Engineering topics

Betti, R. [University of Rochester, NY (United States)]

Publications and source records attributed to Betti, R. [University of Rochester, NY (United States)].

6 records

DOE OSTI2026

Performance enhancement of direct-drive shock-augmented ignition inertial fusion implosions through shock timing optimization

Shock-augmented ignition (SAI) [R. H. H. Scott et al., Phys. Rev. Lett. 129, 195001 (2022)] is an alternative inertial confinement fusion concept that is designed to achieve high energy gain by combining improved resilience to instabilities with enhanced fuel compression. In SAI, lower implosion velocities can improve hydrodynamic stability and limited laser intensities reduce the excitation of detrimental laser-plasma instabilities, enabling greater areal density accumulation. Here we report an experimental investigation of SAI using a series of warm D 2 implosions. By timing the augmenting shock to arrive at the implosion center immediately prior to peak compression, the areal density and hot-spot pressure increase by 50% and 112%, respectively, relative to unoptimized designs. Ignition-scale simulations reproduce the observed timing dependence and demonstrate the potential of SAI for inertial fusion energy.

Direct drive↗

DOE OSTI2026

Wetted-foam target stability for laser-direct-drive inertial confinement fusion

Using highly resolved three-dimensional radiation-hydrodynamic simulations, the effects of wetted-foam (WF) ablators in direct-drive inertial confinement fusion cryogenic implosions on the OMEGA laser were investigated. The performance of these implosions was compared with that of implosions using targets with solid-plastic ablators. Simulations considering WF ablators as a homogeneous material show no mitigation of the effects of laser imprint, where the absence of this mitigation can be attributed to the use of picket pulses. Heterogeneous random-structure WF ablators introduce large short-wavelength perturbations, which are seeded by WF inhomogeneities. These perturbations exceed the perturbations seeded by the imprint and cause an additional reduction in implosion performance when the average pore size in the WF exceeds ~0.2 μm. Foam-seeded perturbations are expected to be less damaging in more stable high-adiabat (⁠ ≳ 5⁠) implosions. Here, the perturbations introduced by the WF ablators can be substantially reduced by using a foam matrix with a layered structure instead of a random one. Further study of the effects of WFs in ignition designs of the MJ laser energy scale is required in the perspective of future inertial fusion energy mass production.

Igumenshchev, I. V. [University of Rochester, NY (↗

DOE OSTI2025

Three-dimensional reconstruction of inertial confinement fusion hot-spot plasma from x-ray and nuclear diagnostics on OMEGA

Multidimensional effects degrade the neutron yield and the compressed areal density of laser-direct-drive inertial confinement fusion implosions of layered deuterium–tritium cryogenic targets on the OMEGA Laser System with respect to 1D radiation-hydrodynamic simulation predictions. A comprehensive physics-informed 3D reconstruction effort is under way to infer hot-spot and shell conditions at stagnation from four x-ray and seven neutron detectors distributed around the OMEGA target chamber. Neutron diagnostics, providing measurements of the neutron yield, hot-spot flow velocity, and apparent ion-temperature distribution, are used to infer the mode-1 perturbation at stagnation. The x-ray imagers record the shape of the hot-spot plasma to diagnose mode-1 and mode-2 perturbations. A deep-learning convolutional neural network trained on an extensive set of 3D radiation-hydrodynamic simulations is used to interpret the x-ray and nuclear measurements to infer the 3D profiles of the hot-spot plasma conditions and the amount of laser energy coupled to the hot-spot plasma. A 3D simulation database shows that larger mode-1 asymmetries are correlated with higher hot-spot flow velocities and reduced laser-energy coupling and neutron yield. Three-dimensional hot-spot reconstructions from x-ray measurements indicate that higher amounts of residual kinetic energy are correlated with higher measured hot-spot flow velocities, consistent with 3D simulations.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2025

Inference of the neutron down-scatter ratio using neutron time-of-flight data for DT-layered implosions on the OMEGA laser

First analysis of the neutron time of flight (nTOF) data is presented to infer the areal density using the neutron down-scatter ratio (DSR) for OMEGA deuterium–tritium (DT)-layered (cryogenic) implosions. The required very-high-dynamic range (nTOF) signal is constructed using an nTOF detector [Forrest et al., Rev. Sci. Ins. 83, 10D919 (2012)] with multiple time-gated photomultiplier tubes. The nTOF data are analyzed using a forward-fit technique to account for the detector responses and infer the DSR and areal density for DT-layered implosions. The areal densities inferred using this analysis are found to be in agreement with the areal densities measured using the magnetic recoil spectrometer detector that is located in a similar line-of-sight. This work establishes the feasibility of the DSR measurement using nTOF data on OMEGA and provides an additional areal-density measurement that will benefit the assessment of the implosion performance and 3D reconstruction of the imploded core.

47 OTHER INSTRUMENTATION↗

DOE OSTI2025

An experimentally informed design process for future inertial confinement fusion facilities

The achievement of ignition in the laboratory has renewed interest in defining the requirements for a future high-gain inertial confinement fusion (ICF) facility. Our best chance of predicting future ICF performance is with 3-D radiation hydrodynamic simulations that have been benchmarked against experimental data, but their high computational cost is prohibitive for use in practical design studies. We introduce a hierarchical approach where 3-D simulations are tuned to match experimental measurements and used to train 3-D degradation models in 1-D simulations allowing for accurate predictions over the entire OMEGA direct-drive database. A genetic algorithm was used in combination with the trained 1-D simulations to search for optimal direct-drive implosion designs at driver energies ranging from 20 kJ to 10 MJ. As the fidelity of 3-D codes improves, this approach will provide a viable experimentally informed tool for defining the next ICF facility.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2025

Progress toward hydro-equivalent ignition in OMEGA direct-drive DT-layered implosions

Considerable progress has been made in deuterium-tritium-layered implosion experiments on the OMEGA Laser System, bringing the prospects for thermonuclear ignition in direct-drive configurations with megajoule-class lasers closer to reality. Doing so has required navigating the balance between improved 1D performance and multidimensional stability. Using statistical modeling based on over 350 cryogenic implosions to identify various degradation mechanisms, and combined with multidimensional simulations and experimental techniques such as target offsets to combat residual flows, core conditions have repeatably been achieved that extrapolate to the burning-plasma state when scaled to 2.15 MJ of symmetric laser illumination. Using high implosion velocities (⁠> 450 km/s) and moderately high adiabats (⁠~5⁠), these experiments produced record-high scaled Lawson parameters in direct drive equal to 89 ± 2% of that required for ignition with expected yields of up to 1.5 ± 0.2 MJ. To improve these results still further, focused physics studies are performed to improve physics understanding and identify routes to even greater performance. Recent studies include investigations into the impact of mounting features, laser imprint, reduced fuel temperatures, and greater on-target intensities through subscale experiments. This manuscript gives a summary of the cryogenic direct-drive program on the OMEGA laser, including routes taken to achieve the current best performance, the status of recent focused physics investigations, and future designs—such as target solutions to laser imprint and reducing vapor density to increase convergence—that are expected lead to the demonstration of hydro-equivalent ignition on OMEGA.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗