements during encounters of a wake vortex, wave clouds, persistent contrails, mountain are gravity waves are illustrated.

Chan, K. R.

A case study of the mountain lee wave event of January 6, 1992

A mountain wave event, observed at the southern tip of Greenland on January 6, 1992, was corroborated by three experiments: the Meteorological Measurement System (MMS), the Microwave Temperature Profiler (MTP), and the Reactive Nitrogen Instrument (NO/NO(y)). Gravity wave signatures with classical phase relationship between wind and temperature were observed on both the outbound and inbound legs at different altitudes. The waves showed both vertically propagating and evanescent properties. Characteristics of the dominant wave mode are: wavelength about = 35 km; vertical displacement about = 0.8 km, and peak-to-peak vertical wind about = 6/ms. With the prevailing wind at about = 37/ms, the stratospheric temperature was reduced by 6K to 195.5 K within 8 minutes. The implication and potential impact of mountain lee waves on the formation of polar stratospheric clouds (PSC's) are discussed.

Chan, K. R.

A Case Study of the Mountain Lee Wave Event of January 6, 1992

A mountain wave event, observed at the southern tip of Greenland on January 6, 1992, was corroborated by three experiments: the Meteorological Measurement System (MMS), the Microwave Temperature Profiler (MTP), and the Reactive Nitrogen Instrument (NO/NO(y)). Gravity wave signatures with classical phase relationship between wind and temperature were observed on both the outbound and inbound legs at different altitudes. The waves showed both vertically propagating and evanescent properties. Characteristics of the dominant wave mode are: wavelength approximately equals 35 km, vertical displacement approximately equals 0.8 km, and peak-to-peak vertical wind approximately equals 6 ms-1. With the prevailing wind at approximately equals 37 m/s, the stratospheric temperature was reduced by 6 K to 195.5 K within 8 minutes. The implication and potential impact of mountain lee waves on the formation of polar stratospheric clouds (PSC's) are discussed.

Chan, K. R.

Horizontal wind fluctuations in the stratosphere during large-scale cyclogenesis

The meteorological measurement system (MMS) on the U-2 aircraft measured pressure, temperature, and the horizontal wind during a cyclogenesis event over western United States on April 20, 1984. The mean horizontal wind in the stratosphere decreases monotonically with altitude. Superimposed on the mean stratospheric wind is a perturbation wind vector, which is an elliptically polarized wave with an amplitude of 4 to 10 m/s and a vertical wavelength of 2 to 3 km. The perturbation wind vector rotates anticyclonically (clockwise) with altitude and produces alternating advection in the plane of the aircraft flight path. This differential advection folds surfaces of constant tracer mixing ratio and contributes to the observed tracer laminar structures and inferred cross-jet transport.

Chan, K. R.

Temperature and wind measurements and model atmospheres of the 1989 Airborne Arctic Stratospheric Expedition

The ER-2 Meteorological Measurement System provides accurate in situ measurements of atmospheric state variables. During the Airborne Arctic Stratospheric Expedition (AASE) the ER-2 flew over the polar region on 14 occasions in January and February, 1989. Vertical temperature profiles, during aircraft takeoff at about 60 deg N and during midflight descent and ascent at high latitudes, are presented. Latitudinal variations of the horizontal wind measurement are illustrated and discussed. Based on observation data, model atmospheres at 60 deg and 75 deg N, representative of the environment of the AASE campaign, are developed.

Chan, K. R.

Temperature and horizontal wind measurements on the ER-2 aircraft during the 1987 Airborne Antarctic Ozone Experiment

The accuracy of temperature, pressure, potential temperature, and horizontal wind measurements is discussed in connection with the use of Meteorological Measurement System data in the AAOE. The vertical distribution of temperature measurements and latitudinal variations of the zonal wind for 12 flights over Antarctica during the 1987 AAOE campaign are summarized. Model atmospheres from 0 to 32 km at 70 deg and 55 deg S for the August-September period are constructed. Above the 420 K isentropic surface, the polar vortex remains strong throughout August and September of 1987.

Chan, K. R.

Ablation and deceleration of mass-driver launched projectiles for space disposal of nuclear wastes

The energy cost of launching a projectile containing nuclear waste is two orders of magnitude lower with a mass driver than with a typical rocket system. A mass driver scheme will be feasible, however, only if ablation and deceleration are within certain tolerable limits. It is shown that if a hemisphere-cylinder-shaped projectile protected thermally with a graphite nose is launched vertically to attain a velocity of 17 km/sec at an altitude of 40 km, the mass loss from ablation during atmospheric flight will be less than 0.1 ton, provided the radius of the projectile is under 20 cm and the projectile's mass is of the order of 1 ton. The velocity loss from drag will vary from 0.4 to 30 km/sec, depending on the mass and radius of the projectile, the smaller velocity loss corresponding to large mass and small radius. Ablation is always within a tolerable range for schemes using a mass driver launcher to dispose of nuclear wastes outside the solar system. Deceleration can also be held in the tolerable range if the mass and diameter of the projectile are properly chosen.

Park, C.

Space reflector technology and its system implications

The technical feasibility of providing nearly continuous solar energy to a world-distributed set of conversion sites by means of a system of orbiting, large-area, low-areal-density reflecting structures is examined. Requisite mirror area to provide a chosen, year-averaged site intensity is shown. A modeled reflector structure, with suitable planarity and ability to meet operational torques and loads, is discussed. Typical spatial and temporal insolation profiles are presented. These determine the sizing of components and the output electric power from a baselined photovoltaic conversion system. Technical and economic challenges which, if met, would allow the system to provide a large fraction of future world energy needs at costs competitive to circa-1995 fossil and nuclear sources are discussed.

Billman, K. W.

Satellite mirror systems for providing terrestrial power - System concept

A system of orbiting reflectors, SOLARES, has been studied as a possible means of providing terrestrial power with a space system of minimum mass and complexity. The key impact that such a system, providing continuous and slightly concentrated insolation, makes on the economic viability of solar farming is demonstrated. New developments in solar sailing are incorporated to reduce mirror mass and transportation cost. The system is compatible with incremental implementation and continual expansion to produce the world's power needs. Key technology, environmental, and economic issues and payoffs are identified. SOLARES appears to be economically superior to other advanced, and even conventional, energy systems and could be scaled to completely abate our fossil fuel usage for power generation.

Billman, K. W.

Enhanced solar energy options using earth-orbiting mirrors

A system of orbiting space reflectors is described, analyzed, and shown to economically provide nearly continuous insolation to preselected ground sites, producing benefits hitherto lacking in conventional solar farms and leading to large reductions in energy costs for such installations. Free-flying planar mirrors of about 1 sq km are shown to be optimum and can be made at under 10 g/sq m of surface, thus minimizing material needs and space transportation costs. Models are developed for both the design of such mirrors and for the analysis of expected ground insolation as a function of orbital parameters, time, and site location. Various applications (agricultural, solar-electric production, weather enhancement, etc.) are described.

Gilbreath, W. P.

Orbiting mirrors for terrestrial energy supply

A system of orbiting reflectors termed 'SOLARES' is proposed as a means of reducing the diurnal variation and increasing the average intensity of sunlight for terrestrial solar power systems. The paper discusses orbital considerations for the placement of the reflectors, insolation profiles, ground conversion options, costs, and environmental and social effects.

Billman, K. W.

SOLARES - A new hope for solar energy

A system of orbiting reflectors, SOLARES, has been studied as a possible means of reducing the diurnal variation and enhancing the average intensity of sunlight with a space system of minimum mass and complexity. The key impact that such a system makes on the economic viability of solar farming and other solar applications is demonstrated. The system is compatible with incremental implementation and continual expansion to meet the world's power needs. Key technology, environmental, and economic issues and payoffs are identified. SOLARES appears to be economically superior to other advanced, and even competitive with conventional, energy systems and could be scaled to completely abate our fossil fuel usage for power generation. Development of the terrestrial solar conversion technique, optimized for this new artificial source of solar radiation, yet remains.

Billman, K. W.

Introductory assessment of orbiting reflections for terrestrial power generation

The use of orbiting mirrors for providing energy to ground conversion stations to produce electrical power is shown to be a viable, cost effective and environmentally sound alternative to satellite solar power stations and conventional power sources. This is accomplished with the use of very light weight metal coated polymeric films as mirrors which, after deployment at 800 km, are placed in operational orbit and controlled by solar radiation pressure. Relations are developed showing the influence of a number of parameters (mirror altitude, orbit inclination, period, mirror size and number, and atmospheric effects) on the reflected insolation that may be received by a ground spot as a function of location. Some attractive alternative uses of the reflection are briefly discussed as a beneficial adjuncts to the system.

Billman, K. W.