Engineering topics

Bogdanoff, David W.

Publications and source records attributed to Bogdanoff, David W..

44 records · Page 3

NASA NTRS1992

Increase of stagnation pressure and enthalpy in shock tunnels

High stagnation pressures and enthalpies are required for the testing of aerospace vehicles such as aerospace planes, aeroassist vehicles, and reentry vehicles. Among the most useful ground test facilities for performing such tests are shock tunnels. With a given driver gas condition, the enthalpy and pressure in the driven tube nozzle reservoir condition can be varied by changing the driven tube geometry and initial gas fill pressure. Reducing the driven tube diameter yields only very modest increases in reservoir pressure and enthalpy. Reducing the driven tube initial gas fill pressure can increase the reservoir enthalpy significantly, but at the cost of reduced reservoir pressure and useful test time. A new technique, the insertion of a converging section in the driven tube is found to produce substantial increases in both reservoir pressure and enthalpy. Using a one-dimensional inviscid full kinetics code, a number of different locations and shapes for the converging driven tube section were studied and the best cases found. For these best cases, for driven tube diameter reductions of factors of 2 and 3, the reservoir pressure can be increased by factors of 2.1 and 3.2, respectively and the enthalpy can be increased by factors of 1.5 and 2.1, respectively.

Bogdanoff, David W.↗

NASA NTRS1992

30 degree injectors at hypervelocity conditions

Results are presented of the first high-speed propulsion-related experiments performed in the NASA-Ames 16-Inch Shock Tunnel, designed to simulate combustor inlet conditions at approximately Mach 14. Results demonstrate the capability of the tunnel for high-speed propulsion testing and yield data on the performance of 30-deg flush wall injectors tested in the tunnel. The experimental results are compared with those of a CFD analysis.

Loomis, Mark P.↗

NASA NTRS1992

Flow characterization in the NASA Ames 16-inch Shock Tunnel

Flow characteristics of NASA's 16-Inch Shock Tunnel are determined for purposes of providing hypersonic propulsion simulation capability. The key tunnel operating parameters are the incident shock speed and reservoir pressure and enthalpy. Flow characteristics of concern are the nozzle exit pressure, temperature, Mach number, Reynolds number, chemical composition, and flow uniformity. Surface mounted gages (for pressure and heat transfer) and nonintrusive optical flow diagnostics (emission and absorption spectroscopy and holographic interferometry) are used to verify tunnel conditions. Experimental measurements are used to validate computational analysis for predicting facility performance, and CFD is used to interpret the free stream optical diagnostic measurements.

Cavolowsky, John A.↗

NASA NTRS1992

Ram accelerator direct space launch system - New concepts

The ram accelerator, a chemically driven ramjet-in-tube device is a new option for direct launch of acceleration-insensitive payloads into earth orbit. The projectile is the centerbody of a ramjet and travels through a tube filled with a premixed fuel-oxidizer mixture. The tube acts as the cowl of the ramjet. A number of new concepts for a ram accelerator space launch system are presented. The velocity and acceleration capabilities of a number of ram accelerator drive modes, including several new modes, are given. Passive (fin) stabilization during atmospheric transit is investigated and found to be promising. Gasdynamic heating in-tube and during atmospheric transit is studied; the former is found to be severe, but may be alleviated by the selection of the most suitable drive modes, transpiration cooling, or a hydrogen gas core in the launch tube. To place the payload in earth orbit, scenarios using one impulse and three impulses (with an aeropass) and a new scenario involving an auxiliary vehicle are studied. The auxiliary vehicle scenario is found to be competitive regarding payload, and requires a much simpler projectile, but has the disadvantage of requiring the auxiliary vehicle.

Bogdanoff, David W.↗

NASA NTRS1992

Experimental investigation of nozzle/plume aerodynamics at hypersonic speeds

An extensive program to improve the operation of the Ames 16 Inch Shock Tunnel was carried out. This included reduction of driver slosh wave amplitudes and detonation risk by the use of premixed He/O2 gas, longer wait times between the last gas load and driver gas ignition, an improved gas loading sequence, the use of four instead of one ignition wire, and the use of lower ignition wire voltages. Successful operation of the tunnel at pressures of 2000-6000 psi and enthalpies up to 12,000 J/gm was achieved. A new diaphragm breaking technique, self break on the driver combustion pressure rise, was tested and found to produce clean breaks over the full pressure range of the tunnel. Improvements were made to the driver gas loading manifold and a preliminary design was made of a gas mixing system which mixes all three gases on the fly just before injection into the driver. Other improvements as well as tests are discussed.

Bogdanoff, David W.↗

NASA NTRS1992

Reactivation and upgrade of the NASA Ames 16-Inch Shock Tunnel - Status report

The NASA Ames 16-Inch Shock Tunnel has been reactivated after seventeen years of inactivity. In the years before deactivating the facility, it was operated at enthalpies of 4,700 J/gm and pressures up to 260 atm or at enthalpies of 1900 J/gm over a wide pressure range. Since reactivating, the facility has been operated at enthalpies up to 12,000 J/gm and pressures up to 408 atm. The present paper describes the steps taken in upgrading the facility and summarizes the currently achievable conditions. The selection of the driver gas, the steps taken to improve the driver burn, and the diaphragm opening techniques are described. The pressure and heat flux instrumentation, the optical diagnostics and the data acquisition system are also described.

Bogdanoff, David W.↗

NASA NTRS1990

Nonequilibrium H2-air reactions in shock tunnel nozzle

A nitrogen-water vapor mixture simulating hydrogen-air combustion products was produced and expanded in the nozzle of the 16-inch Combustion-Driven Shock Tunnel at NASA Ames Research Center. The measured OH concentrations are smaller than those calculated by the conventional one-temperature reaction model even when the reaction rate coefficients are multiplied by a factor of 10. The values calculated by a two-temperature model bound the experimental values under one operating condition, but fail to do so in the other. The discrepancy between experiment and calculation is unresolved.

Lee, Seung-Ho↗

NASA NTRS1989

Vortex gas lens

A vortex gas lens concept is presented. Such a lens has a potential power density capability of 10 to the 9th - 10 to the 10th w/sq cm. An experimental prototype was constructed, and the divergence half angle of the exiting beam was measured as a function of the lens operating parameters. Reasonably good agreement is found between the experimental results and theoretical calculations. The expanded beam was observed to be steady, and no strong, potentially beam-degrading jets were found to issue from the ends of the lens. Estimates of random beam deflection angles to be expected due to boundary layer noise are presented; these angles are very small.

Bogdanoff, David W.↗