Engineering Papers⌕ Search

Engineering topics

Birr, Richard B.

Publications and source records attributed to Birr, Richard B..

Unmanned Aviation Systems Models of the Radio Communications Links: Study Results - Appendices Annex 2. Volume 1 and Volume 2

This report describes the analysis of communications between the Control Station and an Unmanned Aircraft (UA) flying in the National Airspace System (NAS). This work is based on the RTCA SC-203 Operational Services and Environment Description (OSED). The OSED document seeks to characterize the highly different attributes of all UAs navigating the airspace and define their relationship to airspace users, air traffic services, and operating environments of the NAS. One goal of this report is to lead to the development of Minimum Aviation System Performance Standards for Control and Communications. This report takes the nine scenarios found in the OSED and analyzes the communication links.

Birr, Richard B.↗

UAS Modeling of the Communication Links Study Results

The Federal Aviation Administration (FAA) is the authority that grants access into, and operations within, the National Airspace System (NAS) for all aircraft, including Unmanned Aircraft Systems (UAS). The safe operation of UAS in the NAS must be assured if the full potential of UAS is to be realized and supported by the public and Congress. This report analyzed the communication systems that are needed for the safe operations of UAS in the NAS. Safe operations can be defined as the availability of the required links to carry the information to control the UAS and the return links to allow controllers to know where the UAS is at any given moment as well as how it is performing. This report is the end result of work performed jointly between the FAA and National Aeronautics and Space Administration (NASA)/Kennedy Space Center (NASA KSC). The work was done in support of the Radio Technical Commission for Aeronautics (RTCA) Special Committee 203 (SC-203) Control and Communications Working Group. The RTCA is a federal advisory committee to the FAA. Though the work was not under the direction of the working group, a large part of the specific values used in the simulations came from the working group. Specifically, all of the radio links were modeled based on the formulation completed by the working group. This report analyzed three scenarios from RTCA SC-203 that represent how a UAS would operate in the NAS. Each scenario was created using the Satellite Tool Kit (STK) modeling and simulation tool. The flight paths of the UAS were generated and the UAS dynamics were likewise modeled. Then each communication asset such as transmitters, receivers, and antennas were modeled and placed on the appropriate UAS, satellite, or Control Station (CS). After that, the radio links were analyzed for signal strength and antenna blockage, and the overall link performance was analyzed in detail. The goal was to obtain 99.9% availability on all of the radio communication links. In order to ensure the 99.9% availability, certain values for the telemetry transmitter will have to be increased slightly from I watt up to about 4 watts which is reasonable. The results of this analysis show that it is possible to send commands, during the airborne segment, to the Unmanned Aircraft (UA) and have the UA send back the system health and status with high availability of at least 99.9% of the time. This 99.9% availability included the condition of heavy rain at 90 mm/hr as well as interference from adjacent satellites. The link budget values used in this report were based on the work from the working group.

Birr, Richard B.↗

Communication system with adaptive noise suppression

A signal-to-noise ratio dependent adaptive spectral subtraction process eliminates noise from noise-corrupted speech signals. The process first pre-emphasizes the frequency components of the input sound signal which contain the consonant information in human speech. Next, a signal-to-noise ratio is determined and a spectral subtraction proportion adjusted appropriately. After spectral subtraction, low amplitude signals can be squelched. A single microphone is used to obtain both the noise-corrupted speech and the average noise estimate. This is done by determining if the frame of data being sampled is a voiced or unvoiced frame. During unvoiced frames an estimate of the noise is obtained. A running average of the noise is used to approximate the expected value of the noise. Spectral subtraction may be performed on a composite noise-corrupted signal, or upon individual sub-bands of the noise-corrupted signal. Pre-averaging of the input signal's magnitude spectrum over multiple time frames may be performed to reduce musical noise.

Kozel, David↗

Space-Based Telemetry and Range Safety Project Ku-Band and Ka-Band Phased Array Antenna

The National Aeronautics and Space Administration Space-Based Telemetry and Range Safety study is a multiphase project to increase data rates and flexibility and decrease costs by using space-based communications assets for telemetry during launches and landings. Phase 1 used standard S-band antennas with the Tracking and Data Relay Satellite System to obtain a baseline performance. The selection process and available resources for Phase 2 resulted in a Ku-band phased array antenna system. Several development efforts are under way for a Ka-band phased array antenna system for Phase 3. Each phase includes test flights to demonstrate performance and capabilities. Successful completion of this project will result in a set of communications requirements for the next generation of launch vehicles.

Whiteman, Donald E.↗

Ku- and Ka-Band Phased Array Antenna for the Space-Based Telemetry and Range Safety Project

The National Aeronautics and Space Administration Space-Based Telemetry and Range Safety study is a multiphase project to increase data rates and flexibility and decrease costs by using space-based communications assets for telemetry during launches and landings. Phase 1 used standard S-band antennas with the Tracking and Data Relay Satellite System to obtain a baseline performance. The selection process and available resources for Phase 2 resulted in a Ku-band phased array antenna system. Several development efforts are under way for a Ka-band phased array antenna system for Phase 3. Each phase includes test flights to demonstrate performance and capabilities. Successful completion of this project will result in a set of communications requirements for the next generation of launch vehicles.

Whiteman, Donald E.↗

Adaptive Suppression of Noise in Voice Communications

A subsystem for the adaptive suppression of noise in a voice communication system effects a high level of reduction of noise that enters the system through microphones. The subsystem includes a digital signal processor (DSP) plus circuitry that implements voice-recognition and spectral- manipulation techniques. The development of the adaptive noise-suppression subsystem was prompted by the following considerations: During processing of the space shuttle at Kennedy Space Center, voice communications among test team members have been significantly impaired in several instances because some test participants have had to communicate from locations with high ambient noise levels. Ear protection for the personnel involved is commercially available and is used in such situations. However, commercially available noise-canceling microphones do not provide sufficient reduction of noise that enters through microphones and thus becomes transmitted on outbound communication links.

Kozel, David↗