Engineering Papers⌕ Search

Engineering topics

Bertoni, Mariana

Publications and source records attributed to Bertoni, Mariana.

28 records · Page 2

On the recombination centers of iron-gallium pairs in Ga-doped silicon

Gallium (Ga) doped silicon (Si) is becoming a relevant player in solar cell manufacturing thanks to its demonstrated low light-induced degradation, yet little is known about Ga-related recombination centers. In this paper, we study iron (Fe)-related recombination centers in as-grown, high quality, directionally solidified, monocrystalline Ga-doped Si. While no defect states could be detected by deep level transient spectroscopy, lifetime spectroscopy analysis shows that the minority carrier lifetime in as-grown wafers is dominated by low levels of FeGa related defect complexes. FeGa pairs have earlier been shown to occur in two different structural configurations. Herein, we show that in terms of recombination strength, the orthorhombic pair-configuration is dominant over the trigonal pair-configuration for FeGa. Furthermore, the defect energy level in the band gap for the orthorhombic defect center is determined to be E V + 0.09 eV, and the capture cross-section ratio of the same defect center is determined to be 220.

14 SOLAR ENERGY↗

Low temperature spalling of silicon: A crack propagation study

Spalling is a promising kerfless method for cutting thin silicon wafers while doubling the yield of a silicon ingot. The main obstacle in this technology is the high total thickness variation of the spalled wafers, often as high as 100% of the wafer thickness. It has been suggested before that a strong correlation exists between low crack velocities and a smooth surface, but this correlation has never been shown during a spalling process in silicon. The reason lies in the challenge associated to measuring such velocities. In this contribution, we present a new approach to assess, in real time, the crack velocity as it propagates during a low temperature spalling process. Understanding the relationship between crack velocity and surface roughness during spalling can pave the way to attain full control on the surface quality of the spalled wafer.

14 SOLAR ENERGY↗

In-situ X-ray Nanocharacterization of Defect Kinetics in Chalcogenide Solar Cell Materials

For decades the optimization of polycrystalline absorbers has been done using an Edisonian approach, where trial and error and complex design of experiments in large parameter spaces have driven efficiencies to the record values we see today – CIGS at 22.5%, 22.1% for CdTe, 21.3% for high purity multi-crystalline silicon. Appropriate growth parameters are critical to ensure good quality crystals with low concentration of structural defects - low dislocation density and large grain sizes. However, to bridge the gap between the efficiencies today and the fundamental Shockley-Queisser limit for these materials a much more fundamental understanding of the role and interaction between composition, structure, defect density and electrical properties is required. In recent years multiple novel characterization techniques have shown the potential that nanoscale characterization can have in deciphering the composition of grain boundaries in materials like CIGS and CdTe. However, high resolution has come at the cost of small sampling areas and number of specimens, making it extremely difficult to draw conclusions based on the characteristic small sampling sizes. The missing links thus far have been: (1) the lack of statistical meaningfulness of the nanosclae studies and (2) the direct correlation of compositional variations to electrical performance with nanoscale resolution. In this work we present the use of synchrotron-based nano-X-ray fluorescence microscopy (nano-XRF), x-ray absorption nanospectroscopy (nano-XAS) coupled with nano-x-ray beam induced current (nano-XBIC) as ideal tools for investigating elemental, chemical and electrical properties of large areas of solar cell materials at the sub-micron scale with very high sensitivity. We show how the technique can provide statistical valuable information regarding the elemental segregation in CIGS and the direct correlation to current collection. For example, we demonstrate that Cu and Ga (and with that, CGI and GGI) correlate positively, and In negatively with charge collection efficiency for cells with low Ga content, both at grain boundaries and in grain cores. For cells with high Ga content, the charge collection efficiency depends to much lesser extent on the elemental distribution. The objective is three folded: (1) develop an x-ray in-situ microscopy capability to simulate growth and processing conditions, (2) apply it to elucidate performance-governing defect kinetics in chalcogenide solar cell materials, and (3) to study approaches to engineer materials from the nanoscale up. The development of these capabilities will enable experimental characterization to take place under actual processing and operating conditions and it will have impact well beyond the proposed research, enabling future studies on a large variety of materials system where electronic properties depend on underlying structural or chemical inhomogeneities.

14 SOLAR ENERGY↗

Thin Silicon Solar Cells: A Path to 35% Shockley-Queisser Limits

Crystalline silicon technology is expected to remain the leading photovoltaic industry workhorse for decades. We present here the objectives and workplan of a recently launched project funded by the U.S. Department of Energy through the Foundational Program to Advance Cell Efficiency II (FPACE II), which aims at leading crystalline silicon to an efficiency breakthrough. The project will tackle fundamental approach of materials design, defect engineering, device simulations and materials growth and characterization. Among the main novelties, the implementation of carrier selective contacts made of wide bandgap material or stack of materials is investigated for improved passivation, carrier extraction and carrier transport. Based on an initial selection of candidate materials, preliminary experiments are conducted to verify the suitability of their critical parameters as well as preservation of the silicon substrate surface and bulk properties. The target materials include III-V and metal-oxide materials.

Ding, Laura↗

Phonon-enhanced crystal growth and lattice healing

A system for modifying dislocation distributions in semiconductor materials is provided. The system includes one or more vibrational sources for producing at least one excitation of vibrational mode having phonon frequencies so as to enhance dislocation motion through a crystal lattice.

36 MATERIALS SCIENCE↗

Method to reduce dislocation density in silicon using stress

A crystalline material structure with reduced dislocation density and method of producing same is provided. The crystalline material structure is annealed at temperatures above the brittle-to-ductile transition temperature of the crystalline material structure. One or more stress elements are formed on the crystalline material structure so as to annihilate dislocations or to move them into less harmful locations.

36 MATERIALS SCIENCE↗