Engineering topics

Blair, Mark A.

Publications and source records attributed to Blair, Mark A..

4 records

NASA NTRS1990

Space Shuttle payload trunnion interface verification test and correlation with fixed based responses

An interface verification test (IFVT) in the free-free condition was conducted to verify that the constrained modes of a mass simulator had the same frequencies as the Hubble Space Telescope, for which it was designed. Landing tests were performed in which the mass simulator was mounted on its trunnions inside a container onboard an aircraft. Its acceleration response was adequately measured, and the anticipated constrained natural frequencies based on the IFVT were confirmed. The first test updated the model to predict the fixed based modes, and the second verified the test's capacity to characterize the structure. The IFVT is shown to generate information which permits accurate modeling of the constrained structure, without requiring the traditional fixed-based modal test.

Blair, Mark A.↗

NASA NTRS1989

Hubble Space Telescope-Space Shuttle interface dynamic verification test

A test program has been developed for the interface between the Space Shuttle Orbiter and the Hubble Space Telescope which couples a standard modal test for a simple suspended structure with a novel, 'interface verification' test. While the free-free modal test is used to verify the high loads generating structural modes due to the interaction of internal components of the structure with the rest of the structure, the interface verification test verifies the character of the high-loading generating modes in which the structure reacts against the booster interface. The novel method excites the structure at a single payload-booster interface DOF, while all other interfaces are left free to move.

Blair, Mark A.↗

NASA NTRS1988

Constrained structural dynamic model verification using free vehicle suspension testing methods

Verification of the validity of a spacecraft's structural dynamic math model used in computing ascent (or in the case of the STS, ascent and landing) loads is mandatory. This verification process requires that tests be carried out on both the payload and the math model such that the ensuing correlation may validate the flight loads calculations. To properly achieve this goal, the tests should be performed with the payload in the launch constraint (i.e., held fixed at only the payload-booster interface DOFs). The practical achievement of this set of boundary conditions is quite difficult, especially with larger payloads, such as the 12-ton Hubble Space Telescope. The development of equations in the paper will show that by exciting the payload at its booster interface while it is suspended in the 'free-free' state, a set of transfer functions can be produced that will have minima that are directly related to the fundamental modes of the payload when it is constrained in its launch configuration.

Blair, Mark A.↗

NASA NTRS1988

Jitter performance test for the Hubble Space Telescope - Method and results

The types of on-board equipment on the Hubble Space Telescope (HST) that can cause jitter are identified. Tests designed and conducted to measure the motion of the focal plane due to disturbances from the on-board equipment are then described. Test results are presented for two types of jitter-producing equipment: the reaction wheel assemblies and the engineering/science tape recorders.

Blair, Mark A.↗