Engineering topics

Bennett, G.

Publications and source records attributed to Bennett, G..

5 records

DOE OSTI2024

Achievement of Target Gain Larger than Unity in an Inertial Fusion Experiment

On December 5, 2022, an indirect drive fusion implosion on the National Ignition Facility (NIF) achieved a target gain G target of 1.5. This is the first laboratory demonstration of exceeding “scientific breakeven” (or G target > 1 ) where 2.05 MJ of 351 nm laser light produced 3.1 MJ of total fusion yield, a result which significantly exceeds the Lawson criterion for fusion ignition as reported in a previous NIF implosion [H. Abu-Shawareb (Indirect Drive ICF Collaboration), ]. This achievement is the culmination of more than five decades of research and gives proof that laboratory fusion, based on fundamental physics principles, is possible. This Letter reports on the target, laser, design, and experimental advancements that led to this result. Published by the American Physical Society 2024

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

DOE OSTI2022

Lawson Criterion for Ignition Exceeded in an Inertial Fusion Experiment

For more than half a century, researchers around the world have been engaged in attempts to achieve fusion ignition as a proof of principle of various fusion concepts. Following the Lawson criterion, an ignited plasma is one where the fusion heating power is high enough to overcome all the physical processes that cool the fusion plasma, creating a positive thermodynamic feedback loop with rapidly increasing temperature. In inertially confined fusion, ignition is a state where the fusion plasma can begin “burn propagation” into surrounding cold fuel, enabling the possibility of high energy gain. While “scientific breakeven” (i.e., unity target gain) has not yet been achieved (here target gain is 0.72, 1.37 MJ of fusion for 1.92 MJ of laser energy), this work reports the first controlled fusion experiment, using laser indirect drive, on the National Ignition Facility to produce capsule gain (here 5.8) and reach ignition by nine different formulations of the Lawson criterion.

70 PLASMA PHYSICS AND FUSION TECHNOLOGY↗

NASA NTRS1983

Theoretical investigations of high lift aerodynamics

A program which generates a coordinate system for a two element airfoil with the mesh points concentrated in areas of significant vorticity, i.e., boundary layer and wake is operational. The 'imbedded' grid method developed allows a transition from the scale of the main airfoil to the scale of the flap. This requirement is essential for the modeling of viscous flows over the flap and slat of a multielement airfoil. An airfoil mounted in a 2-D wind tunnel was formulated. The program is ready for a fine grid and a large number of planes to explore the characteristics of a Navier-Stokes solver in a quasi-3D case. The program was converted to a form suitable for the STAR computer. Runs were made to map a three dimensional flow field for a wall airfoil intersection with and without lift.

Bennett, G.↗

NASA NTRS1981

Propeller propulsion integration, phase 1

A bibliography was compiled of all readily available sources of propeller analytical and experimental studies conducted during the 1930 through 1960 period. A propeller test stand was developed for the measurement of thrust and torque characteristics of full scale general aviation propellers and installed in the LaRC 30 x 60 foot full scale wind tunnel. A tunnel entry was made during the January through February 1980 period. Several propellers were tested, but unforseen difficulties with the shaft thrust torque balance severely degraded the data quality.

Bennett, G.↗

NASA NTRS1976

Flight test of a stall sensor and evaluation of its application to an aircraft stall deterrent system using the NASA LRC general aviation simulator

A series of flight maneuvers were developed to cover the range of flight conditions and to define the repeatability and hysteresis of the sensors. Initial flights were made with two sensors at the + or - 68 percent span and 60 percent and 70 percent chord stations. The primary effort in simulation program development was to modify the LRC General Aviation Simulator (GAS) Fortran programs to allow execution on the MSU UNIVAC 1106. A simple model of the sensor-servo stall deterrent system was developed. A one degree of freedom model of pitch dynamics of the airplane and stall deterrent system was developed to make initial estimates of the control system gains. A position error plus rate damping control algorithm was found to have acceptable characteristics.

Bennett, G.↗