Engineering Papers⌕ Search

Engineering topics

Bhat, C

Publications and source records attributed to Bhat, C.

Implementation of longitudinal dynamics with barrier RF in BETACOOL and comparison to ESME

The barrier bucket RF system is successfully used on Recycler storage ring at Fermilab. The special program code ESME was used for numerical simulation of longitudinal phase space manipulations. This program helps optimizing the various regimes of operation in the Recycler and increasing the luminosity in the colliding experiments. Electron and stochastic cooling increases the phase space density in all degrees of freedom. In the case of a small phase space volume the intrabeam scattering introduces coupling between the transverse and longitudinal temperatures of the antiproton beam. For numerical simulations of the cooling processes at the Recycler, a new model of the barrier buckets was implemented in the BETACOOL code. The comparison between ESME and BETACOOL codes for a stationary and moving barrier buckets is presented. This article also includes an application of the barrier bucket numerical model for simulation of the luminosity distribution for RHIC colliding experiments. These simulations take into account the specific longitudinal distribution of the bunch and the vertex size of the detector.

43 PARTICLE ACCELERATORS↗

Stability of Flat Bunches in the Recycler Barrier Bucket

We examine the stability of intense flat bunches in barrier buckets used in the Fermilab Recycler. We consider some common stationary distributions and show that they would be unstable against rigid dipole oscillations. We discuss the measurements which identify stable distributions. We also report on experimental studies on the impact of creating a local extremum of the incoherent frequency within the rf bucket. We considered two typical stationary distributions and found they were not adequate descriptions of the Recycler bunches. From the measured line density distribution we find (a) the tanh function is a good fit to the line density, and (b) the coherent frequency of the rigid dipole mode for this distribution is within the incoherent spread at nominal intensities. Stability diagrams when the beam couples to space charge and external impedances will be discussed elsewhere. Our initial experimental investigations indicate that longitudinal stability in the Recycler is, consistent with expectations, influenced by the ratio T{sub 2}/(4T{sub 1}) which determines the location of the extremum of the incoherent tune. The coherent tune depends strongly on the distribution in the bunch tails which is difficult to measure. Numerical studies using both a conventional tracking code and a Vlasov solver are in progress and should provide more insight into conditions that may lead to unstable behavior.

43 PARTICLE ACCELERATORS↗

Stabilizing effect of a double-harmonic RF system in the CERN PS

Motivated by the discussions on scenarios for LHC upgrades, beam studies on the stability of flat bunches in a double-harmonic RF system have been conducted in the CERN Proton Synchrotron (PS). Injecting nearly nominal LHC beam intensity per cycle, 18 bunches are accelerated on harmonic h = 21 to 26GeV with the 10MHz RF system. On the flat-top, all bunches are then transformed to flat bunches by adiabatically adding RF voltage at h = 42 from a 20 MHz cavity in anti-phase to the h = 21 system. The voltage ratio V (h42)/V (h21) of about 0.5 was set according to simulations. For the next 140 ms, longitudinal profiles show stable bunches in the double-harmonic RF bucket until extraction. Without the second harmonic component, coupled-bunch oscillations are observed. The flatness of the bunches along the batch is analyzed as a measure of the relative phase error between the RF systems due to beam loading. The results of beam dynamics simulations and their comparison with the measured data are presented.

43 PARTICLE ACCELERATORS↗

Muon Collider Task Force Report

Muon Colliders offer a possible long term path to lepton-lepton collisions at center-of-mass energies {radical}s {ge} 1 TeV. In October 2006 the Muon Collider Task Force (MCTF) proposed a program of advanced accelerator R&D aimed at developing the Muon Collider concept. The proposed R&D program was motivated by progress on Muon Collider design in general, and in particular, by new ideas that have emerged on muon cooling channel design. The scope of the proposed MCTF R&D program includes muon collider design studies, helical cooling channel design and simulation, high temperature superconducting solenoid studies, an experimental program using beams to test cooling channel RF cavities and a 6D cooling demonstration channel. The first year of MCTF activities are summarized in this report together with a brief description of the anticipated FY08 R&D activities. In its first year the MCTF has made progress on (1) Muon Collider ring studies, (2) 6D cooling channel design and simulation studies with an emphasis on the HCC scheme, (3) beam preparations for the first HPRF cavity beam test, (4) preparations for an HCC four-coil test, (5) further development of the MANX experiment ideas and studies of the muon beam possibilities at Fermilab, (6) studies of how to integrate RF into an HCC in preparation for a component development program, and (7) HTS conductor and magnet studies to prepare for an evaluation of the prospects for of an HTS high-field solenoid build for a muon cooling channel.

43 PARTICLE ACCELERATORS↗