Engineering Papers⌕ Search

Engineering topics

Bloom, A. M.

Publications and source records attributed to Bloom, A. M..

7 records
All sourcesNASA NTRSDOE OSTI
NASA NTRS1976

Wing surface-jet interaction characteristics of an upper-surface blown model with rectangular exhaust nozzles and a radius flap

The wing surface jet interaction characteristics of an upper surface blown transport configuration were investigated in the Langley V/STOL tunnel. Velocity profiles at the inboard engine center line were measured for several chordwise locations, and chordwise pressure distributions on the flap were obtained. The model represented a four engine arrangement having relatively high aspect ratio rectangular spread, exhaust nozzles and a simple trailing edge radius flap.

Bloom, A. M.↗
NASA NTRS1976

Solar energy storage and utilization

A method of storing solar energy in the ground for heating residential buildings is described. The method would utilize heat exchanger pipes with a circulating fluid to transfer the energy beneath the surface as well as to extract the stored energy.

Yuan, S. W.↗
NASA NTRS1975

Wind tunnel investigation of the wake near the trailing edge of a distributed upper-surface-blown flap

An investigation of the flow field near the trailing edge of a distributed upper-surface-blown propulsive-lift transport was conducted in the Langley V/STOL tunnel. This model used blowing slots across the entire wing span to produce a thin jet efflux near the leading edge and at the knee of the flap. Velocity surveys of the flow field were taken near the trailing edge of the model, and are presented as plots of the individual velocity vectors. The test conditions include an angle-of-attack range from 4 deg to 16 deg and a thrust coefficient range from 0 to 1.3 at a free-stream dynamic pressure of 814 Newton per square meter (17 pounds per square foot).

Forsyth, D. R.↗
NASA NTRS1974

Roll-up of aircraft trailing vortices using artificial viscosity

The artificial viscosity method of Kuwahara and Takami (1973) is used to calculate the roll-up of trailing vortices behind a number of practical aerodynamic configurations. Where possible, the results are compared for core location with available experimental data.

Bloom, A. M.↗
NASA NTRS1974

Computer simulation of the NASA water vapor electrolysis reactor

The water vapor electrolysis (WVE) reactor is a spacecraft waste reclamation system for extended-mission manned spacecraft. The WVE reactor's raw material is water, its product oxygen. A computer simulation of the WVE operational processes provided the data required for an optimal design of the WVE unit. The simulation process was implemented with the aid of a FORTRAN IV routine.

Bloom, A. M.↗