Engineering Papers⌕ Search

Engineering topics

Bostelmann, Rike

Publications and source records attributed to Bostelmann, Rike.

At least 19 records

Modeling Enhancements, Cross-Section Generation Updates, and Benchmarking with Shift

This technical report documents the modeling enhancements, cross-section generation updates, and bench marking with the Shift Monte Carlo code performed under the US Department of Energy Nuclear Energy Advanced Modeling and Simulation Program in FY 2024. The work performed included several modeling enhancements, such as integration of cross-section generation in Titan and the ability to produce microscopic multigroup cross sections with Shift. Benchmarking of the cross sections produced by Shift and the two-step workflow with Griffin was performed for three problems: the Advanced Breeder Test Reactor, a generic pebble bed reactor, and a TRISO heat pipe microreactor. Comparisons of results from these benchmark problems were done with Serpent, OpenMC, and Griffin. These enhancements provide a robust foundation for applying Shift for both reference and two-step neutronics analysis for advanced reactor simulation.

97 MATHEMATICS AND COMPUTING↗

SCALE Analyses of Scenarios in the High-Temperature Gas-Cooled Reactor Fuel Cycle

This report demonstrates the SCALE code system’s capabilities in modeling and simulating scenarios in the High-Temperature Gas-cooled Reactor (HTGR) nuclear fuel cycle as part of a United States Nuclear Regulatory Commission (NRC) project that aims to demonstrate the capabilities of the SCALE and MELCOR codes for non-light water reactor (non-LWR) modeling and simulation.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

SCALE Analyses of Scenarios in the Molten Salt Reactor Fuel Cycle

In support of the US Nuclear Regulatory Commission non-light-water reactor fuel cycle demonstration project, the capabilities of SCALE 6.3.1 for radionuclide characterization, criticality, and shielding were demonstrated through several scenarios in a molten salt reactor (MSR) nuclear fuel cycle. Three scenarios were selected for this study, with the molten salt breeder reactor (MSBR) serving as the reference design. The original thorium-based fuel salt used in MSBR was replaced with a 235 U-enriched fuel salt to better reflect anticipated future MSR concepts. The first scenario focused on the fuel salt preparation stage. Criticality analyses, using SCALE/CSAS-Shift and SCALE/SAMPLER, examined potential critical configurations in the fresh fuel salt container based on variables such as 235 U enrichment, UF 4 molar fraction, temperature, and container geometry. The second scenario explored the release of fission products during reactor operation in which the tritium buildup in the primary fuel salt was quantified through depletion calculations using SCALE/TRITON with continuous fuel makeup and fractional fission product removal. This scenario also assessed radioactivity levels in the off-gas system (OGS), quantifying radiotoxic nuclides that could be released into the environment. SCALE/SAMPLER was employed to perform uncertainty quantification to identify key operating parameters influencing the buildup of radiotoxic nuclides in the OGS. Additionally, radiation dose rates were calculated using SCALE/MAVRIC to estimate the maximum exposure levels within the reactor cell complex during operation. The final scenario evaluated the decay heat and radioactivity of the primary fuel salt collected in the drain tank, as well as the radiation dose rate outside the building from the presence of the drain tank. Overall, the application of SCALE’s various capabilities for radionuclide inventory generation, criticality analysis, and shielding in MSR fuel cycles was successfully demonstrated across these scenarios.

22 GENERAL STUDIES OF NUCLEAR REACTORS↗

Advancements in nuclear data evaluations in the unresolved resonance region [Slides]

Minimal updates to current capabilities (SAMMY/AMPX) and to the ENDF format are proposed to include threshold reaction for outgoing charged-particle channels in the URR formalism. If average resonance parameters are reported, probability tables for newly defined reactions channels may be needed, implemented, and tested. Nuclear data evaluation of n+ 35 Cl reactions can be considered the best case to apply the proposed updates.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Extension of SCALE/Sampler’s sensitivity index for the assessment of cross section, fission yield, and decay data uncertainties

Accurate prediction of nuclide compositions and neutron and gamma sources and spectra for fresh and spent nuclear fuel through computational modeling and simulations is the basis for safeguards instruments design, optimization, and calibration, and for validation of the measured responses. The accuracy of these simulations can be significantly impacted by uncertainties in input parameters to the applied computer code. Input parameters are, for example, dimensions, material compositions, and temperatures of the model. Additionally, important but sometimes neglected input parameters for simulations of nuclear systems are the nuclear data that include nuclear reaction cross sections, fission product yields, and decay data. It has been shown that uncertainties of calculated results are dominated by uncertainties of these nuclear data.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

SCALE 6.3.1 Radiation Source Terms and Shielding Analysis for a Postulated Sodium-Cooled Fast Reactor Accident Scenario

In support of the US Nuclear Regulatory Commission non–light-water reactor fuel cycle demonstration project, SCALE 6.3.1 capabilities for radiation source term and shielding calculations are demonstrated for scenarios in the sodium-cooled fast reactor (SFR) fuel cycle. A postulated accident scenario, which consists of a seismic event causing the refueling machine to fall and release a spent fuel assembly inside the containment building (CB), is analyzed in this paper. Radiation source terms were generated for a U/TRU-10Zr metal fuel assembly with a 16.5% initial transuranic waste content and a discharge burnup of approximately 95 GWd/tHM; source terms were also generated for a high-assay low-enriched uranium metal fuel assembly (U-10Zr) with a 16.5% initial enrichment and a discharge burnup of 149.74 GWd/tHM. These radiation source terms were then used to determine the dose rate inside the CB and near the outer surface of the CB for a range of spent fuel assembly cooling times. The dose rate produced by the analyzed SFR assemblies is similar to that produced by a typical pressurized water reactor assembly with a discharge burnup of 50 GWd/MTU. Ultimately, the validation of the source terms predicted for SFRs with SCALE will need to be demonstrated via the use of assay measurements.

Radulescu, Georgeta↗

Path to Automated Validation of ENDF/B-VIII.1 [Slides]

We need to expand the variety of applications to rigorously test libraries. Advanced reactors: – Decreasing reactivity for 8.1b2 compared to 8.0, some unexpected nuclides causing major differences (F-19, Cr), no clear performance difference when compared to experiment. Depletion RCA: – High impact isotopes closer to 7.1 – Small improvement on average (U-5, Pu-9, BC FPs), worse for Am and Cm. Fuel reactivity: – 8.1b2 is higher reactivity at high burnups than 8.0, but likely under predicting k eff for PWRs at high burnup.

97 MATHEMATICS AND COMPUTING↗

Non-LWR Fuel Cycle Scenarios for SCALE and MELCOR Modeling Capability Demonstration

To assess the modeling and simulation capabilities for radionuclide characterization, criticality, and shielding in the nuclear fuel cycle of non-light–water reactor (LWR) technologies, the US Nuclear Regulatory Commission (NRC) initiated a collaborative project between the NRC, Sandia National Laboratories (SNL), and Oak Ridge National Laboratory (ORNL) with the goal to demonstrate capabilities of MELCOR and SCALE to calculate accident scenarios in all stages of the nuclear fuel cycle for relevant non-LWRs. The first project task was to develop representative nuclear fuel cycles and identify potential hazards and accident scenarios in the individual fuel cycle stages based on publicly available information. Because the nuclear fuel cycle is not established for any non-LWR concept, many assumptions were made, and it is anticipated that the details of the fuel cycles will eventually look different.

11 NUCLEAR FUEL CYCLE AND FUEL MATERIALS↗

Fission Product Yields: SCALE/ORNL Perspective [Slides]

This presentation covers a few key points. First and foremost, that ORIGEN is a consumer of FPY data. Secondly, TRITON and POLARIS are assets which can be used to validate new FPY data, e.g., from existing radiochemical benchmarks and new irradiation experiments. Lastly, this presentation finds that new capabilities with covariance data should be developed, and V and V methods and analysis are also needed for the covariance data.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

5-10 Years Cross-cutting Priorities on the Topic of Nuclear Data Covariances and Uncertainty Quantification for Users

The goal of this meeting was to draft a whitepaper on prioritized nuclear data covariance and uncertainty quantification needs impacting users for the next 5 to 10 years. These needs are described herein in an actionable context (i.e., a high-level plan is given to address them), and are feasible for the community to tackle the need (i.e., high-level idea of funding is provided). It should be noted that each of these proposed projects are ideal for training new nuclear data evaluators who are also integrated into application needs.

73 NUCLEAR PHYSICS AND RADIATION PHYSICS↗

Rapid depletion analysis of flowing-pebble reactor systems at equilibrium using SCALE

Several high-temperature gas-cooled reactor concepts (and more recently, salt-cooled designs such as the fluoride salt-cooled high-temperature reactor) feature core designs employing continuously circulating fuel pebbles. These reactor designs permit both continuous online refueling of fuel elements as well as higher overall achievable discharge burnups. However, rapid calculation of time-dependent fuel isotopic inventories proves challenging for this class of dynamic systems with current analysis tools. While iterative approaches employing coupled neutron transport have been developed to solve this issue, rapid depletion analysis techniques are needed to calculate time-dependent inventories for individual pebbles and batches (and thus the construction of full- core inventory at equilibrium). We propose a depletion analysis strategy for this type of system for cores at equilibrium. Drawing upon previous neutronic analysis of the PBMR-400 equilibrium core, we demonstrate the viability of developing collapsed one-group cross section libraries suitable for performing rapid depletion analyses with SCALE. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗

Overview of recent SCALE activities for Non-LWR inventory and decay heat analysis

In 2019, the US Nuclear Regulatory Commission initiated a project for the development and assessments of non-light-water reactor (non-LWR) accident progression using the SCALE and MELCOR simulation tools. SCALE simulations are used to generate nuclide inventories, full-core power distributions, decay heat, and kinetics parameters to initialize MELCOR simulations of severe accident scenarios. Five non-LWR concepts were studied: high-temperature gas-cooled reactor (HTGR), heat pipe reactor (HPR), high-temperature fluoride salt-cooled reactor (FHR), molten salt-fueled reactor (MSR), and sodium-cooled fast reactor (SFR). This paper summarizes the SCALE results obtained in 2021 for the first three non-LWR concepts, compares characteristics and results to common LWRs, and provides the strategy for the analysis of the remaining two non-LWRs. (authors)

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗