Engineering Papers⌕ Search

Engineering topics

Bobbitt, P. J.

Publications and source records attributed to Bobbitt, P. J..

At least 19 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1989

Computational results for the effects of external disturbances on transition location of bodies of revolution from subsonic to supersonic speeds and comparisons with experimental data

Computational experiments have been performed for a few configurations in order to investigate the effects of external flow disturbances on the extent of laminar flow and wake drag. Theoretical results have been compared with experimental data for the AEDC cone, for Mach numbers from subsonic to supersonic, and for both free flight and wind tunnel environments. The comparisons have been found to be very satisfactory, thus establishing the utility of the present method for the design and development of laminar flow configurations and for the assessment of wind tunnel data. In addition, results of calculations concerning the effects of unit Reynolds numbers on transition are presented. In addition to the AEDC cone, computations have been performed for an ogive body of revolution at zero angle of attack and supersonic Mach numbers. Results are presented for transition Reynolds number and wake drag for external disturbances corresponding to free air and the test section of the AEDC-VKF tunnel. These results have been found to compare quite well with wind tunnel data for cases when surface suction is applied as well as when suction is absent.

Goradia, S. H.↗
NASA NTRS1989

Results of correlations for transition location on a clean-up glove installed on an F-14 aircraft and design studies for a laminar glove for the X-29 aircraft accounting for spanwise pressure gradient

Results of correlative and design studies for transition location, laminar and turbulent boundary-layer parameters, and wake drag for forward swept and aft swept wings are presented. These studies were performed with the use of an improved integral-type boundary-layer and transition-prediction methods. Theoretical predictions were compared with flight measurements at subsonic and transonic flow conditions for the variable aft swept wing F-14 aircraft for which experimental pressure distributions, transition locations, and turbulent boundary-layer velocity profiles were measured. Flight data were available at three spanwise stations for several values of sweep, freestream unit Reynolds number, Mach numbers, and lift coefficients. Theory/experiment correlations indicate excellent agreement for both transition location and turbulent boundary-layer parameters. The results of parametric studies performed during the design of a laminar glove for the forward swept wing X-29 aircraft are also presented. These studies include the effects of a spanwise pressure gradient on transition location and wake drag for several values of freestream Reynolds numbers at a freestream Mach number of 0.9.

Goradia, S. H.↗
NASA NTRS1988

Toward lower drag with laminar flow technology

The most promising method of achieving significantly lower skin-friction drag of an aircraft component is through the stabilization and maintenance of a laminar boundary layer over a large fraction of its surface. In a number of applications, however, laminar flow is unfeasible and/or undesirable, and the most efficient turbulent flow design must be provided. The development of both laminar and turbulent airfoil and wing designs over the past decade is reviewed. High, medium, and low-speed airfoil concepts are discussed, and some overall comparisons are made for different Reynolds number ranges.

Harvey, W. D.↗
NASA NTRS1987

Theoretical investigations, and correlative studies for NLF, HLFC, and LFC swept wings at subsonic, transonic and supersonic speeds

Attention is given to the results of theory/experiment-correlation studies for natural laminar flow, LFC, and hybrid-LFC airfoils at subsonic and supersonic Mach numbers. The method of characteristics, integral compressible boundary layer methods for infinitely swept wings, and a method for prediction of separating turbulent boundary layer characteristics. The integral boundary layer methods are found to be successful at predicting both transonic and supersonic transition phenomena. Computations for wings with 0-50 deg sweep angle, Reynolds number range of 1-30 million, and with and without LFC, are in good agreement with experimental data.

Goradia, S. H.↗
NASA NTRS1985

Semiempirical method for predicting vortex-induced rolling moments

A method is described for the prediction of rolling moments on a wing penetrating a vortex velocity field generated by a large aircraft. Rolling moments are determined from lifting pressure coefficients computed with an inviscid-flow linear panel method. Two empirical corrections are included to account for the lifting efficiency of an airfoil section and the local stall on the wing. Predicted rolling moments are compared with those from two windtunnel experiments. Results indicate that experimental rolling moments, for which the Reynolds number of the following wing is low, should be interpreted with caution.

Allison, D. O.↗
NASA NTRS1985

Pivotable strakes for high angle of attack control

A series of pivotable strakes have been tested in combination with a 44-deg swept wing to determine their ability to provide pitch control at high angles of attack. The tests were carried out in the Langley 7 X 10-Foot High-Speed tunnel at nominal Mach numbers of 0.3 to 0.4. A total of five strakes with various aspects ratios and shapes were tested at negative deflection angles of 5, 10, 15, and 20 deg through an angle of attack range up to approximately 50 deg. In addition, a cranked delta wing with 70-deg sweep was tested with two different pivotable apex flaps. This paper shows lift, drag and moment data for the complete configurations as well as for the separate contributions of the strakes and fuselage nose which are mounted on a second balance. Generally, strake deflection was found to have a significant effect on moment while lift/drag changed very little.

Bobbitt, P. J.↗
NASA NTRS1985

A faster 'transition' to laminar flow

A discussion is given of the ongoing research related to laminar flow airfoils, nacelles, and wings where the laminar flow is maintained by a favorable pressure gradient, surface suction or a combination of the two. Design methologies for natural laminar flow airfoil sections and wings for both low and high speed applications are outlined. Tests of a 7-foot chord, 23-deg sweep laminar flow-control airfoil at high subsonic Mach numbers are described, along with the associated stability theory used to design the suction system. The state-of-the-art of stability theory is simply stated and a typical calculation illustrated. In addition, recent computer simulations of transition using the time dependent Navier-Stokes equations are briefly described. Advances in wind tunnel capabilities and instrumentation will be reviewed, followed by the presentation of a few results from both wind tunnels and flight. Finally, some suggestions for future work will complete the paper.

Bobbitt, P. J.↗
NASA NTRS1983

Supersonic loads due to shuttle-orbiter/external-tank attachment structures

A large variety of tests were conducted during development of the Space Shuttle to determine the strength, fatigue, and thermal characteristics of the thermal-protection system of the orbiter. The research and analysis carried out to accurately define and simulate the flow characteristics immediately ahead of the external tank attachment structures are described. The highest known acoustic pressure loads occur in these regions and tests to insure the ability of the titles to withstand these acoustic loads, plus those due to pressure gradient, were thought necessary. First flight-critical wind tunnel tests were therefore conducted in the Langley 8-Foot Transonic Pressure Tunnel (8-Ft. TPT), which simulated the time histories of Shuttle ascent loads on tile arrays bonded to structures which accurately duplicated those of the Shuttle. The time-varying free stream conditions were provided by controlling the deflection angle history of diffuser spoiler flaps in an automated way. Time histories of the critical load parameters imposed on the tile arrays in the tunnel are compared with those expected in flight.

Edwards, C. L. W.↗
NASA NTRS1982

The simulation of time varying ascent loads on arrays of Shuttle tiles in a large transonic tunnel

A large variety of tests were made to determine the strength, fatigue and thermal characteristics of the thermal-protection system of the Shuttle orbiter. The present paper describes first-launch-critical tests which were conducted in the Langley 8-Foot Transonic Pressure Tunnel (8'TPT) which simulated the time histories of Shuttle ascent loads on tile arrays bonded to structures which accurately duplicated those of the Shuttle. The time varying free-stream conditions were provided by controlling the deflection angle history of diffuser spoiler flaps in an automated way. Time histories of the critical-load parameters imposed on the tile arrays in the tunnel are compared in the paper to those expected in flight. In addition, the effect of repeated load pulses on the smoothness of the surface and condition of the tiles is discussed briefly.

Bobbitt, P. J.↗
NASA NTRS1981

Report of the panel on fluid dynamics

Areas of investigation in fluid dynamics, recommended experiments, and use of the facility for theory evaluation are discussed. Tunnel flow quality and calibration of the NTF are considered. Recent technological advances affecting tunnel design are surveyed.

Bobbitt, P. J.↗
NASA NTRS1981

Some anomalies between wind tunnel and flight transition results

A review of environmental disturbance influence and boundary layer transition measurements on a large collection of reference sharp cone tests in wind tunnels and of recent transonic-supersonic cone flight results have previously demonstrated the dominance of free-stream disturbance level on the transition process from the beginning to end. Variation of the ratio of transition Reynolds number at onset-to-end with Mach number has been shown to be consistently different between flight and wind tunnels. Previous correlations of the end of transition with disturbance level give good results for flight and large number of tunnels, however, anomalies occur for similar correlation based on transition onset. Present cone results with a tunnel sonic throat reduced the disturbance level by an order of magnitude with transition values comparable to flight.

Harvey, W. D.↗
NASA NTRS1980

Modern fluid dynamics of subsonic and transonic flight

The paper discusses a number of factors, termed research drivers, which are expected to provide much of the stimulus for research in the subsonic and transonic flight regimes in the coming decade. The research drivers discussed comprise the need for energy efficiency, new and improved facilities, better instrumentation, more capable and efficient computers, theoretical methodology refinements, increased use of optimization techniques, and military requirements. Illustrations of advances in aircraft aerodynamics at subsonic and transonic speeds are presented, along with a discussion of future research opportunities and trends. Particular attention is given to airfoil and basic fluids research designed to reduce skin-friction drag.

Bobbitt, P. J.↗
NASA NTRS1980

The prediction of pressure distributions on an arrow-wing configuration including the effect of camber, twist, and a wing fin

Wind tunnel tests of an arrow wing body configuration consisting of flat, twisted, and cambered twisted wings were conducted at Mach numbers from 0.40 to 2.50 to provide an experimental data base for comparison with theoretical methods. A variety of leading and trailing edge control surface deflections were included in these tests, and in addition, the cambered twisted wing was tested with an outboard vertical fin to determine its effect on wing and control surface loads. Theory experiment comparisons show that current state of the art linear and nonlinear attached flow methods were adequate at small angles of attack typical of cruise conditions. The incremental effects of outboard fin, wing twist, and wing camber are most accurately predicted by the advanced panel method PANAIR. Results of the advanced panel separated flow method, obtained with an early version of the program, show promise that accurate detailed pressure predictions may soon be possible for an aeroelasticity deformed wing at high angles of attack.

Bobbitt, P. J.↗
NASA NTRS1979

Langley airfoil-research program

An overview of past, present, and future airfoil research activities at the Langley Research Center is given. The immediate past and future occupy most of the discussion; however, past accomplishments and milestones going back to the early NACA years are dealt with in a broad-brush way to give a better perspective of current developments and programs. In addition to the historical perspective, a short description of the facilities which are now being used in the airfoil program is given. This is followed by a discussion of airfoil developments, advances in airfoil design and analysis tools (mostly those that have taken place over the past 5 or 6 years), and tunnel-wall-interference predictive methods and measurements. Future research requirements are treated.

Bobbitt, P. J.↗
NASA NTRS1977

Comparisons of Theoretical and Experimental Pressure Distributions on an Arrow-Wing Configuration at Subsonic, Transonic, and Supersonic Speeds

A wind tunnel test of an arrow wing body configuration consisting of flat and twisted wings, as well as a variety of leading- and trailing-edge control surface deflection, has been conducted at Mach numbers from 0.40 to 2.50 to provide an experimental data base for comparison with theoretical methods. Theory-to-experiment comparisons of detailed pressure distributions have been made using current state-of-the-art attached- and separated-flow methods. The purpose of these comparisons was to delineate conditions under which these theories are valid for aeroelastic calculations and to explore the use of empirical methods to correct the theoretical methods where theory is deficient. It was determined that current state-of-the-art attached flow and empirical methods were inadequate to predict aeroelastic loads for this configuration.

Manro, M. E.↗
NASA NTRS1977

Report of the panel on theoretical aerodynamics

Requirements for flow quality in the National Transonic Facility are explored. Viscous flow effects of concern to theoreticians are discussed. Experiments outlined for theory validation in the facility include validating high aspect ratio wing-body combination; low aspect ratio moderately swept wing; low aspect ratio highly swept wing; high lift systems on high aspect ration wings; Reynolds number scaling; dynamic shock- boundary layer interaction; and the effect of R and M on dynamic stall.

Bobbitt, P. J.↗