Birkner, Bjorn W. | Engineering Papers

NASA NTRS1991

Effect of an arcjet plume on satellite reflector performance

The effect of an arcjet plume on the performance of satellite reflector antennas is studied. The arcjet plume is modeled as a weakly ionized plasma. The spatial permittivity distribution of the plume is approximated using the measured electron density profile and a cold plasma model. Geometrical optics is applied to determine the ray paths as well as the transmitted fields through the inhomogeneous plume. The ray optics results are compared against several exact solutions for scattering from inhomogeneous dielectrics, and good agreement is observed for sufficiently large scatterer size. The far-field antenna patterns of the reflector in the presence of the plume are calculated from the transmitted ray fields using a ray-tube integration scheme. For arcjet prototypes in the 1-kW class, the plume effect on the antenna performance is small. As the electron density increases, the main beam and sidelobe level gradually degrade. The main beam also tends to squint away from the plume region.

Ling, Hao↗

NASA NTRS1990

Arcjet Nozzle Area Ratio Effects

An experimental investigation was conducted to determine the effect of nozzle area ratio on the operating characteristics and performance of a low power dc arcjet thruster. Conical thoriated tungsten nozzle inserts were tested in a modular laboratory arcjet thruster run on hydrogen/nitrogen mixtures simulating the decomposition products of hydrazine. The converging and diverging sides of the inserts had half angles of 30 and 20 degrees, respectively, similar to a flight type unit currently under development. The length of the diverging side was varied to change the area ratio. The nozzle inserts were run over a wide range of specific power. Current, voltage, mass flow rate, and thrust were monitored to provide accurate comparisons between tests. While small differences in performance were observed between the two nozzle inserts, it was determined that for each nozzle insert, arcjet performance improved with increasing nozzle area ratio to the highest area ratio tested and that the losses become very pronounced for area ratios below 50. These trends are somewhat different than those obtained in previous experimental and analytical studies of low Re number nozzles. It appears that arcjet performance can be enhanced via area ratio optimization.

Curran, Francis M.↗

NASA NTRS1990

Arcjet nozzle area ratio effects

An experimental investigation was conducted to determine the effect of nozzle area ratio on the operating characteristics and performance of a low power dc arcjet thruster. Conical thoriated tungsten nozzle inserts were tested in a modular laboratory arcjet thruster run on hydrogen/nitrogen mixtures simulating the decomposition products of hydrazine. The converging and diverging sides of the inserts had half angles of 30 and 20 degrees, respectively, similar to a flight type unit currently under development. The length of the diverging side was varied to change the area ratio. The nozzle inserts were run over a wide range of specific power. Current, voltage, mass flow rate, and thrust were monitored to provide accurate comparisons between tests. While small differences in performance were observed between the two nozzle inserts, it was determined that for each nozzle insert, arcjet performance improved with increasing nozzle area ratio to the highest area ratio tested and that the losses become very pronounced for area ratios below 50. These trends are somewhat different than those obtained in previous experimental and analytical studies of low Re number nozzles. It appears that arcjet performance can be enhanced via area ratio optimization.

Curran, Francis M.↗