Engineering topics

Bird, G. A.

Publications and source records attributed to Bird, G. A..

22 records · Page 2

NASA NTRS1984

Direct simulation of transitional flow for hypersonic reentry conditions

This paper presents results of flowfield calculations for typical hypersonic reentry conditions encountered by the nose region of the Space Shuttle Orbiter. Most of the transitional flow regime is covered by the altitude range of 150 to 92 km. Calculations were made with the Direct Simulation Monte Carlo (DSMC) method that accounts for translational, rotational, vibrational, and chemical nonequilibrium effects. Comparison of the DSMC heating results with both Shuttle flight data and continuum predictions showed good agreement at the lowest altitude considered. However, as the altitude increased, the continuum predictions, which did not include slip effects, departed rapidly from the DSMC results by overpredicting both heating and drag. The results demonstrate the effects of rarefaction on the shock and the shock layer, along with the extent of the slip and temperature jump at the surface. Also, the sensitivity of the flow structure to the gas-surface interaction model, thermal accommodation, and surface catalysis are studied.

Moss, J. N.↗

NASA NTRS1984

Analysis of large solid propellant rocket engine exhaust plumes using the direct simulation Monte Carlo method

A new solution procedure has been developed to analyze the flowfield properties in the vicinity of the Inertial Upper Stage/Spacecraft during the 1st stage (SRMI) burn. Continuum methods are used to compute the nozzle flow and the exhaust plume flowfield as far as the boundary where the breakdown of translational equilibrium leaves these methods invalid. The Direct Simulation Monte Carlo (DSMC) method is applied everywhere beyond this breakdown boundary. The flowfield distributions of density, velocity, temperature, relative abundance, surface flux density, and pressure are discussed for each species for 2 sets of boundary conditions: vacuum and freestream. The interaction of the exhaust plume and the freestream with the spacecraft and the 2-stream direct interaction are discussed. The results show that the low density, high velocity, counter flowing free-stream substantially modifies the flowfield properties and the flux density incident on the spacecraft. A freestream bow shock is observed in the data, located forward of the high density region of the exhaust plume into which the freestream gas does not penetrate. The total flux density incident on the spacecraft, integrated over the SRM1 burn interval is estimated to be of the order of 10 to the 22nd per sq m (about 1000 atomic layers).

Hueser, J. E.↗

NASA NTRS1981

Spacecraft outgas ambient flow interaction

An investigation has been made of the extent to which outgassed or emitted molecules return to a spacecraft as a result of intermolecular collisions with ambient freestream molecules. The governing parameters are discussed and heuristic arguments are used to predict the combination of parameters that is most likely to describe the return flux ratio. This is then tested by an extensive set of numerical calculations using the direct simulation Monte Carlo method. Computations have been made for the flow past spheres and past circular cylinders with their axes normal in the stream. The numerical results lead to empirical expressions that can be used for engineering estimates in spacecraft contamination studies.

Bird, G. A.↗

NASA NTRS1978

One-dimensional outgassing problem

A predominantly numerical study, using the direct-simulation Monte Carlo method, of the flow from outgassing surfaces with plane, cylindrical, or spherical geometry is presented. The numerical results for the plane flow case are compared with existing theoretical and experimental results and also with a new formulation of the jump conditions across the Knudsen layer between the surface and the continuum outflow. This outflow is sonic for the free expansion case but subsonic in the presence of back-pressure effects. The self-scattered return flux is 19% of the outgassed flux in the sonic outflow case and increases at lower Mach numbers. Thermal accomodation and reflection of this return flux produces an outgassing cooling effect. The cylindrical and spherical geometries introduce an additional Knudsen number defined by the ratio of the mean free path in the effusing gas to the radius. The plane flow results apply when this Knudsen number is less than 0.001 and, when it is of order unity or above, the return flux is inversely proportional to it.

Tran Cong, T.↗